Skip to main content

What are Canada Bay Council's setbacks for a house, granny flat or duplex?

A setback is how far a home must sit from each boundary of its lot. In Canada Bay the setbacks for a house, a granny flat or a duplex come from Canada Bay Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.

It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.

Check your address

NSW addresses only. Free, and no sign up.

What are Canada Bay Council's setbacks for a house?

Canada Bay Council's main plan, City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings), asks a single storey house for these setbacks: front at least 4.5m, or the street's established building line where that is further back; side 0.9m; and rear 6m.

House setbacks in Canada Bay gives the two storey figures, the clauses and every other plan that covers one.

What are Canada Bay Council's setbacks for a granny flat?

Canada Bay Council's main plan, City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings), asks a single storey granny flat for these setbacks: front at least 4.5m, or the street's established building line where that is further back; side 1.5m; and rear 3m.

Granny flat setbacks in Canada Bay gives the two storey figures, the clauses and every other plan that covers one.

What are Canada Bay Council's setbacks for a duplex?

Canada Bay Council's main plan, City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings), asks a single storey duplex for these setbacks: front at least 4.5m, or the street's established building line where that is further back; side 0.9m; and rear 6m.

Duplex setbacks in Canada Bay gives the two storey figures, the clauses and every other plan that covers one.

Which DCP covers my block in Canada Bay?

It depends on the lot: we hold 6 plans with setbacks for homes in Canada Bay Council, and City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings) is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.

Every plan in Canada Bay with setbacks for homes
PlanWhere it appliesHomes it covers
City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings)Main plan. Land zoned R1, R2 or R3 under Canada Bay LEP 2013 (the only LEP zoning the LGA).house, granny flat, duplex
City of Canada Bay DCP, Part C Heritage, C4 Development in Heritage Conservation Areas (with Part E)R2 and R3 land inside a heritage conservation area listed in Schedule 5 of Canada Bay LEP 2013 and mapped on its Heritage Map (26 areas, 103 ha; the largest are Bourketown and the Yaralla Estate).house, granny flat, duplex
City of Canada Bay DCP, Part K, K4.14 Breakfast Point, Provisions for single dwellingsThe Breakfast Point single dwelling lots shown in Part K Figure K4-14 ("Additional provisions for single dwellings location map"): the single dwelling lots of the Breakfast Point estate shaded in the figure, 120 lots, about 5.7 ha. K4.14: "The following additional provisions for single dwellings apply to the area identified in Figure K4-14".house
City of Canada Bay DCP, Part K, K13 Mortlake PointMortlake Point (Part K Figure K13-3 "Mortlake Point: Location Plan"): the R1 General Residential land on the Mortlake peninsula around Tennyson Road, Edwin Street, Northcote Street, McDonald Street and Bertram Street, about 22 ha. It is the only R1 land in the LGA, and its outline matches the figure.house, granny flat, duplex
City of Canada Bay DCP, Part K, K12 Liberty Grove (with Part E)Liberty Grove, the community title estate between Homebush Bay Drive and the railway north of Concord Avenue, Concord West (Part K Figure K12-3 "Liberty Grove: Location Plan", the land "shown edged orange"), R3 land, except the 27 lots on the gross site boundary, which have their own plan.house, granny flat, duplex
City of Canada Bay DCP, Part K, K12 Liberty Grove, lots on the gross site boundary (with Part E)The 27 Liberty Grove lots of DP270137 that touch the gross site boundary of Figure K12-3, where K12 C5 sets a 10 m building line.house, granny flat, duplex

Do Canada Bay Council's setbacks apply to complying development?

No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).

The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

What setbacks apply on a corner block in Canada Bay?

City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings) sets a separate setback for a house from the second street, the side street of a corner block: 0.9m for one storey, 1.5m for the second storey (CCBDCP Part E, E4.2, C6 (table, Dwelling houses row) and Note 2; C7 (the secondary street setback is a side setback)). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.

What else do people ask?

Can Canada Bay Council approve a smaller setback?

It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

Do Canada Bay setbacks apply to sheds, pools and fences?

Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were Canada Bay Council's setbacks checked?

We last read Canada Bay Council's plans on 12 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block