How close to the boundary can a house be in Port Stephens?
Port Stephens Council's main plan, Port Stephens DCP 2025, Chapter C4 Residential Development, asks a single storey house for these setbacks: front the average of the neighbouring homes (4.5m where there are none) on lots up to 1,000m²; the average of the neighbouring homes (10m where there are none) on larger lots; side 0.9m on lots up to 1,000m²; 5m on larger lots; and rear 2m on lots up to 1,000m²; 5m on larger lots.
In Port Stephens the setbacks for a house come from Port Stephens Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.
NSW addresses only. Free, and no sign up.
What setbacks does Port Stephens Council's main plan set for a house?
The table gives Port Stephens DCP 2025, Chapter C4 Residential Development's one and two storey figures and the clause each comes from. The plan covers this land: All of the Port Stephens LGA (s A5) outside the R5, RU1 and RU2 zones and the two traced areas below.
| Setback | One storey | Two storeys | Where in the plan |
|---|---|---|---|
| Front | the average of the neighbouring homes (4.5m where there are none) on lots up to 1,000m²; the average of the neighbouring homes (10m where there are none) on larger lots | the average of the neighbouring homes (4.5m where there are none) on lots up to 1,000m²; the average of the neighbouring homes (10m where there are none) on larger lots | PSDCP 2025, Ch C4.A2 Building setbacks, C4.2; PSDCP 2025, Ch C4.B (application note) and C4.B1 Building setbacks, C4.34 |
| Side | 0.9m on lots up to 1,000m²; 5m on larger lots | 1.5m on lots up to 1,000m²; 5m on larger lots | PSDCP 2025, Ch C4.A2 Building setbacks, C4.3; PSDCP 2025, Ch C4.B (application note) and C4.B1 Building setbacks, C4.35 |
| Rear | 2m on lots up to 1,000m²; 5m on larger lots | 4m on lots up to 1,000m²; 5m on larger lots | PSDCP 2025, Ch C4.A2 Building setbacks, C4.5; PSDCP 2025, Ch C4.B (application note) and C4.B1 Building setbacks, C4.36 |
| Corner block, second street | 3m on lots up to 1,000m²; 10m on larger lots | 3m on lots up to 1,000m²; 10m on larger lots | PSDCP 2025, Ch C4.A2 Building setbacks, C4.4; PSDCP 2025, Ch C4.B (application note) and C4.B1 Building setbacks, C4.36 |
Which DCP applies to my block in Port Stephens?
It depends on where the lot is. Port Stephens DCP 2025, Chapter C4 Residential Development is Port Stephens Council's main plan, and 4 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Port Stephens DCP 2025, Chapter C4 Residential Development (RU5, C2 and C4) | Land zoned RU5 Village, C2 Environmental Conservation or C4 Environmental Living. | the average of the neighbouring homes (4.5m where there are none) on lots up to 1,000m²; the average of the neighbouring homes (10m where there are none) on larger lots | 0.9m on lots up to 1,000m²; 5m on larger lots | 2m on lots up to 1,000m²; 5m on larger lots | 3m on lots up to 1,000m²; 10m on larger lots |
| Port Stephens DCP 2025, Chapter C4.B Housing on large lots (R5, RU1, RU2) | Land zoned R5 Large Lot Residential, RU1 Primary Production or RU2 Rural Landscape under PSLEP 2013, whatever the lot size (C4.B application note). | the average of the neighbouring homes (10m where there are none) | 5m | 5m | 10m |
| Port Stephens DCP 2025, Chapter C4.A (Koala Bay: Tanilba Bay area) | The Koala Bay estate, Tanilba Bay, shown in PSDCP 2025 Figure 36 (Diggers Drive, Pershing Place, Brittania Drive, north of Lemon Tree Passage Road). | 6m on lots up to 1,000m²; the average of the neighbouring homes (10m where there are none) on larger lots | 0.9m on lots up to 1,000m²; 5m on larger lots | 2m on lots up to 1,000m²; 5m on larger lots | 3m on lots up to 1,000m²; 10m on larger lots |
| Port Stephens DCP 2025, Chapter D10 Stockton Rifle Range | The former Stockton Rifle Range at Fern Bay, "the land identified in Figure 64 as Stockton Rifle Range" (D10 Application): Lot 5 DP233358, east of Popplewell Road. | 2m on lots up to 299.99m²; the average of the neighbouring homes (4.5m where there are none) on lots up to 1,000m²; the average of the neighbouring homes (10m where there are none) on larger lots | 0.9m on lots up to 299.99m²; 0.9m on lots up to 1,000m²; 5m on larger lots | 4m on lots up to 299.99m²; 2m on lots up to 1,000m²; 5m on larger lots | 2m on lots up to 299.99m²; 3m on lots up to 1,000m²; 10m on larger lots |
What are the complying development setbacks for a house?
If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.
| Example lot | Front | Side | Rear | Corner block, second street |
|---|---|---|---|---|
| 450m² (15m wide, 30m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 600m² (15m wide, 40m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 1,000m² (20m wide, 50m deep) | 6.5m | 1.5m (2.1m at two storeys) | 5m (12m at two storeys) | 3m |
What if my block is on a corner?
Port Stephens DCP 2025, Chapter C4 Residential Development sets a separate setback for a house from the second street, the side street of a corner block: 3m on lots up to 1,000m²; 10m on larger lots (PSDCP 2025, Ch C4.A2 Building setbacks, C4.4; PSDCP 2025, Ch C4.B (application note) and C4.B1 Building setbacks, C4.36). The complying development figure for the second street is in the CDC table above.
Does a two storey house need bigger setbacks?
Yes, under Port Stephens DCP 2025, Chapter C4 Residential Development: the side setback goes from 0.9m on lots up to 1,000m²; 5m on larger lots to 1.5m on lots up to 1,000m²; 5m on larger lots; the rear setback goes from 2m on lots up to 1,000m²; 5m on larger lots to 4m on lots up to 1,000m²; 5m on larger lots. Under complying development, the two storey figures are in the CDC table above.
What else do people ask?
Can Port Stephens Council approve a house closer to the boundary?
It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.
Do these setbacks apply to a shed, pool or fence in Port Stephens?
No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were the setbacks on this page checked?
We last read Port Stephens Council's plans on 11 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.