How close to the boundary can a duplex be in Federation?
Federation Council's main plan, Corowa DCP 2013, Chapter 2 Residential Development (Average and Higher density), asks a single storey duplex for these setbacks: front the average of the neighbouring homes (4.5m where there are none), side 2m and rear 2m.
In Federation the setbacks for a duplex come from Federation Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the duplex first.
NSW addresses only. Free, and no sign up.
What setbacks does Federation Council's main plan set for a duplex?
The table gives Corowa DCP 2013, Chapter 2 Residential Development (Average and Higher density)'s one and two storey figures and the clause each comes from. The plan covers this land: R1 General Residential and RU5 Village land in the former Corowa Shire (Corowa, Howlong, Mulwala and the villages), under Corowa LEP 2012.
| Setback | One storey | Two storeys | Where in the plan |
|---|---|---|---|
| Front | the average of the neighbouring homes (4.5m where there are none) | the average of the neighbouring homes (4.5m where there are none) | Corowa DCP 2013, s 2.5 Building setbacks, standard 4 (Higher density) |
| Side | 2m | 2m | Corowa DCP 2013, s 2.5 Building setbacks, standard 5 (Higher density) |
| Rear | 2m | 2m | Corowa DCP 2013, s 2.5 Building setbacks, standard 5 (Higher density) |
| Corner block, second street | 4m | 4m | Corowa DCP 2013, s 2.5 Building setbacks, standard 6 (Higher density) |
Which DCP applies to my block in Federation?
It depends on where the lot is. Corowa DCP 2013, Chapter 2 Residential Development (Average and Higher density) is Federation Council's main plan, and 5 other plans cover a duplex on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Corowa DCP 2013, Chapter 2 Residential Development (Lower density, 1 ha areas) | R2 Low Density Residential land in the former Corowa Shire where the Corowa LEP 2012 Lot Size Map sets a 1 ha minimum (about 811 ha around Corowa, Howlong and Mulwala). | 10m | 5m | 5m | not set |
| Corowa DCP 2013, Chapter 2 Residential Development (R2 land with a 550 m2 minimum lot) | R2 Low Density Residential land in the former Corowa Shire where the Corowa LEP 2012 Lot Size Map sets 550 m2 (about 368 ha, mostly in Corowa town, with a little in Mulwala). | the average of the neighbouring homes (4.5m where there are none) | 2m | 2m | 4m |
| Corowa DCP 2013, Chapter 2 Residential Development (Rural, RU1 Primary Production) | RU1 Primary Production land in the former Corowa Shire. | 50m | 10m | 15m | 10m |
| Corowa DCP 2013, Chapter 7 Mulwala Foreshore Land | R1 and R2 lots in Mulwala adjoining Lake Mulwala foreshore land (DCP Ch 7: "This chapter of the CDCP applies to `foreshore land' and adjoining land around Lake Mulwala within the township of Mulwala."). | not set by the DCP: ask the council | not set by the DCP: ask the council | not set by the DCP: ask the council | not set |
| Urana Shire DCP 2011, Circular V1 Village Zones | RU5 Village land in the former Urana Shire (Urana, Oaklands, Rand, Boree Creek and Morundah), under Urana LEP 2011. | 6m | 0.9m | 3m | 3m |
What are the complying development setbacks for a duplex?
If you build a duplex with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.
| Example lot | Front | Side | Rear | Corner block, second street |
|---|---|---|---|---|
| 450m² (15m wide, 30m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 600m² (15m wide, 40m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 1,000m² (20m wide, 50m deep) | 6.5m | 0.9m (1.5m at two storeys) | 5m (12m at two storeys) | 3m |
What if my block is on a corner?
Corowa DCP 2013, Chapter 2 Residential Development (Average and Higher density) sets a separate setback for a duplex from the second street, the side street of a corner block: 4m (Corowa DCP 2013, s 2.5 Building setbacks, standard 6 (Higher density)). Where the duplex faces that street, it asks for the average of the neighbouring homes (4.5m where there are none) (detached dwellings that face the second frontage). The complying development figure for the second street is in the CDC table above.
Does a two storey duplex need bigger setbacks?
No. Corowa DCP 2013, Chapter 2 Residential Development (Average and Higher density) sets the same figures for a one or two storey duplex. Under complying development, the two storey figures are in the CDC table above.
What else do people ask?
Can Federation Council approve a duplex closer to the boundary?
It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.
Do these setbacks apply to a shed, pool or fence in Federation?
No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were the setbacks on this page checked?
We last read Federation Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.