Skip to main content

How close to the boundary can a granny flat be in Cootamundra-Gundagai Regional?

Cootamundra-Gundagai Regional Council's main plan, Cootamundra DCP 2013, Chapter 2 Residential Development (R1 and R3), asks a single storey granny flat for these setbacks: front the average of the neighbouring homes (4.5m on lots up to 599.99m²; 4.5m on lots up to 899.99m²; 6.5m on lots up to 1,499.99m²; 10m on larger lots where there are none). It does not set a side or rear setback: ask the council.

In Cootamundra-Gundagai Regional the setbacks for a granny flat come from Cootamundra-Gundagai Regional Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the granny flat first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Cootamundra-Gundagai Regional Council's main plan set for a granny flat?

The table gives Cootamundra DCP 2013, Chapter 2 Residential Development (R1 and R3)'s one and two storey figures and the clause each comes from. The plan covers this land: Land zoned R1 General Residential or R3 Medium Density Residential in the former Cootamundra Shire, except the Florence Gardens Estate.

Cootamundra DCP 2013, Chapter 2 Residential Development (R1 and R3): setbacks for a granny flat
SetbackOne storeyTwo storeysWhere in the plan
Frontthe average of the neighbouring homes (4.5m on lots up to 599.99m²; 4.5m on lots up to 899.99m²; 6.5m on lots up to 1,499.99m²; 10m on larger lots where there are none)the average of the neighbouring homes (4.5m on lots up to 599.99m²; 4.5m on lots up to 899.99m²; 6.5m on lots up to 1,499.99m²; 10m on larger lots where there are none)Chapter 2, 2.1 Building Line Setbacks, Front Primary Building Line Setback Requirements, Acceptable Solutions 1 and 2 (table)
Sidenot set by the DCP: ask the councilnot set by the DCP: ask the councilNone
Rearnot set by the DCP: ask the councilnot set by the DCP: ask the councilNone
Corner block, second street2m on lots up to 599.99m²; 3m on lots up to 899.99m²; 3m on lots up to 1,499.99m²; 5m on larger lots2m on lots up to 599.99m²; 3m on lots up to 899.99m²; 3m on lots up to 1,499.99m²; 5m on larger lotsChapter 2, 2.1 Building Line Setbacks, Secondary Building Line Setbacks For Corner Lots, Acceptable solutions (table)

Which DCP applies to my block in Cootamundra-Gundagai Regional?

It depends on where the lot is. Cootamundra DCP 2013, Chapter 2 Residential Development (R1 and R3) is Cootamundra-Gundagai Regional Council's main plan, and 5 other plans cover a granny flat on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Cootamundra-Gundagai Regional that cover a granny flat
PlanWhere it appliesFrontSideRearSecond street
Cootamundra DCP 2013, Chapter 2 Residential Development (Florence Gardens Estate)The Florence Gardens Estate, Cootamundra: the allotments facing Mary Angove Crescent and Chelonia Street (R1).the average of the neighbouring homes (4.5m on lots up to 599.99m²; 4.5m on lots up to 899.99m²; 6.5m on lots up to 1,499.99m²; 10m on larger lots where there are none)not set by the DCP: ask the councilnot set by the DCP: ask the council2m on lots up to 599.99m²; 3m on lots up to 899.99m²; 3m on lots up to 1,499.99m²; 5m on larger lots
Cootamundra DCP 2013, Chapter 2 Residential Development (R5 and RU5)Land zoned R5 Large Lot Residential or RU5 Village in the former Cootamundra Shire (Cootamundra's large lot areas and the villages, e.g. Stockinbingal and Wallendbeen).the average of the neighbouring homes (4.5m on lots up to 599.99m²; 4.5m on lots up to 899.99m²; 6.5m on lots up to 1,499.99m²; 10m on larger lots where there are none)not set by the DCP: ask the councilnot set by the DCP: ask the council2m on lots up to 599.99m²; 3m on lots up to 899.99m²; 3m on lots up to 1,499.99m²; 5m on larger lots
Cootamundra DCP 2013 (RU1 and RU2: no dwelling setbacks)Land zoned RU1 Primary Production or RU2 Rural Landscape in the former Cootamundra Shire.not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
Former Gundagai Shire: no DCP (RU1 and RU4)Land zoned RU1 Primary Production or RU4 Primary Production Small Lots in the former Gundagai Shire, where no DCP applies.not set (the council has no DCP): ask the councilnot set (the council has no DCP): ask the councilnot set (the council has no DCP): ask the councilnot set
Former Gundagai Shire: no DCP (residential, village and centre zones)Land zoned R1, R3, R5, RU5, E1 or MU1 in the former Gundagai Shire (Gundagai, South Gundagai and the villages), where no DCP applies.not set (the council has no DCP): ask the councilnot set (the council has no DCP): ask the councilnot set (the council has no DCP): ask the councilnot set

What are the complying development setbacks for a granny flat?

If you build a granny flat with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a granny flat on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m2m
1,000m² (20m wide, 50m deep)6.5m1.5m5m3m

What if my block is on a corner?

Cootamundra DCP 2013, Chapter 2 Residential Development (R1 and R3) sets a separate setback for a granny flat from the second street, the side street of a corner block: 2m on lots up to 599.99m²; 3m on lots up to 899.99m²; 3m on lots up to 1,499.99m²; 5m on larger lots (Chapter 2, 2.1 Building Line Setbacks, Secondary Building Line Setbacks For Corner Lots, Acceptable solutions (table)). It measures the front setback from the shorter street frontage. The complying development figure for the second street is in the CDC table above.

Does a two storey granny flat need bigger setbacks?

No. Cootamundra DCP 2013, Chapter 2 Residential Development (R1 and R3) sets the same figures for a one or two storey granny flat. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Cootamundra-Gundagai Regional Council approve a granny flat closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Cootamundra-Gundagai Regional?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Cootamundra-Gundagai Regional Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block