How close to the boundary can a duplex be in Canada Bay?
Canada Bay Council's main plan, City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings), asks a single storey duplex for these setbacks: front at least 4.5m, or the street's established building line where that is further back; side 0.9m; and rear 6m.
In Canada Bay the setbacks for a duplex come from Canada Bay Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the duplex first.
NSW addresses only. Free, and no sign up.
What setbacks does Canada Bay Council's main plan set for a duplex?
The table gives City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings)'s one and two storey figures and the clause each comes from. The plan covers this land: Land zoned R1, R2 or R3 under Canada Bay LEP 2013 (the only LEP zoning the LGA).
| Setback | One storey | Two storeys | Where in the plan |
|---|---|---|---|
| Front | at least 4.5m, or the street's established building line where that is further back | at least 4.5m, or the street's established building line where that is further back | CCBDCP Part E, E4.2 Building setbacks, Front setbacks: primary street, C1 |
| Side | 0.9m | 1.5m for the second storey | CCBDCP Part E, E4.2, Side setbacks: single frontage or parallel road lot, C6 (table, Dual occupancies row) |
| Rear | 6m | 9m for any living room located on an upper floor (the rest of the building 6.0 m) | CCBDCP Part E, E4.2, Rear setbacks: single street frontage, C9 and C10 |
| Corner block, second street | 2m for the first 25m from the front, then the average of the neighbouring homes (where two dwellings are proposed one behind the other) | 2m for the first 25m from the front, then the average of the neighbouring homes (where two dwellings are proposed one behind the other) | CCBDCP Part E, E4.2, Side setbacks: corner lot, C7 and C8 |
Which DCP applies to my block in Canada Bay?
It depends on where the lot is. City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings) is Canada Bay Council's main plan, and 4 other plans cover a duplex on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| City of Canada Bay DCP, Part C Heritage, C4 Development in Heritage Conservation Areas (with Part E) | R2 and R3 land inside a heritage conservation area listed in Schedule 5 of Canada Bay LEP 2013 and mapped on its Heritage Map (26 areas, 103 ha; the largest are Bourketown and the Yaralla Estate). | at least 4.5m, or the street's established building line where that is further back | 0.9m | 6m | 2m for the first 25m from the front, then the average of the neighbouring homes (where two dwellings are proposed one behind the other) |
| City of Canada Bay DCP, Part K, K13 Mortlake Point | Mortlake Point (Part K Figure K13-3 "Mortlake Point: Location Plan"): the R1 General Residential land on the Mortlake peninsula around Tennyson Road, Edwin Street, Northcote Street, McDonald Street and Bertram Street, about 22 ha. It is the only R1 land in the LGA, and its outline matches the figure. | 7.5m | 3m | 3m | 3m |
| City of Canada Bay DCP, Part K, K12 Liberty Grove (with Part E) | Liberty Grove, the community title estate between Homebush Bay Drive and the railway north of Concord Avenue, Concord West (Part K Figure K12-3 "Liberty Grove: Location Plan", the land "shown edged orange"), R3 land, except the 27 lots on the gross site boundary, which have their own plan. | 4m | 0.9m | 6m | 4m |
| City of Canada Bay DCP, Part K, K12 Liberty Grove, lots on the gross site boundary (with Part E) | The 27 Liberty Grove lots of DP270137 that touch the gross site boundary of Figure K12-3, where K12 C5 sets a 10 m building line. | 4m | 0.9m | 10m (the boundary of the Liberty Grove gross site) | 4m |
What are the complying development setbacks for a duplex?
If you build a duplex with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.
| Example lot | Front | Side | Rear | Corner block, second street |
|---|---|---|---|---|
| 450m² (15m wide, 30m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 600m² (15m wide, 40m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 1,000m² (20m wide, 50m deep) | 6.5m | 0.9m (1.5m at two storeys) | 5m (12m at two storeys) | 3m |
What if my block is on a corner?
City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings) sets a separate setback for a duplex from the second street, the side street of a corner block: 2m for the first 25m from the front, then the average of the neighbouring homes (where two dwellings are proposed one behind the other) (CCBDCP Part E, E4.2, Side setbacks: corner lot, C7 and C8). Where the duplex faces that street, it asks for the average of the neighbouring homes. It measures the front setback from the street the home is addressed to. The complying development figure for the second street is in the CDC table above.
Does a two storey duplex need bigger setbacks?
Yes, under City of Canada Bay DCP, Part E (Single Dwellings, Semi-Detached Dwellings, Dual Occupancies and Secondary Dwellings): the side setback goes from 0.9m to 1.5m for the second storey; the rear setback goes from 6m to 9m for any living room located on an upper floor (the rest of the building 6.0 m). Under complying development, the two storey figures are in the CDC table above.
What else do people ask?
Can Canada Bay Council approve a duplex closer to the boundary?
It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.
Do these setbacks apply to a shed, pool or fence in Canada Bay?
No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were the setbacks on this page checked?
We last read Canada Bay Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.