Skip to main content

How close to the boundary can a house be in Federation?

Federation Council's main plan, Corowa DCP 2013, Chapter 2 Residential Development (Average and Higher density), asks a single storey house for these setbacks: front the average of the neighbouring homes (3m on lots up to 300m²; 4.5m on lots up to 900m²; 6.5m on lots up to 1,500m²; 10m on larger lots where there are none); side 0.9m, plus 0.25m for every metre of wall above 5.5m on lots up to 10m wide; 0.9m, plus 0.25m for every metre of wall above 4.5m on lots up to 18m wide; 1.5m, plus 0.25m for every metre of wall above 4.5m on lots up to 24m wide; 2.5m on wider lots; and rear 3m on lots up to 300m²; 3m on lots up to 900m²; 5m on lots up to 1,500m²; 10m on larger lots.

In Federation the setbacks for a house come from Federation Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Federation Council's main plan set for a house?

The table gives Corowa DCP 2013, Chapter 2 Residential Development (Average and Higher density)'s one and two storey figures and the clause each comes from. The plan covers this land: R1 General Residential and RU5 Village land in the former Corowa Shire (Corowa, Howlong, Mulwala and the villages), under Corowa LEP 2012.

Corowa DCP 2013, Chapter 2 Residential Development (Average and Higher density): setbacks for a house
SetbackOne storeyTwo storeysWhere in the plan
Frontthe average of the neighbouring homes (3m on lots up to 300m²; 4.5m on lots up to 900m²; 6.5m on lots up to 1,500m²; 10m on larger lots where there are none)the average of the neighbouring homes (3m on lots up to 300m²; 4.5m on lots up to 900m²; 6.5m on lots up to 1,500m²; 10m on larger lots where there are none)Corowa DCP 2013, s 2.5 Building setbacks, standard 3 (Average density); Codes SEPP 2008 cl 3.10(1) and (3)
Side0.9m, plus 0.25m for every metre of wall above 5.5m on lots up to 10m wide; 0.9m, plus 0.25m for every metre of wall above 4.5m on lots up to 18m wide; 1.5m, plus 0.25m for every metre of wall above 4.5m on lots up to 24m wide; 2.5m on wider lots0.9m, plus 0.25m for every metre of wall above 5.5m on lots up to 10m wide; 0.9m, plus 0.25m for every metre of wall above 4.5m on lots up to 18m wide; 1.5m, plus 0.25m for every metre of wall above 4.5m on lots up to 24m wide; 2.5m on wider lotsCorowa DCP 2013, s 2.5 Building setbacks, standard 3 (Average density); Codes SEPP 2008 cl 3.10(4)
Rear3m on lots up to 300m²; 3m on lots up to 900m²; 5m on lots up to 1,500m²; 10m on larger lotsthe average of the neighbouring homes (10m where there are none) on lots up to 300m²; 8m on lots up to 900m²; 12m on lots up to 1,500m²; 15m on larger lotsCorowa DCP 2013, s 2.5 Building setbacks, standard 3 (Average density); Codes SEPP 2008 cl 3.10(10)
Corner block, second street2m on lots up to 600m²; 3m on lots up to 1,500m²; 5m on larger lots2m on lots up to 600m²; 3m on lots up to 1,500m²; 5m on larger lotsCorowa DCP 2013, s 2.5 Building setbacks, standard 3 (Average density); Codes SEPP 2008 cl 3.10(11)

Which DCP applies to my block in Federation?

It depends on where the lot is. Corowa DCP 2013, Chapter 2 Residential Development (Average and Higher density) is Federation Council's main plan, and 7 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Federation that cover a house
PlanWhere it appliesFrontSideRearSecond street
Corowa DCP 2013, Chapter 2 Residential Development (Lower density, 1 ha areas)R2 Low Density Residential land in the former Corowa Shire where the Corowa LEP 2012 Lot Size Map sets a 1 ha minimum (about 811 ha around Corowa, Howlong and Mulwala).10m5m5mnot set
Corowa DCP 2013, Chapter 2 Residential Development (R2 land with a 550 m2 minimum lot)R2 Low Density Residential land in the former Corowa Shire where the Corowa LEP 2012 Lot Size Map sets 550 m2 (about 368 ha, mostly in Corowa town, with a little in Mulwala).not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
Corowa DCP 2013, Chapter 2 Residential Development (Rural, R5 Large Lot Residential)R5 Large Lot Residential land in the former Corowa Shire (one 666 ha zone polygon, 5 ha minimum lot size).the average of the neighbouring homes (10m where there are none) on lots up to 3,999.99m²; 15m on larger lots2.5m on lots up to 3,999.99m²; 10m on larger lots15m5m on lots up to 3,999.99m²; 10m on larger lots
Corowa DCP 2013, Chapter 2 Residential Development (Rural, RU1 Primary Production)RU1 Primary Production land in the former Corowa Shire.50m10m15m10m
Corowa DCP 2013, Chapter 7 Mulwala Foreshore LandR1 and R2 lots in Mulwala adjoining Lake Mulwala foreshore land (DCP Ch 7: "This chapter of the CDCP applies to `foreshore land' and adjoining land around Lake Mulwala within the township of Mulwala.").not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
Urana Shire DCP 2011, Circular V1 Village ZonesRU5 Village land in the former Urana Shire (Urana, Oaklands, Rand, Boree Creek and Morundah), under Urana LEP 2011.6m0.9m3m3m
Urana Shire DCP 2011, Circular R2 Large Lot Residential ZoneR5 Large Lot Residential land in the former Urana Shire (about 166 ha, 1 ha minimum lot size), under Urana LEP 2011.15m10m10m10m

What are the complying development setbacks for a house?

If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a house on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
1,000m² (20m wide, 50m deep)6.5m1.5m (2.1m at two storeys)5m (12m at two storeys)3m

What if my block is on a corner?

Corowa DCP 2013, Chapter 2 Residential Development (Average and Higher density) sets a separate setback for a house from the second street, the side street of a corner block: 2m on lots up to 600m²; 3m on lots up to 1,500m²; 5m on larger lots (Corowa DCP 2013, s 2.5 Building setbacks, standard 3 (Average density); Codes SEPP 2008 cl 3.10(11)). The complying development figure for the second street is in the CDC table above.

Does a two storey house need bigger setbacks?

Yes, under Corowa DCP 2013, Chapter 2 Residential Development (Average and Higher density): the rear setback goes from 3m on lots up to 300m²; 3m on lots up to 900m²; 5m on lots up to 1,500m²; 10m on larger lots to the average of the neighbouring homes (10m where there are none) on lots up to 300m²; 8m on lots up to 900m²; 12m on lots up to 1,500m²; 15m on larger lots. The side setback also grows as the wall gets taller. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Federation Council approve a house closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Federation?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Federation Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block