Skip to main content

How close to the boundary can a granny flat be in Canada Bay?

Canada Bay Council's main plan, City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings), asks a single storey granny flat for these setbacks: front at least 4.5m, or the street's established building line where that is further back; side 1.5m; and rear 3m.

In Canada Bay the setbacks for a granny flat come from Canada Bay Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the granny flat first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Canada Bay Council's main plan set for a granny flat?

The table gives City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings)'s one and two storey figures and the clause each comes from. The plan covers this land: Land zoned R1, R2 or R3 under Canada Bay LEP 2013 (the only LEP zoning the LGA).

City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings): setbacks for a granny flat
SetbackOne storeyTwo storeysWhere in the plan
Frontat least 4.5m, or the street's established building line where that is further backat least 4.5m, or the street's established building line where that is further backCCBDCP Part E, E4.2 Building setbacks, Front setbacks: primary street, C1 and C3
Side1.5m1.5mCCBDCP Part E, E4.2, Side setbacks: single frontage or parallel road lot, C6 (table, Secondary dwellings row)
Rear3m3mCCBDCP Part E, E4.2, Rear setbacks: single street frontage, C11
Corner block, second streetat least 1.5m, or the street's established building line where that is further backat least 1.5m, or the street's established building line where that is further backCCBDCP Part E, E4.2, Front setbacks: corner lot, C5; C6 (table, Secondary dwellings row)

Which DCP applies to my block in Canada Bay?

It depends on where the lot is. City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings) is Canada Bay Council's main plan, and 4 other plans cover a granny flat on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Canada Bay that cover a granny flat
PlanWhere it appliesFrontSideRearSecond street
City of Canada Bay DCP, Part C Heritage, C4 Development in Heritage Conservation Areas (with Part E)R2 and R3 land inside a heritage conservation area listed in Schedule 5 of Canada Bay LEP 2013 and mapped on its Heritage Map (26 areas, 103 ha; the largest are Bourketown and the Yaralla Estate).at least 4.5m, or the street's established building line where that is further back1.5m3mat least 1.5m, or the street's established building line where that is further back
City of Canada Bay DCP, Part K, K13 Mortlake PointMortlake Point (Part K Figure K13-3 "Mortlake Point: Location Plan"): the R1 General Residential land on the Mortlake peninsula around Tennyson Road, Edwin Street, Northcote Street, McDonald Street and Bertram Street, about 22 ha. It is the only R1 land in the LGA, and its outline matches the figure.7.5m3m3m3m
City of Canada Bay DCP, Part K, K12 Liberty Grove (with Part E)Liberty Grove, the community title estate between Homebush Bay Drive and the railway north of Concord Avenue, Concord West (Part K Figure K12-3 "Liberty Grove: Location Plan", the land "shown edged orange"), R3 land, except the 27 lots on the gross site boundary, which have their own plan.4m1.5m3m4m
City of Canada Bay DCP, Part K, K12 Liberty Grove, lots on the gross site boundary (with Part E)The 27 Liberty Grove lots of DP270137 that touch the gross site boundary of Figure K12-3, where K12 C5 sets a 10 m building line.4m1.5m10m (the boundary of the Liberty Grove gross site)4m

What are the complying development setbacks for a granny flat?

If you build a granny flat with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a granny flat on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m2m
1,000m² (20m wide, 50m deep)6.5m1.5m5m3m

What if my block is on a corner?

City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings) sets a separate setback for a granny flat from the second street, the side street of a corner block: at least 1.5m, or the street's established building line where that is further back (CCBDCP Part E, E4.2, Front setbacks: corner lot, C5; C6 (table, Secondary dwellings row)). It measures the front setback from the street the home is addressed to. The complying development figure for the second street is in the CDC table above.

Does a two storey granny flat need bigger setbacks?

No. City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings) sets the same figures for a one or two storey granny flat. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Canada Bay Council approve a granny flat closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Canada Bay?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Canada Bay Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block