Skip to main content

How close to the boundary can a granny flat be in Maitland?

Maitland Council's main plan, Maitland DCP 2026, Chapter 6 Residential Uses, s 6.2.10 Table 6.5 (R1 General Residential), asks a single storey granny flat for these setbacks: front the average of the neighbouring homes (4.5m where there are none); side inside a plane rising at 45° from 3m above the boundary, and at least 0.9m; and rear 3m on lots up to 899.99m²; 5m on lots up to 1,499.99m²; 10m on larger lots.

In Maitland the setbacks for a granny flat come from Maitland Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the granny flat first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Maitland Council's main plan set for a granny flat?

The table gives Maitland DCP 2026, Chapter 6 Residential Uses, s 6.2.10 Table 6.5 (R1 General Residential)'s one and two storey figures and the clause each comes from. The plan covers this land: R1 General Residential land in Maitland, outside the Chapter 10 locality plans and release areas and the Morpeth conservation area that set their own setbacks.

Maitland DCP 2026, Chapter 6 Residential Uses, s 6.2.10 Table 6.5 (R1 General Residential): setbacks for a granny flat
SetbackOne storeyTwo storeysWhere in the plan
Frontthe average of the neighbouring homes (4.5m where there are none)the average of the neighbouring homes (4.5m where there are none)Maitland DCP 2026, Chapter 6, s 6.2.10 Housing setbacks, PC.1, Table 6.5, Secondary dwellings, Front setback; s 6.5 PC.3
Sideinside a plane rising at 45° from 3m above the boundary, and at least 0.9minside a plane rising at 45° from 3m above the boundary, and at least 0.9mMaitland DCP 2026, Chapter 6, s 6.2.10 Housing setbacks, PC.1, Table 6.5, Secondary dwellings; s 6.2.10 PC.2; Figure 6-6
Rear3m on lots up to 899.99m²; 5m on lots up to 1,499.99m²; 10m on larger lots3m on lots up to 899.99m²; 5m on lots up to 1,499.99m²; 10m on larger lotsMaitland DCP 2026, Chapter 6, s 6.2.10 Housing setbacks, PC.1, Table 6.5, Secondary dwellings, Rear setback
Corner block, second street2m2mMaitland DCP 2026, Chapter 6, s 6.2.10 Housing setbacks, PC.1, Table 6.5, Secondary dwellings, Secondary setback (corner lots)

Which DCP applies to my block in Maitland?

It depends on where the lot is. Maitland DCP 2026, Chapter 6 Residential Uses, s 6.2.10 Table 6.5 (R1 General Residential) is Maitland Council's main plan, and 8 other plans cover a granny flat on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Maitland that cover a granny flat
PlanWhere it appliesFrontSideRearSecond street
Maitland DCP 2026, Chapter 6 Residential Uses, Table 6.5 (R5 Large Lot Residential)R5 Large Lot Residential land in Maitland, outside Bolwarra Heights, Greta (Orient Street) and the Mount Harris release area, which have their own setbacks.10m on lots up to 5,000m²; 20m on larger lotsinside a plane rising at 45° from 3m above the boundary, and at least 0.9m3m on lots up to 899.99m²; 5m on lots up to 1,499.99m²; 10m on larger lots6m on lots up to 5,000m²; 10m on larger lots
Maitland DCP 2026, Chapter 10, s 10.3.2 Bolwarra Heights locality planThe land in Figure 10-5, bounded by Tocal Road, Lang Drive and Paterson Road, Bolwarra Heights: "This Locality Plan applies to all land detailed in Figure 10-5." 98% of it is R5.20minside a plane rising at 45° from 3m above the boundary, and at least 0.9m3m on lots up to 899.99m²; 5m on lots up to 1,499.99m²; 10m on larger lots6m on lots up to 5,000m²; 10m on larger lots
Maitland DCP 2026, Chapter 10, s 10.3.4 Greta (Orient Street) locality planThe land in Figure 10-7 on the east side of Orient Street, Greta: "This Locality Plan applies to all land indicated within Figure 10-7." The subdivided lots (DP883618) are R5; the northern strip inside the outline is part of a larger RU2 lot.10m10m10m10m
Maitland DCP 2026, Chapter 10, s 10.3.7 Thornton (Radburn Estate) locality planRadburn Estate, Thornton, as outlined in Figure 10-11: "This Locality Plan applies to: Lots within the Radburn Estate at Thornton which have a property frontage to a public reserve, and Lots within the Radburn Estate at Thornton as shown on Figure 10-11 which have a principal frontage to a public reserve." R1.the average of the neighbouring homes (4.5m where there are none)inside a plane rising at 45° from 3m above the boundary, and at least 0.9m6m (the boundary to the public reserve, where the lot's principal frontage is to the reserve)2m
Maitland DCP 2026, Chapter 10, s 10.3.8 Thornton (Hermitage Close) locality planThe Hermitage Close precinct, Thornton, in Figure 10-12: "This Locality Plan applies to all land detailed in Figure 10-12." R1.12m4m4m5m
Maitland DCP 2026, Chapter 10, s 10.4.11 Mount Harris Urban Release AreaThe Mount Harris Urban Release Area off Maitland Vale Road (Figure 10-100, about 23 ha, R5): "The Mount Harris Urban Release Area is made up of one precinct, which utilises the general provisions of this section."12m4m4m5m
Maitland DCP 2026, Chapter 10, s 10.4.17 Anambah Urban Release AreaR1 land in the Anambah Urban Release Area (Figure 10-130, about 500 ha north of Windella), mostly not yet subdivided.the average of the neighbouring homes (4.5m where there are none)inside a plane rising at 45° from 3m above the boundary, and at least 0.9m3m on lots up to 899.99m²; 5m on lots up to 1,499.99m²; 10m on larger lots2m
Maitland DCP 2026, Chapter 4 Heritage, s 4.12 Morpeth Heritage Conservation AreaR1 land in the Morpeth Heritage Conservation Area (Figure 4-13; Maitland LEP 2011 heritage map item C6).the average of the neighbouring homes (4.5m where there are none)inside a plane rising at 45° from 3m above the boundary, and at least 1.5m3m on lots up to 899.99m²; 5m on lots up to 1,499.99m²; 10m on larger lots2m

What are the complying development setbacks for a granny flat?

If you build a granny flat with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a granny flat on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m2m
1,000m² (20m wide, 50m deep)6.5m1.5m5m3m

What if my block is on a corner?

Maitland DCP 2026, Chapter 6 Residential Uses, s 6.2.10 Table 6.5 (R1 General Residential) sets a separate setback for a granny flat from the second street, the side street of a corner block: 2m (Maitland DCP 2026, Chapter 6, s 6.2.10 Housing setbacks, PC.1, Table 6.5, Secondary dwellings, Secondary setback (corner lots)). The complying development figure for the second street is in the CDC table above.

Does a two storey granny flat need bigger setbacks?

Yes, through the wall height: under Maitland DCP 2026, Chapter 6 Residential Uses, s 6.2.10 Table 6.5 (R1 General Residential) the side setback grows as the wall gets taller. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Maitland Council approve a granny flat closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Maitland?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Maitland Council's plans on 11 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block