Skip to main content

What are Armidale Regional Council's setbacks for a house, granny flat or duplex?

A setback is how far a home must sit from each boundary of its lot. In Armidale Regional the setbacks for a house, a granny flat or a duplex come from Armidale Regional Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.

It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.

Check your address

NSW addresses only. Free, and no sign up.

What are Armidale Regional Council's setbacks for a house?

Armidale Regional Council's main plan, Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R1), asks a single storey house for these setbacks: front 4.5m, side 0.9m and rear 0.9m.

House setbacks in Armidale Regional gives the two storey figures, the clauses and every other plan that covers one.

What are Armidale Regional Council's setbacks for a granny flat?

Armidale Regional Council's main plan, Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R1), asks a single storey granny flat for these setbacks: front 4.5m, side 0.9m and rear 0.9m.

Granny flat setbacks in Armidale Regional gives the two storey figures, the clauses and every other plan that covers one.

What are Armidale Regional Council's setbacks for a duplex?

Armidale Regional Council's main plan, Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R1), asks a single storey duplex for these setbacks: front 4.5m, side 0.9m and rear 0.9m.

Duplex setbacks in Armidale Regional gives the two storey figures, the clauses and every other plan that covers one.

Which DCP covers my block in Armidale Regional?

It depends on the lot: we hold 8 plans with setbacks for homes in Armidale Regional Council, and Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R1) is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.

Every plan in Armidale Regional with setbacks for homes
PlanWhere it appliesHomes it covers
Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R1)Main plan. Land in Zone R1 General Residential across the council area (Armidale and Guyra), outside the heritage conservation areas.house, granny flat, duplex
Armidale Regional DCP 2024, Chapter 2.3 European Heritage and Chapter 4.1 (heritage conservation areas, Zone R1)Zone R1 land inside the four LEP heritage conservation areas (Armidale C1, Armidale School C2, Armidale Showground C3, O'Connor Catholic College C4).house, granny flat, duplex
Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R2)Land in Zone R2 Low Density Residential (Armidale only; 282 ha).house, granny flat, duplex
Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R5)Land in Zone R5 Large Lot Residential around Armidale and Guyra.house, granny flat, duplex
Armidale Regional DCP 2024, Chapter 4.3 Development in Rural and Environment Protection Zones (Zone RU5)Land in Zone RU5 Village (the villages; 294 ha).house, granny flat, duplex
Armidale Regional DCP 2024, Chapter 4.3 Development in Rural and Environment Protection Zones (Zone RU4)Land in Zone RU4 Primary Production Small Lots.house, duplex
Armidale Regional DCP 2024, Chapter 4.3 Development in Rural and Environment Protection Zones (Zones C3 and C4)Land in Zone C3 Environmental Management and Zone C4 Environmental Living (the zoning layer returns only C codes here).house, duplex
Armidale Regional DCP 2024, Chapter 4.3 Development in Rural and Environment Protection Zones (Zone RU1)Land in Zone RU1 Primary Production.house, duplex

Do Armidale Regional Council's setbacks apply to complying development?

No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).

The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

What setbacks apply on a corner block in Armidale Regional?

Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R1) sets a separate setback for a house from the second street, the side street of a corner block: 4m (ARDCP 2024, Chapter 4.1 Urban Residential Development, Part 5, s 5.2.2 Corner lot site setbacks in the R1 and R2 zones, S.6). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.

What else do people ask?

Can Armidale Regional Council approve a smaller setback?

It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

Do Armidale Regional setbacks apply to sheds, pools and fences?

Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were Armidale Regional Council's setbacks checked?

We last read Armidale Regional Council's plans on 12 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block