Skip to main content

What are Lismore Council's setbacks for a house, granny flat or duplex?

A setback is how far a home must sit from each boundary of its lot. In Lismore the setbacks for a house, a granny flat or a duplex come from Lismore Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.

It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.

Check your address

NSW addresses only. Free, and no sign up.

What are Lismore Council's setbacks for a house?

Lismore Council's main plan, Lismore DCP, Part A Chapter 1 Residential Development (R1, R3 and RU5), asks a single storey house for these setbacks: front 6m; and side 0.9m on lots up to 399.99m², no figure on larger lots. It does not set a rear setback: ask the council.

House setbacks in Lismore gives the two storey figures, the clauses and every other plan that covers one.

What are Lismore Council's setbacks for a granny flat?

Lismore Council's main plan, Lismore DCP, Part A Chapter 1 Residential Development (R1, R3 and RU5), asks a single storey granny flat for these setbacks: front 6m. It does not set a side or rear setback: ask the council.

Granny flat setbacks in Lismore gives the two storey figures, the clauses and every other plan that covers one.

What are Lismore Council's setbacks for a duplex?

Lismore Council's main plan, Lismore DCP, Part A Chapter 1 Residential Development (R1, R3 and RU5), asks a single storey duplex for these setbacks: front 6m. It does not set a side or rear setback: ask the council.

Duplex setbacks in Lismore gives the two storey figures, the clauses and every other plan that covers one.

Which DCP covers my block in Lismore?

It depends on the lot: we hold 7 plans with setbacks for homes in Lismore Council, and Lismore DCP, Part A Chapter 1 Residential Development (R1, R3 and RU5) is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.

Every plan in Lismore with setbacks for homes
PlanWhere it appliesHomes it covers
Lismore DCP, Part A Chapter 1 Residential Development (R1, R3 and RU5)Main plan. R1 General Residential, R3 Medium Density Residential and RU5 Village land in Lismore City where LEP 2012 applies (the city and Goonellabah, and the villages of Nimbin, Dunoon, Clunes, Bexhill, Caniaba and others), outside the North Lismore Plateau.house, granny flat, duplex
Lismore DCP, Part A Chapter 1 Residential Development (R2)R2 Low Density Residential land in Lismore City (about 100 ha, around North Lismore, the CBD fringe and Girards Hill).house, granny flat, duplex
Lismore DCP, Part A Chapter 1 Residential Development (RU1 Primary Production)RU1 Primary Production land in Lismore City.house, duplex
Lismore DCP, Part A Chapter 1 Residential Development (R5 Large Lot Residential)R5 Large Lot Residential land in Lismore City.house, granny flat, duplex
Lismore DCP, Part A Chapter 1 Residential Development (C3 Environmental Management)C3 Environmental Management land in Lismore City.house
Lismore DCP, Part B Chapter 10 North Lismore Plateau Urban Release AreaR1 General Residential land in the North Lismore Plateau urban release area, between Nimbin Road and Dunoon Road north of North Lismore (Figure 1 Location Plan).house, granny flat, duplex
Lismore DCP (land to which LEP 2000 applies), Part A Chapter 1 Residential DevelopmentLand shown as "Deferred matter" on the Lismore LEP 2012 Land Application Map, where Lismore LEP 2000 still applies (LEP 2012 cl 1.3(1A)).house, duplex

Do Lismore Council's setbacks apply to complying development?

No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).

The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

What setbacks apply on a corner block in Lismore?

Lismore DCP, Part A Chapter 1 Residential Development (R1, R3 and RU5) sets a separate setback for a house from the second street, the side street of a corner block: 3m (Lismore DCP Part A, Chapter 1, s 4.1 Setbacks, A1.2). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.

What else do people ask?

Can Lismore Council approve a smaller setback?

It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

Do Lismore setbacks apply to sheds, pools and fences?

Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were Lismore Council's setbacks checked?

We last read Lismore Council's plans on 12 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block