How close to the boundary can a house be in Ryde?
Ryde Council's main plan, City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached) (R2, R3, R4), asks a single storey house for these setbacks: front 6m; side 0.9m; and rear 25% of the lot depth, and at least 8m.
In Ryde the setbacks for a house come from Ryde Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.
NSW addresses only. Free, and no sign up.
What setbacks does Ryde Council's main plan set for a house?
The table gives City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached) (R2, R3, R4)'s one and two storey figures and the clause each comes from. The plan covers this land: Zones R2 Low Density Residential, R3 Medium Density Residential and R4 High Density Residential in the City of Ryde, outside the character and conservation areas below.
| Setback | One storey | Two storeys | Where in the plan |
|---|---|---|---|
| Front | 6m | 6m | City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached), s 2.9.1 Front Setbacks, control a |
| Side | 0.9m | 1.5m | City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached), s 2.9.2 Side Setbacks, controls a and b |
| Rear | 25% of the lot depth, and at least 8m | 25% of the lot depth, and at least 8m | City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached), s 2.9.3 Rear Setbacks, control a |
| Corner block, second street | 2m | 2m | City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached), s 2.9.1 Front Setbacks, control b |
Which DCP applies to my block in Ryde?
It depends on where the lot is. City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached) (R2, R3, R4) is Ryde Council's main plan, and 8 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached) (R1) | Zone R1 General Residential in the City of Ryde (about 11 ha). | 6m | 0.9m | 25% of the lot depth, and at least 8m | 2m |
| City of Ryde DCP 2014, Part 5.1 Coronation Avenue and Trelawney Street, Eastwood Character Area | The Coronation Avenue and Trelawney Street, Eastwood Character Area shown on Figure 5.1.01, less the four corner lots that have their own plans: Coronation Avenue 3 to 23 and 2 to 6, Trelawney Street 31A, 33, 35, 37 and 39, and 6 Clanwilliam Street (25 lots), zoned R2. | the average of the neighbouring homes (6m where there are none) | 1.5m to one side, 4m (for at least 5.0 m past the front building line; 1.0 m beyond that) to the other | 25% of the lot depth, and at least 8m | 4m (Coronation Avenue frontage) |
| City of Ryde DCP 2014, Part 5.1 Coronation Avenue and Trelawney Street, Eastwood Character Area (Stewart Street corner lots) | The two corner lots of the Coronation Avenue and Trelawney Street Character Area (Figure 5.1.01) with a side frontage to Stewart Street: 8 and 10 Coronation Avenue, zoned R2. | the average of the neighbouring homes (6m where there are none) | 1.5m to one side, 4m (for at least 5.0 m past the front building line; 1.0 m beyond that) to the other | 25% of the lot depth, and at least 8m | 2.5m (Stewart Street frontage) |
| City of Ryde DCP 2014, Part 5.1 Coronation Avenue and Trelawney Street, Eastwood Character Area (corner lots on Clanwilliam Street and Shaftsbury Road) | The two corner lots of the Coronation Avenue and Trelawney Street Character Area (Figure 5.1.01) whose side street is neither Coronation Avenue nor Stewart Street: 1 Coronation Avenue (side to Clanwilliam Street) and 31 Trelawney Street (side to Shaftsbury Road), zoned R2. | the average of the neighbouring homes (6m where there are none) | 1.5m to one side, 4m (for at least 5.0 m past the front building line; 1.0 m beyond that) to the other | 25% of the lot depth, and at least 8m | 2m (Clanwilliam Street or Shaftsbury Road frontage) |
| City of Ryde DCP 2014, Part 5.2 Eastwood House Estate Heritage Conservation Area | The Eastwood House Estate heritage conservation area (Ryde LEP 2014 Schedule 5, C4): the land "edged by a thick black line on the map marked "Eastwood House Conservation Area"" (Part 5.2 s 1.0, Figure 5.2.01). | the average of the neighbouring homes (6m where there are none) | 0.9m | 25% of the lot depth, and at least 8m | 2m |
| City of Ryde DCP 2014, Part 5.3 Tyrell Street, Gladesville, Character Area | The Tyrell Street, Gladesville Character Area, which is also heritage conservation area C8 under Ryde LEP 2014 Schedule 5: the land "edged by a thick black line on the map" (Part 5.3 s 1.0, Figure 5.3.01). | the average of the neighbouring homes (6m where there are none) | 1.5m to one side, 4m (for at least 5.0 m past the front building line; 1.0 m beyond that) to the other | 25% of the lot depth, and at least 8m | 4m |
| City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached), s 3.1 West Ryde Special Development Area | The West Ryde Special Development Area shown on Figure 3.3.28: the land between Marsden Road and Brush Road from Rutledge Street south to where Marsden Road meets Winbourne Street, including Marsden High School (south of the school, only the land west of Winbourne Street). | the average of the neighbouring homes (6m where there are none) | 0.9m | 25% of the lot depth, and at least 8m | 2m |
| City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached), s 3.2 Denistone Character Area | The Denistone Character Area shown on Figure 3.3.29: Bellevue Avenue, Burman Road, Simla Road, Buena Vista Avenue, the west side of Chatham Road, the east side of Trelawney Street around Outlook Park, and some Shaftsbury Road and Clanalpine Street lots (317 lots). | the average of the neighbouring homes (6m where there are none) | 0.9m | 25% of the lot depth, and at least 8m | 2m |
What are the complying development setbacks for a house?
If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.
| Example lot | Front | Side | Rear | Corner block, second street |
|---|---|---|---|---|
| 450m² (15m wide, 30m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 600m² (15m wide, 40m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 1,000m² (20m wide, 50m deep) | 6.5m | 1.5m (2.1m at two storeys) | 5m (12m at two storeys) | 3m |
What if my block is on a corner?
City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached) (R2, R3, R4) sets a separate setback for a house from the second street, the side street of a corner block: 2m (City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached), s 2.9.1 Front Setbacks, control b). The complying development figure for the second street is in the CDC table above.
Does a two storey house need bigger setbacks?
Yes, under City of Ryde DCP 2014, Part 3.3 Dwelling Houses and Dual Occupancy (attached) (R2, R3, R4): the side setback goes from 0.9m to 1.5m. Under complying development, the two storey figures are in the CDC table above.
What else do people ask?
Can Ryde Council approve a house closer to the boundary?
It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.
Do these setbacks apply to a shed, pool or fence in Ryde?
No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were the setbacks on this page checked?
We last read Ryde Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.