What are Mosman Council's setbacks for a house, granny flat or duplex?
A setback is how far a home must sit from each boundary of its lot. In Mosman the setbacks for a house, a granny flat or a duplex come from Mosman Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.
It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.
NSW addresses only. Free, and no sign up.
What are Mosman Council's setbacks for a house?
Mosman Council's main plan, Mosman Residential DCP 2012, Part 4.2 Siting and scale (R2 and R3), asks a single storey house for these setbacks: front the average of the neighbouring homes, side 0.9m and rear the average of the neighbouring homes.
House setbacks in Mosman gives the two storey figures, the clauses and every other plan that covers one.
What are Mosman Council's setbacks for a granny flat?
Mosman Council's main plan, Mosman Residential DCP 2012, Part 4.2 Siting and scale (R2 and R3), asks a single storey granny flat for these setbacks: front the average of the neighbouring homes, side 0.9m and rear the average of the neighbouring homes.
Granny flat setbacks in Mosman gives the two storey figures, the clauses and every other plan that covers one.
What are Mosman Council's setbacks for a duplex?
Mosman Council's main plan, Mosman Residential DCP 2012, Part 4.2 Siting and scale (R2 and R3), asks a single storey duplex for these setbacks: front the average of the neighbouring homes, side 0.9m and rear the average of the neighbouring homes.
Duplex setbacks in Mosman gives the two storey figures, the clauses and every other plan that covers one.
Which DCP covers my block in Mosman?
It depends on the lot: we hold 7 plans with setbacks for homes in Mosman Council, and Mosman Residential DCP 2012, Part 4.2 Siting and scale (R2 and R3) is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.
| Plan | Where it applies | Homes it covers |
|---|---|---|
| Mosman Residential DCP 2012, Part 4.2 Siting and scale (R2 and R3) | Main plan. Land zoned R2 Low Density Residential or R3 Medium Density Residential in Mosman, outside the Rosherville/Wy-ar-gine Townscape and Markham Close. | house, granny flat, duplex |
| Mosman Residential DCP 2012, Part 4.2 Siting and scale (C4) | Land zoned C4 Environmental Living in Mosman (mostly harbour foreshore slopes), outside the Rosherville/Wy-ar-gine Townscape and 2 Illawarra Street. | house, granny flat |
| Mosman Residential DCP 2012, Part 4.2 P17 and Part 7 Rosherville/Wy-ar-gine Townscape (R2 and R3) | R2 and R3 land in the Rosherville/Wy-ar-gine Townscape (Parriwi Road, Cyprian Street, Rosherville and Hopetoun Avenues, Fairfax, Warringah and Kirkoswald, Burran Avenue to Wyargine Point), as mapped in Part 7, where P17 sets larger side setbacks. | house, granny flat, duplex |
| Mosman Residential DCP 2012, Part 4.2 P17 and Part 7 Rosherville/Wy-ar-gine Townscape (C4) | C4 Environmental Living land in the Rosherville/Wy-ar-gine Townscape. | house, granny flat |
| Sydney Harbour Federation Trust Management Plan: Mosman No. 3 (Markham Close) | The Markham Close houses at Georges Heights: Nos 1 to 15 Markham Close and 1093B to 1099 Middle Head Road (the plan's Lots 1 to 19 DP233157 and part Lot 202 DP1022020). | house, granny flat, duplex |
| Mosman Residential DCP 2012, Part 6.11 2 Illawarra Street, Mosman | 2 Illawarra Street, Mosman (Lot B DP411026), a heritage item on Little Sirius Cove. | house, granny flat |
| Mosman Business Centres DCP 2012, Part 5 Urban Design and Planning Controls (E1 Local Centre) | Land zoned E1 Local Centre in Mosman: Spit, Mosman and Cremorne Junctions, Parriwi Junction, Avenue Road, Mosman Bay Wharf, Spofforth Street and The Esplanade, Balmoral (Part 1.3). | house |
Do Mosman Council's setbacks apply to complying development?
No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).
The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
What setbacks apply on a corner block in Mosman?
Mosman Residential DCP 2012, Part 4.2 Siting and scale (R2 and R3) sets no separate setback for the second street of a corner block for a house, so ask the council how it treats one. Under complying development the code sets one by lot size.
What else do people ask?
Can Mosman Council approve a smaller setback?
It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
Do Mosman setbacks apply to sheds, pools and fences?
Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were Mosman Council's setbacks checked?
We last read Mosman Council's plans on 12 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.