Skip to main content

What are Coolamon Council's setbacks for a house, granny flat or duplex?

A setback is how far a home must sit from each boundary of its lot. In Coolamon the setbacks for a house, a granny flat or a duplex come from Coolamon Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.

It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.

Check your address

NSW addresses only. Free, and no sign up.

What are Coolamon Council's setbacks for a house?

Coolamon Council's main plan, Coolamon Shire DCP 2015, Sections 15 and 26, RU5 Village, asks a single storey house for these setbacks: front 8m, side 0.9m and rear 0m.

House setbacks in Coolamon gives the two storey figures, the clauses and every other plan that covers one.

What are Coolamon Council's setbacks for a granny flat?

Coolamon Council's main plan, Coolamon Shire DCP 2015, Sections 15 and 26, RU5 Village, asks a single storey granny flat for these setbacks: front 8m, side 0.9m and rear 0m.

Granny flat setbacks in Coolamon gives the two storey figures, the clauses and every other plan that covers one.

What are Coolamon Council's setbacks for a duplex?

Coolamon Council's main plan, Coolamon Shire DCP 2015, Sections 15 and 26, RU5 Village, asks a single storey duplex for these setbacks: front 8m, side 0.9m and rear 3m.

Duplex setbacks in Coolamon gives the two storey figures, the clauses and every other plan that covers one.

Which DCP covers my block in Coolamon?

It depends on the lot: we hold 4 plans with setbacks for homes in Coolamon Council, and Coolamon Shire DCP 2015, Sections 15 and 26, RU5 Village is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.

Every plan in Coolamon with setbacks for homes
PlanWhere it appliesHomes it covers
Coolamon Shire DCP 2015, Sections 15 and 26, RU5 VillageMain plan. Land zoned RU5 Village under Coolamon LEP 2011: the town of Coolamon and the villages of Ganmain, Ardlethan, Marrar, Matong and Beckom, outside the seven heritage conservation areas.house, granny flat, duplex
Coolamon Shire DCP 2015, Sections 15, 16.7 and 26, RU5 Village in a heritage conservation areaRU5 Village land inside the seven heritage conservation areas of Coolamon LEP 2011 (Schedule 5 Part 2): Ariah Street (C1, Ardlethan), Cowabbie Street (C2, Coolamon), Ford Street, Langham Street and Waterview Street (C3 to C5, Ganmain), Marrar (C6) and Matong Street (C7).house, granny flat, duplex
Coolamon Shire DCP 2015, Sections 15 and 26, R5 Large Lot ResidentialLand zoned R5 Large Lot Residential under Coolamon LEP 2011 (Amendment No 5).house, granny flat, duplex
Coolamon Shire DCP 2015, Section 15, RU1 Primary Production and RU4 Primary Production Small LotsLand zoned RU1 Primary Production or RU4 Primary Production Small Lots under Coolamon LEP 2011.house, granny flat

Do Coolamon Council's setbacks apply to complying development?

No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).

The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

What setbacks apply on a corner block in Coolamon?

Coolamon Shire DCP 2015, Sections 15 and 26, RU5 Village sets a separate setback for a house from the second street, the side street of a corner block: 3m (Section 15.3 Building Setback, RU5: Village, NOTE (corner allotments)). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.

What else do people ask?

Can Coolamon Council approve a smaller setback?

It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

Do Coolamon setbacks apply to sheds, pools and fences?

Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were Coolamon Council's setbacks checked?

We last read Coolamon Council's plans on 12 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block