What are Port Stephens Council's setbacks for a house, granny flat or duplex?
A setback is how far a home must sit from each boundary of its lot. In Port Stephens the setbacks for a house, a granny flat or a duplex come from Port Stephens Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.
It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.
NSW addresses only. Free, and no sign up.
What are Port Stephens Council's setbacks for a house?
Port Stephens Council's main plan, Port Stephens DCP 2025, Chapter C4 Residential Development, asks a single storey house for these setbacks: front the average of the neighbouring homes (4.5m where there are none) on lots up to 1,000m²; the average of the neighbouring homes (10m where there are none) on larger lots; side 0.9m on lots up to 1,000m²; 5m on larger lots; and rear 2m on lots up to 1,000m²; 5m on larger lots.
House setbacks in Port Stephens gives the two storey figures, the clauses and every other plan that covers one.
What are Port Stephens Council's setbacks for a granny flat?
Port Stephens Council's main plan, Port Stephens DCP 2025, Chapter C4 Residential Development, asks a single storey granny flat for these setbacks: front the average of the neighbouring homes (4.5m where there are none) on lots up to 1,000m²; the average of the neighbouring homes (10m where there are none) on larger lots; side 0.9m on lots up to 1,000m²; 5m on larger lots; and rear 0.9m on lots up to 1,000m²; 5m on larger lots.
Granny flat setbacks in Port Stephens gives the two storey figures, the clauses and every other plan that covers one.
What are Port Stephens Council's setbacks for a duplex?
Port Stephens Council's main plan, Port Stephens DCP 2025, Chapter C4 Residential Development, asks a single storey duplex for these setbacks: front the average of the neighbouring homes (4.5m where there are none) on lots up to 1,000m²; the average of the neighbouring homes (10m where there are none) on larger lots; side 0.9m on lots up to 1,000m²; 5m on larger lots; and rear 2m on lots up to 1,000m²; 5m on larger lots.
Duplex setbacks in Port Stephens gives the two storey figures, the clauses and every other plan that covers one.
Which DCP covers my block in Port Stephens?
It depends on the lot: we hold 5 plans with setbacks for homes in Port Stephens Council, and Port Stephens DCP 2025, Chapter C4 Residential Development is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.
| Plan | Where it applies | Homes it covers |
|---|---|---|
| Port Stephens DCP 2025, Chapter C4 Residential Development | Main plan. All of the Port Stephens LGA (s A5) outside the R5, RU1 and RU2 zones and the two traced areas below. | house, granny flat, duplex |
| Port Stephens DCP 2025, Chapter C4 Residential Development (RU5, C2 and C4) | Land zoned RU5 Village, C2 Environmental Conservation or C4 Environmental Living. | house, duplex |
| Port Stephens DCP 2025, Chapter C4.B Housing on large lots (R5, RU1, RU2) | Land zoned R5 Large Lot Residential, RU1 Primary Production or RU2 Rural Landscape under PSLEP 2013, whatever the lot size (C4.B application note). | house, granny flat, duplex |
| Port Stephens DCP 2025, Chapter C4.A (Koala Bay: Tanilba Bay area) | The Koala Bay estate, Tanilba Bay, shown in PSDCP 2025 Figure 36 (Diggers Drive, Pershing Place, Brittania Drive, north of Lemon Tree Passage Road). | house, granny flat, duplex |
| Port Stephens DCP 2025, Chapter D10 Stockton Rifle Range | The former Stockton Rifle Range at Fern Bay, "the land identified in Figure 64 as Stockton Rifle Range" (D10 Application): Lot 5 DP233358, east of Popplewell Road. | house, granny flat, duplex |
Do Port Stephens Council's setbacks apply to complying development?
No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).
The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
What setbacks apply on a corner block in Port Stephens?
Port Stephens DCP 2025, Chapter C4 Residential Development sets a separate setback for a house from the second street, the side street of a corner block: 3m on lots up to 1,000m²; 10m on larger lots (PSDCP 2025, Ch C4.A2 Building setbacks, C4.4; PSDCP 2025, Ch C4.B (application note) and C4.B1 Building setbacks, C4.36). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.
What else do people ask?
Can Port Stephens Council approve a smaller setback?
It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
Do Port Stephens setbacks apply to sheds, pools and fences?
Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were Port Stephens Council's setbacks checked?
We last read Port Stephens Council's plans on 11 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.