Skip to main content

How close to the boundary can a granny flat be in Ryde?

Ryde Council's main plan, City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached) (R2, R3, R4), names a granny flat but sets no front, side or rear setback for one, so a development application is assessed on its merits. Ask the council what it expects.

In Ryde the setbacks for a granny flat come from Ryde Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the granny flat first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Ryde Council's main plan set for a granny flat?

Ryde Council's main plan, City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached) (R2, R3, R4), names a granny flat but sets no front, side or rear setback for one, so a development application is assessed on its merits. Ask the council what it expects.

Which DCP applies to my block in Ryde?

It depends on where the lot is. City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached) (R2, R3, R4) is Ryde Council's main plan, and 8 other plans cover a granny flat on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Ryde that cover a granny flat
PlanWhere it appliesFrontSideRearSecond street
City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached) (R1)Zone R1 General Residential in the City of Ryde (about 11 ha).not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
City of Ryde DCP 2014, Part 5.1 Coronation Avenue and Trelawney Street, Eastwood Character AreaThe Coronation Avenue and Trelawney Street, Eastwood Character Area shown on Figure 5.1.01, less the four corner lots that have their own plans: Coronation Avenue 3 to 23 and 2 to 6, Trelawney Street 31A, 33, 35, 37 and 39, and 6 Clanwilliam Street (25 lots), zoned R2.not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
City of Ryde DCP 2014, Part 5.1 Coronation Avenue and Trelawney Street, Eastwood Character Area (Stewart Street corner lots)The two corner lots of the Coronation Avenue and Trelawney Street Character Area (Figure 5.1.01) with a side frontage to Stewart Street: 8 and 10 Coronation Avenue, zoned R2.not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
City of Ryde DCP 2014, Part 5.1 Coronation Avenue and Trelawney Street, Eastwood Character Area (corner lots on Clanwilliam Street and Shaftsbury Road)The two corner lots of the Coronation Avenue and Trelawney Street Character Area (Figure 5.1.01) whose side street is neither Coronation Avenue nor Stewart Street: 1 Coronation Avenue (side to Clanwilliam Street) and 31 Trelawney Street (side to Shaftsbury Road), zoned R2.not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
City of Ryde DCP 2014, Part 5.2 Eastwood House Estate Heritage Conservation AreaThe Eastwood House Estate heritage conservation area (Ryde LEP 2014 Schedule 5, C4): the land "edged by a thick black line on the map marked "Eastwood House Conservation Area"" (Part 5.2 s 1.0, Figure 5.2.01).not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
City of Ryde DCP 2014, Part 5.3 Tyrell Street, Gladesville, Character AreaThe Tyrell Street, Gladesville Character Area, which is also heritage conservation area C8 under Ryde LEP 2014 Schedule 5: the land "edged by a thick black line on the map" (Part 5.3 s 1.0, Figure 5.3.01).not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached), s 3.1 West Ryde Special Development AreaThe West Ryde Special Development Area shown on Figure 3.3.28: the land between Marsden Road and Brush Road from Rutledge Street south to where Marsden Road meets Winbourne Street, including Marsden High School (south of the school, only the land west of Winbourne Street).not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached), s 3.2 Denistone Character AreaThe Denistone Character Area shown on Figure 3.3.29: Bellevue Avenue, Burman Road, Simla Road, Buena Vista Avenue, the west side of Chatham Road, the east side of Trelawney Street around Outlook Park, and some Shaftsbury Road and Clanalpine Street lots (317 lots).not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set

What are the complying development setbacks for a granny flat?

If you build a granny flat with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a granny flat on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m2m
1,000m² (20m wide, 50m deep)6.5m1.5m5m3m

What if my block is on a corner?

City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached) (R2, R3, R4) sets no separate setback for the second street of a corner block for a granny flat, so ask the council how it treats one. The complying development figure for the second street is in the CDC table above.

Does a two storey granny flat need bigger setbacks?

City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached) (R2, R3, R4) sets no setbacks for a granny flat of any height, so ask the council. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Ryde Council approve a granny flat closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Ryde?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Ryde Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block