What are Bega Valley Council's setbacks for a house, granny flat or duplex?
A setback is how far a home must sit from each boundary of its lot. In Bega Valley the setbacks for a house, a granny flat or a duplex come from Bega Valley Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.
It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.
NSW addresses only. Free, and no sign up.
What are Bega Valley Council's setbacks for a house?
Bega Valley Council's main plan, Bega Valley DCP 2013, Chapter 3 Residential Development (Zone R2), asks a single storey house for these setbacks: front no figure on lots up to 349.99m², the average of the neighbouring homes (4.5m where there are none) on lots up to 550m², the average of the neighbouring homes (5m where there are none) on lots up to 900m², the average of the neighbouring homes (6m where there are none) on larger lots; side 0.9m; and rear no figure on lots up to 349.99m², 4m on lots up to 900m², 5m on larger lots.
House setbacks in Bega Valley gives the two storey figures, the clauses and every other plan that covers one.
What are Bega Valley Council's setbacks for a granny flat?
Bega Valley Council's main plan, Bega Valley DCP 2013, Chapter 3 Residential Development (Zone R2), asks a single storey granny flat for these setbacks: front no figure on lots up to 349.99m², the average of the neighbouring homes (4.5m where there are none) on lots up to 550m², the average of the neighbouring homes (5m where there are none) on lots up to 900m², the average of the neighbouring homes (6m where there are none) on larger lots; side 0.9m; and rear no figure on lots up to 349.99m², 4m on lots up to 900m², 5m on larger lots.
Granny flat setbacks in Bega Valley gives the two storey figures, the clauses and every other plan that covers one.
What are Bega Valley Council's setbacks for a duplex?
Bega Valley Council's main plan, Bega Valley DCP 2013, Chapter 3 Residential Development (Zone R2), asks a single storey duplex for these setbacks: front no figure on lots up to 349.99m², the average of the neighbouring homes (4.5m where there are none) on lots up to 550m², the average of the neighbouring homes (5m where there are none) on lots up to 900m², the average of the neighbouring homes (6m where there are none) on larger lots; side 0.9m; and rear no figure on lots up to 349.99m², 4m on lots up to 900m², 5m on larger lots.
Duplex setbacks in Bega Valley gives the two storey figures, the clauses and every other plan that covers one.
Which DCP covers my block in Bega Valley?
It depends on the lot: we hold 10 plans with setbacks for homes in Bega Valley Council, and Bega Valley DCP 2013, Chapter 3 Residential Development (Zone R2) is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.
| Plan | Where it applies | Homes it covers |
|---|---|---|
| Bega Valley DCP 2013, Chapter 3 Residential Development (Zone R2) | Main plan. Land in Zone R2 Low Density Residential under Bega Valley LEP 2013. | house, granny flat, duplex |
| Bega Valley DCP 2013, Chapter 3 Residential Development (Zone RU5) | Land in Zone RU5 Village under Bega Valley LEP 2013. | house, granny flat, duplex |
| Bega Valley DCP 2013, Chapter 3 Residential Development (Zone R3) | Land in Zone R3 Medium Density Residential under Bega Valley LEP 2013. | house, granny flat, duplex |
| Bega Valley DCP 2013, Chapter 4 Rural Development (Zones RU1 and RU2) | Land in Zone RU1 Primary Production and Zone RU2 Rural Landscape under Bega Valley LEP 2013 (Table 4.2, first row). | house, granny flat, duplex |
| Bega Valley DCP 2013, Chapter 4 Rural Development (Zone RU4) | Land in Zone RU4 Primary Production Small Lots under Bega Valley LEP 2013 (Table 4.2, second row). | house, duplex |
| Bega Valley DCP 2013, Chapter 4 Rural Development (Zones R5 and C4) | Land in Zone R5 Large Lot Residential and Zone C4 Environmental Living under Bega Valley LEP 2013 (Table 4.2, second row), other than the Sapphire Coast Turf Club lots (s 7.5). | house, granny flat, duplex |
| Bega Valley DCP 2013, Chapter 4 Rural Development (Zone C3) | Land in Zone C3 Environmental Management under Bega Valley LEP 2013 (Table 4.2, second row). | house, granny flat |
| Bega Valley DCP 2013, s 7.5 Sapphire Coast Turf Club (Kalaru) | Lots 1 to 19, DP 285667, the stabling lots at the Kalaru racecourse (Figure 7.14), zoned R5. | house, granny flat, duplex |
Show 2 more plans
| Plan | Where it applies | Homes it covers |
|---|---|---|
| Bega Valley DCP 2013, s 7.4 Eden Cove | The Eden Cove residential estate, Eden: the land between Komirra Drive and Lake Curalo along KB Timms Drive, Kingfisher Circuit, Marlin Avenue and Trumpeter Avenue, shown on Figure 7.13. | None |
| Bega Valley LEP 2002 deferred matter land | Land shown "Deferred Matter" (DM) on the Bega Valley LEP 2013 zoning map, where Bega Valley LEP 2002 still applies (LEP 2013 cl 1.3(1A)). | None |
Do Bega Valley Council's setbacks apply to complying development?
No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).
The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
What setbacks apply on a corner block in Bega Valley?
Bega Valley DCP 2013, Chapter 3 Residential Development (Zone R2) sets a separate setback for a house from the second street, the side street of a corner block: no figure on lots up to 349.99m², 2m on lots up to 550m², 3m on larger lots (Bega Valley DCP 2013, s 3.2.2.7 Setbacks, Table 3.2). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.
What else do people ask?
Can Bega Valley Council approve a smaller setback?
It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
Do Bega Valley setbacks apply to sheds, pools and fences?
Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were Bega Valley Council's setbacks checked?
We last read Bega Valley Council's plans on 12 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.