Skip to main content

How close to the boundary can a duplex be in Mosman?

Mosman Council's main plan, Mosman Residential DCP 2012, Part 4.2 Siting and scale (R2 and R3), asks a single storey duplex for these setbacks: front the average of the neighbouring homes, side 0.9m and rear the average of the neighbouring homes.

In Mosman the setbacks for a duplex come from Mosman Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the duplex first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Mosman Council's main plan set for a duplex?

The table gives Mosman Residential DCP 2012, Part 4.2 Siting and scale (R2 and R3)'s one and two storey figures and the clause each comes from. The plan covers this land: Land zoned R2 Low Density Residential or R3 Medium Density Residential in Mosman, outside the Rosherville/Wy-ar-gine Townscape and Markham Close.

Mosman Residential DCP 2012, Part 4.2 Siting and scale (R2 and R3): setbacks for a duplex
SetbackOne storeyTwo storeysWhere in the plan
Frontthe average of the neighbouring homesthe average of the neighbouring homesMosman Residential DCP 2012, Part 4.2 Siting and scale, Building setback, P3 and P4
Side0.9m1.5mMosman Residential DCP 2012, Part 4.2 Siting and scale, Building setback, P8 and P10
Rearthe average of the neighbouring homesthe average of the neighbouring homesMosman Residential DCP 2012, Part 4.2 Siting and scale, Building setback, P19 and P20

Which DCP applies to my block in Mosman?

It depends on where the lot is. Mosman Residential DCP 2012, Part 4.2 Siting and scale (R2 and R3) is Mosman Council's main plan, and 2 other plans cover a duplex on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Mosman that cover a duplex
PlanWhere it appliesFrontSideRearSecond street
Mosman Residential DCP 2012, Part 4.2 P17 and Part 7 Rosherville/Wy-ar-gine Townscape (R2 and R3)R2 and R3 land in the Rosherville/Wy-ar-gine Townscape (Parriwi Road, Cyprian Street, Rosherville and Hopetoun Avenues, Fairfax, Warringah and Kirkoswald, Burran Avenue to Wyargine Point), as mapped in Part 7, where P17 sets larger side setbacks.the average of the neighbouring homes1.5m to one side, 0.9m to the otherthe average of the neighbouring homesnot set
Sydney Harbour Federation Trust Management Plan: Mosman No. 3 (Markham Close)The Markham Close houses at Georges Heights: Nos 1 to 15 Markham Close and 1093B to 1099 Middle Head Road (the plan's Lots 1 to 19 DP233157 and part Lot 202 DP1022020).not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set

What are the complying development setbacks for a duplex?

If you build a duplex with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a duplex on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
1,000m² (20m wide, 50m deep)6.5m0.9m (1.5m at two storeys)5m (12m at two storeys)3m

What if my block is on a corner?

Mosman Residential DCP 2012, Part 4.2 Siting and scale (R2 and R3) sets no separate setback for the second street of a corner block for a duplex, so ask the council how it treats one. The complying development figure for the second street is in the CDC table above.

Does a two storey duplex need bigger setbacks?

Yes, under Mosman Residential DCP 2012, Part 4.2 Siting and scale (R2 and R3): the side setback goes from 0.9m to 1.5m. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Mosman Council approve a duplex closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Mosman?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Mosman Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block