How close to the boundary can a house be in Bega Valley?
Bega Valley Council's main plan, Bega Valley DCP 2013, Chapter 3 Residential Development (Zone R2), asks a single storey house for these setbacks: front no figure on lots up to 349.99m², the average of the neighbouring homes (4.5m where there are none) on lots up to 550m², the average of the neighbouring homes (5m where there are none) on lots up to 900m², the average of the neighbouring homes (6m where there are none) on larger lots; side 0.9m; and rear no figure on lots up to 349.99m², 4m on lots up to 900m², 5m on larger lots.
In Bega Valley the setbacks for a house come from Bega Valley Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.
NSW addresses only. Free, and no sign up.
What setbacks does Bega Valley Council's main plan set for a house?
The table gives Bega Valley DCP 2013, Chapter 3 Residential Development (Zone R2)'s one and two storey figures and the clause each comes from. The plan covers this land: Land in Zone R2 Low Density Residential under Bega Valley LEP 2013.
| Setback | One storey | Two storeys | Where in the plan |
|---|---|---|---|
| Front | no figure on lots up to 349.99m², the average of the neighbouring homes (4.5m where there are none) on lots up to 550m², the average of the neighbouring homes (5m where there are none) on lots up to 900m², the average of the neighbouring homes (6m where there are none) on larger lots | no figure on lots up to 349.99m², the average of the neighbouring homes (4.5m where there are none) on lots up to 550m², the average of the neighbouring homes (5m where there are none) on lots up to 900m², the average of the neighbouring homes (6m where there are none) on larger lots | Bega Valley DCP 2013, s 3.2.2.7 Setbacks, Table 3.2 |
| Side | 0.9m | 1.8m for second storey walls | Bega Valley DCP 2013, s 3.2.2.7 Setbacks, Table 3.2 |
| Rear | no figure on lots up to 349.99m², 4m on lots up to 900m², 5m on larger lots | no figure on lots up to 349.99m², 8m for the part of the building with height greater than 4.5m on lots up to 900m², 12m for the part of the building with height greater than 4.5m on larger lots | Bega Valley DCP 2013, s 3.2.2.7 Setbacks, Table 3.2 |
| Corner block, second street | no figure on lots up to 349.99m², 2m on lots up to 550m², 3m on larger lots | no figure on lots up to 349.99m², 2m on lots up to 550m², 3m on larger lots | Bega Valley DCP 2013, s 3.2.2.7 Setbacks, Table 3.2 |
Which DCP applies to my block in Bega Valley?
It depends on where the lot is. Bega Valley DCP 2013, Chapter 3 Residential Development (Zone R2) is Bega Valley Council's main plan, and 7 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Bega Valley DCP 2013, Chapter 3 Residential Development (Zone RU5) | Land in Zone RU5 Village under Bega Valley LEP 2013. | no figure on lots up to 349.99m², the average of the neighbouring homes (4.5m where there are none) on lots up to 550m², the average of the neighbouring homes (5m where there are none) on lots up to 900m², the average of the neighbouring homes (6m where there are none) on larger lots | 2m | no figure on lots up to 349.99m², 4m on lots up to 900m², 5m on larger lots | no figure on lots up to 349.99m², 2m on lots up to 550m², 3m on larger lots |
| Bega Valley DCP 2013, Chapter 3 Residential Development (Zone R3) | Land in Zone R3 Medium Density Residential under Bega Valley LEP 2013. | 6m | 2.5m | 4m | 3m |
| Bega Valley DCP 2013, Chapter 4 Rural Development (Zones RU1 and RU2) | Land in Zone RU1 Primary Production and Zone RU2 Rural Landscape under Bega Valley LEP 2013 (Table 4.2, first row). | the average of the neighbouring homes (20m where there are none) | 20m | 20m | 20m |
| Bega Valley DCP 2013, Chapter 4 Rural Development (Zone RU4) | Land in Zone RU4 Primary Production Small Lots under Bega Valley LEP 2013 (Table 4.2, second row). | the average of the neighbouring homes (20m where there are none) | 10m | 10m | 20m |
| Bega Valley DCP 2013, Chapter 4 Rural Development (Zones R5 and C4) | Land in Zone R5 Large Lot Residential and Zone C4 Environmental Living under Bega Valley LEP 2013 (Table 4.2, second row), other than the Sapphire Coast Turf Club lots (s 7.5). | the average of the neighbouring homes (20m where there are none) | 10m | 10m | 20m |
| Bega Valley DCP 2013, Chapter 4 Rural Development (Zone C3) | Land in Zone C3 Environmental Management under Bega Valley LEP 2013 (Table 4.2, second row). | the average of the neighbouring homes (20m where there are none) | 10m | 10m | 20m |
| Bega Valley DCP 2013, s 7.5 Sapphire Coast Turf Club (Kalaru) | Lots 1 to 19, DP 285667, the stabling lots at the Kalaru racecourse (Figure 7.14), zoned R5. | 5.5m | 3m | 3m | not set |
What are the complying development setbacks for a house?
If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.
| Example lot | Front | Side | Rear | Corner block, second street |
|---|---|---|---|---|
| 450m² (15m wide, 30m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 600m² (15m wide, 40m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 1,000m² (20m wide, 50m deep) | 6.5m | 1.5m (2.1m at two storeys) | 5m (12m at two storeys) | 3m |
What if my block is on a corner?
Bega Valley DCP 2013, Chapter 3 Residential Development (Zone R2) sets a separate setback for a house from the second street, the side street of a corner block: no figure on lots up to 349.99m², 2m on lots up to 550m², 3m on larger lots (Bega Valley DCP 2013, s 3.2.2.7 Setbacks, Table 3.2). The complying development figure for the second street is in the CDC table above.
Does a two storey house need bigger setbacks?
Yes, under Bega Valley DCP 2013, Chapter 3 Residential Development (Zone R2): the side setback goes from 0.9m to 1.8m for second storey walls; the rear setback goes from no figure on lots up to 349.99m², 4m on lots up to 900m², 5m on larger lots to no figure on lots up to 349.99m², 8m for the part of the building with height greater than 4.5m on lots up to 900m², 12m for the part of the building with height greater than 4.5m on larger lots. Under complying development, the two storey figures are in the CDC table above.
What else do people ask?
Can Bega Valley Council approve a house closer to the boundary?
It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.
Do these setbacks apply to a shed, pool or fence in Bega Valley?
No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were the setbacks on this page checked?
We last read Bega Valley Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.