Skip to main content

How close to the boundary can a house be in Singleton?

Singleton Council's main plan, Singleton DCP 2014, ss 2.10 and 2.12 (R1 and R2), asks a single storey house for these setbacks: front 5.5m; side 0.9m; and rear 3m, plus 1m for every metre of wall above 5m.

In Singleton the setbacks for a house come from Singleton Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Singleton Council's main plan set for a house?

The table gives Singleton DCP 2014, ss 2.10 and 2.12 (R1 and R2)'s one and two storey figures and the clause each comes from. The plan covers this land: Land in Zone R1 General Residential and Zone R2 Low Density Residential across the Singleton LGA (s 1.4: the DCP applies to the land on its Land Application Map, which shows the LGA as included land), outside the Huntlee New Town site.

Singleton DCP 2014, ss 2.10 and 2.12 (R1 and R2): setbacks for a house
SetbackOne storeyTwo storeysWhere in the plan
Front5.5m5.5mSingleton DCP 2014, s 2.10(3), Table 2.10A
Side0.9m1.5m for walls over 5 m high facing the boundarySingleton DCP 2014, s 2.12(3)
Rear3m, plus 1m for every metre of wall above 5m3m, plus 1m for every metre of wall above 5mSingleton DCP 2014, s 2.12(4)
Corner block, second street5.5m5.5mSingleton DCP 2014, s 2.10(1)(c), (3), (4), Table 2.10A, Note 1

Which DCP applies to my block in Singleton?

It depends on where the lot is. Singleton DCP 2014, ss 2.10 and 2.12 (R1 and R2) is Singleton Council's main plan, and 5 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Singleton that cover a house
PlanWhere it appliesFrontSideRearSecond street
Singleton DCP 2014, ss 2.10 and 2.12 (RU5 Village)Land in Zone RU5 Village.6m0.9m3m, plus 1m for every metre of wall above 5m6m
Singleton DCP 2014, ss 2.10 and 2.12 (R5 Large Lot Residential)Land in Zone R5 Large Lot Residential, including the R5 land at Huntlee (the Huntlee DCP covers only R1, R2 and B4 land).15m5m10m15m
Singleton DCP 2014, ss 2.10 and 2.11 (RU1, RU2, RU4)Land in Zone RU1 Primary Production, RU2 Rural Landscape and RU4 Primary Production Small Lots: 40 m building line (Table 2.10A) and 10 m side and rear (s 2.11).40m10m10m40m
Singleton DCP 2014, ss 2.10 and 2.11 (C4, formerly E4 Environmental Living)Land in Zone C4 Environmental Living (the DCP's "E4 Environmental Living"; council's DCP page says an E4 reference is to be read as C4): 15 m building line (Table 2.10A) and 10 m side and rear (s 2.11).15m10m10m15m
Huntlee DCP 2013, Part 5 Residential DevelopmentLand in Zone R1 General Residential and R2 Low Density Residential within the Huntlee New Town site in the Singleton LGA (south-west of Branxton, south of the Main Northern rail line).3.5m on lots up to 250m², 4.5m on lots up to 800m², 8m on larger lots0m on lots up to 250m², 1m on lots up to 800m², 1.5m on larger lots to one side, 0m on lots up to 250m², 1m on lots up to 800m², 4.5m on larger lots to the other3m on lots up to 250m², 4m on lots up to 800m², 6m on larger lots1m on lots up to 250m², 1m on lots up to 800m², 3m on larger lots

What are the complying development setbacks for a house?

If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a house on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
1,000m² (20m wide, 50m deep)6.5m1.5m (2.1m at two storeys)5m (12m at two storeys)3m

What if my block is on a corner?

Singleton DCP 2014, ss 2.10 and 2.12 (R1 and R2) sets a separate setback for a house from the second street, the side street of a corner block: 5.5m (Singleton DCP 2014, s 2.10(1)(c), (3), (4), Table 2.10A, Note 1). The complying development figure for the second street is in the CDC table above.

Does a two storey house need bigger setbacks?

Yes, under Singleton DCP 2014, ss 2.10 and 2.12 (R1 and R2): the side setback goes from 0.9m to 1.5m for walls over 5 m high facing the boundary. The rear setback also grows as the wall gets taller. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Singleton Council approve a house closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Singleton?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Singleton Council's plans on 11 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block