What are Hay Council's setbacks for a house, granny flat or duplex?
A setback is how far a home must sit from each boundary of its lot. In Hay the setbacks for a house, a granny flat or a duplex come from Hay Council's setback policy, which stands in for a development control plan (DCP), unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.
It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.
NSW addresses only. Free, and no sign up.
What are Hay Council's setbacks for a house?
Hay Council's main plan, Hay Shire Building Line Policy (a council policy, not a DCP), RU5 Village, asks a single storey house for these setbacks: front 5m, side 0.9m and rear 0.9m.
House setbacks in Hay gives the two storey figures, the clauses and every other plan that covers one.
What are Hay Council's setbacks for a granny flat?
Hay Council's main plan, Hay Shire Building Line Policy (a council policy, not a DCP), RU5 Village, asks a single storey granny flat for these setbacks: front 5m, side 0.9m and rear 0.9m.
Granny flat setbacks in Hay gives the two storey figures, the clauses and every other plan that covers one.
What are Hay Council's setbacks for a duplex?
Hay Council's main plan, Hay Shire Building Line Policy (a council policy, not a DCP), RU5 Village, asks a single storey duplex for these setbacks: front 5m, side 0.9m and rear 0.9m.
Duplex setbacks in Hay gives the two storey figures, the clauses and every other plan that covers one.
Which DCP covers my block in Hay?
It depends on the lot: we hold 4 plans with setbacks for homes in Hay Council, and Hay Shire Building Line Policy (a council policy, not a DCP), RU5 Village is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.
| Plan | Where it applies | Homes it covers |
|---|---|---|
| Hay Shire Building Line Policy (a council policy, not a DCP), RU5 Village | Main plan. Land zoned RU5 Village: the town of Hay (with North Hay and South Hay) and the villages of Maude and Booligal. | house, granny flat, duplex |
| Hay Shire Building Line Policy (a council policy, not a DCP), RU1 Primary Production | Land zoned RU1 Primary Production. | house, duplex |
| Hay Shire Building Line Policy (a council policy, not a DCP), RU4 Primary Production Small Lots | Land zoned RU4 Primary Production Small Lots around Hay. Hay Shire has no DCP; the council's Building Line Policy sets 10 m to the front, side and rear. | house |
| Hay Shire: no DCP (R2 Low Density Residential) | Land zoned R2 Low Density Residential: the single R2 area on the eastern edge of Hay township (229 Bourke Street and 41 Cemetery Road, about 26 ha). | house, granny flat, duplex |
Do Hay Council's setbacks apply to complying development?
No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).
The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
What setbacks apply on a corner block in Hay?
Hay Shire Building Line Policy (a council policy, not a DCP), RU5 Village sets a separate setback for a house from the second street, the side street of a corner block: 3m (Building Line Policy (22 March 2016), Setback Requirements, Residential (Zone RU5: Village)). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.
What else do people ask?
Can Hay Council approve a smaller setback?
It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
Do Hay setbacks apply to sheds, pools and fences?
Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were Hay Council's setbacks checked?
We last read Hay Council's plans on 12 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.