Skip to main content

How close to the boundary can a house be in Coolamon?

Coolamon Council's main plan, Coolamon Shire DCP 2015, Sections 15 and 26, RU5 Village, asks a single storey house for these setbacks: front 8m, side 0.9m and rear 0m.

In Coolamon the setbacks for a house come from Coolamon Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Coolamon Council's main plan set for a house?

The table gives Coolamon Shire DCP 2015, Sections 15 and 26, RU5 Village's one and two storey figures and the clause each comes from. The plan covers this land: Land zoned RU5 Village under Coolamon LEP 2011: the town of Coolamon and the villages of Ganmain, Ardlethan, Marrar, Matong and Beckom, outside the seven heritage conservation areas.

Coolamon Shire DCP 2015, Sections 15 and 26, RU5 Village: setbacks for a house
SetbackOne storeyTwo storeysWhere in the plan
Front8m8mSection 15.3 Building Setback, RU5: Village
Side0.9m0.9mSection 15.3 Building Setback, RU5: Village
Rear0m0mSection 15.3 Building Setback, RU5: Village
Corner block, second street3m3mSection 15.3 Building Setback, RU5: Village, NOTE (corner allotments)

Which DCP applies to my block in Coolamon?

It depends on where the lot is. Coolamon Shire DCP 2015, Sections 15 and 26, RU5 Village is Coolamon Council's main plan, and 3 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Coolamon that cover a house
PlanWhere it appliesFrontSideRearSecond street
Coolamon Shire DCP 2015, Sections 15, 16.7 and 26, RU5 Village in a heritage conservation areaRU5 Village land inside the seven heritage conservation areas of Coolamon LEP 2011 (Schedule 5 Part 2): Ariah Street (C1, Ardlethan), Cowabbie Street (C2, Coolamon), Ford Street, Langham Street and Waterview Street (C3 to C5, Ganmain), Marrar (C6) and Matong Street (C7).the average of the neighbouring homes (8m where there are none)0.9m0m3m
Coolamon Shire DCP 2015, Sections 15 and 26, R5 Large Lot ResidentialLand zoned R5 Large Lot Residential under Coolamon LEP 2011 (Amendment No 5).20m10m10mnot set
Coolamon Shire DCP 2015, Section 15, RU1 Primary Production and RU4 Primary Production Small LotsLand zoned RU1 Primary Production or RU4 Primary Production Small Lots under Coolamon LEP 2011.20m10m10mnot set

What are the complying development setbacks for a house?

If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a house on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
1,000m² (20m wide, 50m deep)6.5m1.5m (2.1m at two storeys)5m (12m at two storeys)3m

What if my block is on a corner?

Coolamon Shire DCP 2015, Sections 15 and 26, RU5 Village sets a separate setback for a house from the second street, the side street of a corner block: 3m (Section 15.3 Building Setback, RU5: Village, NOTE (corner allotments)). The complying development figure for the second street is in the CDC table above.

Does a two storey house need bigger setbacks?

No. Coolamon Shire DCP 2015, Sections 15 and 26, RU5 Village sets the same figures for a one or two storey house. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Coolamon Council approve a house closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Coolamon?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Coolamon Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block