Skip to main content

How close to the boundary can a granny flat be in Armidale Regional?

Armidale Regional Council's main plan, Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R1), asks a single storey granny flat for these setbacks: front 4.5m, side 0.9m and rear 0.9m.

In Armidale Regional the setbacks for a granny flat come from Armidale Regional Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the granny flat first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Armidale Regional Council's main plan set for a granny flat?

The table gives Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R1)'s one and two storey figures and the clause each comes from. The plan covers this land: Land in Zone R1 General Residential across the council area (Armidale and Guyra), outside the heritage conservation areas.

Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R1): setbacks for a granny flat
SetbackOne storeyTwo storeysWhere in the plan
Front4.5m4.5mARDCP 2024, Chapter 4.1 Urban Residential Development, Part 5, s 5.2.1 Front facade setbacks in the R1 and R2 zones, S.2
Side0.9m0.9mARDCP 2024, Chapter 4.1 Urban Residential Development, Part 5, s 5.2.3 Side and rear setbacks in the R1 and R2 zones, S.8
Rear0.9m0.9mARDCP 2024, Chapter 4.1 Urban Residential Development, Part 5, s 5.2.3 Side and rear setbacks in the R1 and R2 zones, S.8
Corner block, second street4m4mARDCP 2024, Chapter 4.1 Urban Residential Development, Part 5, s 5.2.2 Corner lot site setbacks in the R1 and R2 zones, S.6

Which DCP applies to my block in Armidale Regional?

It depends on where the lot is. Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R1) is Armidale Regional Council's main plan, and 4 other plans cover a granny flat on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Armidale Regional that cover a granny flat
PlanWhere it appliesFrontSideRearSecond street
Armidale Regional DCP 2024, Chapter 2.3 European Heritage and Chapter 4.1 (heritage conservation areas, Zone R1)Zone R1 land inside the four LEP heritage conservation areas (Armidale C1, Armidale School C2, Armidale Showground C3, O'Connor Catholic College C4).the average of the neighbouring homes (4.5m where there are none)0.9m0.9m4m
Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R2)Land in Zone R2 Low Density Residential (Armidale only; 282 ha).9m0.9m0.9m4m
Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R5)Land in Zone R5 Large Lot Residential around Armidale and Guyra.20m2.5m on lots up to 3,999.99m²; 10m on larger lots15m5m on lots up to 3,999.99m²; 10m on larger lots
Armidale Regional DCP 2024, Chapter 4.3 Development in Rural and Environment Protection Zones (Zone RU5)Land in Zone RU5 Village (the villages; 294 ha).4.5m10m15m4.5m

What are the complying development setbacks for a granny flat?

If you build a granny flat with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a granny flat on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m2m
1,000m² (20m wide, 50m deep)6.5m1.5m5m3m

What if my block is on a corner?

Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R1) sets a separate setback for a granny flat from the second street, the side street of a corner block: 4m (ARDCP 2024, Chapter 4.1 Urban Residential Development, Part 5, s 5.2.2 Corner lot site setbacks in the R1 and R2 zones, S.6). The complying development figure for the second street is in the CDC table above.

Does a two storey granny flat need bigger setbacks?

No. Armidale Regional DCP 2024, Chapter 4.1 Urban Residential Development (Zone R1) sets the same figures for a one or two storey granny flat. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Armidale Regional Council approve a granny flat closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Armidale Regional?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Armidale Regional Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block