What are Bayside Council's setbacks for a house, granny flat or duplex?
A setback is how far a home must sit from each boundary of its lot. In Bayside the setbacks for a house, a granny flat or a duplex come from Bayside Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.
It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.
NSW addresses only. Free, and no sign up.
What are Bayside Council's setbacks for a house?
Bayside Council's main plan, Bayside DCP 2022, s 5.1.2 and s 5.2.1 (low density residential), asks a single storey house for these setbacks: front the average of the neighbouring homes (6m where there are none), side 0.9m and rear 5m.
House setbacks in Bayside gives the two storey figures, the clauses and every other plan that covers one.
What are Bayside Council's setbacks for a granny flat?
Bayside Council's main plan, Bayside DCP 2022, s 5.1.2 and s 5.2.1 (low density residential), asks a single storey granny flat for these setbacks: front the average of the neighbouring homes (6m where there are none), side 0.9m and rear 0.9m.
Granny flat setbacks in Bayside gives the two storey figures, the clauses and every other plan that covers one.
What are Bayside Council's setbacks for a duplex?
Bayside Council's main plan, Bayside DCP 2022, s 5.1.2 and s 5.2.1 (low density residential), asks a single storey duplex for these setbacks: front the average of the neighbouring homes (6m where there are none), side 0.9m and rear 5m.
Duplex setbacks in Bayside gives the two storey figures, the clauses and every other plan that covers one.
Which DCP covers my block in Bayside?
It depends on the lot: we hold 4 plans with setbacks for homes in Bayside Council, and Bayside DCP 2022, s 5.1.2 and s 5.2.1 (low density residential) is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.
| Plan | Where it applies | Homes it covers |
|---|---|---|
| Bayside DCP 2022, s 5.1.2 and s 5.2.1 (low density residential) | Main plan. Land zoned R2, R3 or R4 in the Bayside LGA outside the Arncliffe sub-precincts of s 7.4 and the Bonar Street Precinct of s 7.5. | house, granny flat, duplex |
| Bayside DCP 2022, s 5.2.1 (dwelling houses in Zone RU4) | Land zoned RU4 Primary Production Small Lots (the heritage listed market gardens). | house |
| Bayside DCP 2022, s 7.4 Arncliffe and Banksia (Arncliffe sub-precincts east of the railway) | R2, R3 and R4 land in the Arncliffe part of the s 7.4 Arncliffe and Banksia precinct (Figure 56: sub-precincts 1 Arncliffe Town Centre, 3 Allen Street Neighbourhood, 4 Cahill Park Neighbourhood and 5 Arncliffe School Neighbourhood, and the Princes Highway Arncliffe special character area), east of the Illawarra railway. | house, granny flat, duplex |
| Bayside DCP 2022, s 7.5 Bonar Street Precinct | R2, R3 and R4 land in the Bonar Street Precinct, Arncliffe (s 7.5, Figure 75: Bonar Street Precinct Land Application Map): the R4 block between Edward Street, Loftus Street, Bonar Street, Martin Avenue and Wollongong Road. | house, granny flat, duplex |
Do Bayside Council's setbacks apply to complying development?
No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).
The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
What setbacks apply on a corner block in Bayside?
Bayside DCP 2022, s 5.1.2 and s 5.2.1 (low density residential) sets a separate setback for a house from the second street, the side street of a corner block: 1.5m (Bayside DCP 2022, s 5.2.1.3 Setbacks, C2). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.
What else do people ask?
Can Bayside Council approve a smaller setback?
It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.
Do Bayside setbacks apply to sheds, pools and fences?
Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were Bayside Council's setbacks checked?
We last read Bayside Council's plans on 12 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.