What are Cootamundra-Gundagai Regional Council's setbacks for a house, granny flat or duplex?
A setback is how far a home must sit from each boundary of its lot. In Cootamundra-Gundagai Regional the setbacks for a house, a granny flat or a duplex come from Cootamundra-Gundagai Regional Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.
It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.
NSW addresses only. Free, and no sign up.
What are Cootamundra-Gundagai Regional Council's setbacks for a house?
Cootamundra-Gundagai Regional Council's main plan, Cootamundra DCP 2013, Chapter 2 Residential Development (R1 and R3), asks a single storey house for these setbacks: front the average of the neighbouring homes (4.5m on lots up to 599.99m²; 4.5m on lots up to 899.99m²; 6.5m on lots up to 1,499.99m²; 10m on larger lots where there are none). It does not set a side or rear setback: ask the council.
House setbacks in Cootamundra-Gundagai Regional gives the two storey figures, the clauses and every other plan that covers one.
What are Cootamundra-Gundagai Regional Council's setbacks for a granny flat?
Cootamundra-Gundagai Regional Council's main plan, Cootamundra DCP 2013, Chapter 2 Residential Development (R1 and R3), asks a single storey granny flat for these setbacks: front the average of the neighbouring homes (4.5m on lots up to 599.99m²; 4.5m on lots up to 899.99m²; 6.5m on lots up to 1,499.99m²; 10m on larger lots where there are none). It does not set a side or rear setback: ask the council.
Granny flat setbacks in Cootamundra-Gundagai Regional gives the two storey figures, the clauses and every other plan that covers one.
What are Cootamundra-Gundagai Regional Council's setbacks for a duplex?
Cootamundra-Gundagai Regional Council's main plan, Cootamundra DCP 2013, Chapter 2 Residential Development (R1 and R3), asks a single storey duplex for these setbacks: front the average of the neighbouring homes (4.5m on lots up to 599.99m²; 4.5m on lots up to 899.99m²; 6.5m on lots up to 1,499.99m²; 10m on larger lots where there are none). It does not set a side or rear setback: ask the council.
Duplex setbacks in Cootamundra-Gundagai Regional gives the two storey figures, the clauses and every other plan that covers one.
Which DCP covers my block in Cootamundra-Gundagai Regional?
It depends on the lot: we hold 8 plans with setbacks for homes in Cootamundra-Gundagai Regional Council, and Cootamundra DCP 2013, Chapter 2 Residential Development (R1 and R3) is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.
| Plan | Where it applies | Homes it covers |
|---|---|---|
| Cootamundra DCP 2013, Chapter 2 Residential Development (R1 and R3) | Main plan. Land zoned R1 General Residential or R3 Medium Density Residential in the former Cootamundra Shire, except the Florence Gardens Estate. | house, granny flat, duplex |
| Cootamundra DCP 2013, Chapter 2 Residential Development (Florence Gardens Estate) | The Florence Gardens Estate, Cootamundra: the allotments facing Mary Angove Crescent and Chelonia Street (R1). | house, granny flat, duplex |
| Cootamundra DCP 2013, Chapter 2 Residential Development (R5 and RU5) | Land zoned R5 Large Lot Residential or RU5 Village in the former Cootamundra Shire (Cootamundra's large lot areas and the villages, e.g. Stockinbingal and Wallendbeen). | house, granny flat, duplex |
| Cootamundra DCP 2013, Chapter 2 Residential Development (RU4) | Land zoned RU4 Primary Production Small Lots in the former Cootamundra Shire. | house, duplex |
| Cootamundra DCP 2013 (RU1 and RU2: no dwelling setbacks) | Land zoned RU1 Primary Production or RU2 Rural Landscape in the former Cootamundra Shire. | house, granny flat, duplex |
| Cootamundra DCP 2013 (C3 and C4: no dwelling setbacks) | Land zoned C3 Environmental Management or C4 Environmental Living in the former Cootamundra Shire. | house |
| Former Gundagai Shire: no DCP (RU1 and RU4) | Land zoned RU1 Primary Production or RU4 Primary Production Small Lots in the former Gundagai Shire, where no DCP applies. | house, granny flat |
| Former Gundagai Shire: no DCP (residential, village and centre zones) | Land zoned R1, R3, R5, RU5, E1 or MU1 in the former Gundagai Shire (Gundagai, South Gundagai and the villages), where no DCP applies. | house, granny flat, duplex |
Do Cootamundra-Gundagai Regional Council's setbacks apply to complying development?
No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).
The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
What setbacks apply on a corner block in Cootamundra-Gundagai Regional?
Cootamundra DCP 2013, Chapter 2 Residential Development (R1 and R3) sets a separate setback for a house from the second street, the side street of a corner block: 2m on lots up to 599.99m²; 3m on lots up to 899.99m²; 3m on lots up to 1,499.99m²; 5m on larger lots (Chapter 2, 2.1 Building Line Setbacks, Secondary Building Line Setbacks For Corner Lots, Acceptable solutions (table)). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.
What else do people ask?
Can Cootamundra-Gundagai Regional Council approve a smaller setback?
It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
Do Cootamundra-Gundagai Regional setbacks apply to sheds, pools and fences?
Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were Cootamundra-Gundagai Regional Council's setbacks checked?
We last read Cootamundra-Gundagai Regional Council's plans on 12 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.