How close to the boundary can a house be in Lismore?
Lismore Council's main plan, Lismore DCP, Part A Chapter 1 Residential Development (R1, R3 and RU5), asks a single storey house for these setbacks: front 6m; and side 0.9m on lots up to 399.99m², no figure on larger lots. It does not set a rear setback: ask the council.
In Lismore the setbacks for a house come from Lismore Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.
NSW addresses only. Free, and no sign up.
What setbacks does Lismore Council's main plan set for a house?
The table gives Lismore DCP, Part A Chapter 1 Residential Development (R1, R3 and RU5)'s one and two storey figures and the clause each comes from. The plan covers this land: R1 General Residential, R3 Medium Density Residential and RU5 Village land in Lismore City where LEP 2012 applies (the city and Goonellabah, and the villages of Nimbin, Dunoon, Clunes, Bexhill, Caniaba and others), outside the North Lismore Plateau.
| Setback | One storey | Two storeys | Where in the plan |
|---|---|---|---|
| Front | 6m | 6m | Lismore DCP Part A, Chapter 1, s 4.1 Setbacks, A1.1 |
| Side | 0.9m on lots up to 399.99m², no figure on larger lots | 0.9m on lots up to 399.99m², no figure on larger lots | Lismore DCP Part A, Chapter 1, s 6 Small Lot Housing, A26.3, with the s 2 definition of small lot |
| Rear | not set by the DCP: ask the council | not set by the DCP: ask the council | None |
| Corner block, second street | 3m | 3m | Lismore DCP Part A, Chapter 1, s 4.1 Setbacks, A1.2 |
Which DCP applies to my block in Lismore?
It depends on where the lot is. Lismore DCP, Part A Chapter 1 Residential Development (R1, R3 and RU5) is Lismore Council's main plan, and 6 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Lismore DCP, Part A Chapter 1 Residential Development (R2) | R2 Low Density Residential land in Lismore City (about 100 ha, around North Lismore, the CBD fringe and Girards Hill). | 6m | 0.9m on lots up to 399.99m², no figure on larger lots | not set by the DCP: ask the council | 3m |
| Lismore DCP, Part A Chapter 1 Residential Development (RU1 Primary Production) | RU1 Primary Production land in Lismore City. | 15m | not set by the DCP: ask the council | not set by the DCP: ask the council | not set |
| Lismore DCP, Part A Chapter 1 Residential Development (R5 Large Lot Residential) | R5 Large Lot Residential land in Lismore City. | 15m | not set by the DCP: ask the council | not set by the DCP: ask the council | not set |
| Lismore DCP, Part A Chapter 1 Residential Development (C3 Environmental Management) | C3 Environmental Management land in Lismore City. | 15m | not set by the DCP: ask the council | not set by the DCP: ask the council | not set |
| Lismore DCP, Part B Chapter 10 North Lismore Plateau Urban Release Area | R1 General Residential land in the North Lismore Plateau urban release area, between Nimbin Road and Dunoon Road north of North Lismore (Figure 1 Location Plan). | 3m on lots up to 399.99m², 6m on larger lots | 0.9m on lots up to 399.99m², no figure on larger lots | not set by the DCP: ask the council | 4m |
| Lismore DCP (land to which LEP 2000 applies), Part A Chapter 1 Residential Development | Land shown as "Deferred matter" on the Lismore LEP 2012 Land Application Map, where Lismore LEP 2000 still applies (LEP 2012 cl 1.3(1A)). | the average of the neighbouring homes (6m where there are none) | 0.9m on lots up to 399.99m², no figure on larger lots | not set by the DCP: ask the council | 4m |
What are the complying development setbacks for a house?
If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.
| Example lot | Front | Side | Rear | Corner block, second street |
|---|---|---|---|---|
| 450m² (15m wide, 30m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 600m² (15m wide, 40m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 1,000m² (20m wide, 50m deep) | 6.5m | 1.5m (2.1m at two storeys) | 5m (12m at two storeys) | 3m |
What if my block is on a corner?
Lismore DCP, Part A Chapter 1 Residential Development (R1, R3 and RU5) sets a separate setback for a house from the second street, the side street of a corner block: 3m (Lismore DCP Part A, Chapter 1, s 4.1 Setbacks, A1.2). The complying development figure for the second street is in the CDC table above.
Does a two storey house need bigger setbacks?
No. Lismore DCP, Part A Chapter 1 Residential Development (R1, R3 and RU5) sets the same figures for a one or two storey house. Under complying development, the two storey figures are in the CDC table above.
What else do people ask?
Can Lismore Council approve a house closer to the boundary?
It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.
Do these setbacks apply to a shed, pool or fence in Lismore?
No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were the setbacks on this page checked?
We last read Lismore Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.