What are Singleton Council's setbacks for a house, granny flat or duplex?
A setback is how far a home must sit from each boundary of its lot. In Singleton the setbacks for a house, a granny flat or a duplex come from Singleton Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.
It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.
NSW addresses only. Free, and no sign up.
What are Singleton Council's setbacks for a house?
Singleton Council's main plan, Singleton DCP 2014, ss 2.10 and 2.12 (R1 and R2), asks a single storey house for these setbacks: front 5.5m; side 0.9m; and rear 3m, plus 1m for every metre of wall above 5m.
House setbacks in Singleton gives the two storey figures, the clauses and every other plan that covers one.
What are Singleton Council's setbacks for a granny flat?
Singleton Council's main plan, Singleton DCP 2014, ss 2.10 and 2.12 (R1 and R2), asks a single storey granny flat for these setbacks: front 6m on lots up to 24.99m wide, 5.5m on wider lots; side 0.9m; and rear 3m, plus 1m for every metre of wall above 5m.
Granny flat setbacks in Singleton gives the two storey figures, the clauses and every other plan that covers one.
What are Singleton Council's setbacks for a duplex?
Singleton Council's main plan, Singleton DCP 2014, ss 2.10 and 2.12 (R1 and R2), asks a single storey duplex for these setbacks: front 6m on lots up to 24.99m wide, 5.5m on wider lots; side 0.9m; and rear 3m, plus 1m for every metre of wall above 5m.
Duplex setbacks in Singleton gives the two storey figures, the clauses and every other plan that covers one.
Which DCP covers my block in Singleton?
It depends on the lot: we hold 6 plans with setbacks for homes in Singleton Council, and Singleton DCP 2014, ss 2.10 and 2.12 (R1 and R2) is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.
| Plan | Where it applies | Homes it covers |
|---|---|---|
| Singleton DCP 2014, ss 2.10 and 2.12 (R1 and R2) | Main plan. Land in Zone R1 General Residential and Zone R2 Low Density Residential across the Singleton LGA (s 1.4: the DCP applies to the land on its Land Application Map, which shows the LGA as included land), outside the Huntlee New Town site. | house, granny flat, duplex |
| Singleton DCP 2014, ss 2.10 and 2.12 (RU5 Village) | Land in Zone RU5 Village. | house, duplex |
| Singleton DCP 2014, ss 2.10 and 2.12 (R5 Large Lot Residential) | Land in Zone R5 Large Lot Residential, including the R5 land at Huntlee (the Huntlee DCP covers only R1, R2 and B4 land). | house, granny flat, duplex |
| Singleton DCP 2014, ss 2.10 and 2.11 (RU1, RU2, RU4) | Land in Zone RU1 Primary Production, RU2 Rural Landscape and RU4 Primary Production Small Lots: 40 m building line (Table 2.10A) and 10 m side and rear (s 2.11). | house, duplex |
| Singleton DCP 2014, ss 2.10 and 2.11 (C4, formerly E4 Environmental Living) | Land in Zone C4 Environmental Living (the DCP's "E4 Environmental Living"; council's DCP page says an E4 reference is to be read as C4): 15 m building line (Table 2.10A) and 10 m side and rear (s 2.11). | house, duplex |
| Huntlee DCP 2013, Part 5 Residential Development | Land in Zone R1 General Residential and R2 Low Density Residential within the Huntlee New Town site in the Singleton LGA (south-west of Branxton, south of the Main Northern rail line). | house, granny flat, duplex |
Do Singleton Council's setbacks apply to complying development?
No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).
The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
What setbacks apply on a corner block in Singleton?
Singleton DCP 2014, ss 2.10 and 2.12 (R1 and R2) sets a separate setback for a house from the second street, the side street of a corner block: 5.5m (Singleton DCP 2014, s 2.10(1)(c), (3), (4), Table 2.10A, Note 1). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.
What else do people ask?
Can Singleton Council approve a smaller setback?
It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
Do Singleton setbacks apply to sheds, pools and fences?
Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were Singleton Council's setbacks checked?
We last read Singleton Council's plans on 11 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.