Skip to main content

What are Albury City Council's setbacks for a house, granny flat or duplex?

A setback is how far a home must sit from each boundary of its lot. In Albury City the setbacks for a house, a granny flat or a duplex come from Albury City Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.

It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.

Check your address

NSW addresses only. Free, and no sign up.

What are Albury City Council's setbacks for a house?

Albury City Council's main plan, Albury DCP 2010, Part 10, Divisions D and E (Zones R1, R3, E1 and MU1), asks a single storey house for these setbacks: front the average of the neighbouring homes (4m where there are none), side 0.9m and rear 2m.

House setbacks in Albury City gives the two storey figures, the clauses and every other plan that covers one.

What are Albury City Council's setbacks for a granny flat?

Albury City Council's main plan, Albury DCP 2010, Part 10, Divisions D and E (Zones R1, R3, E1 and MU1), asks a single storey granny flat for these setbacks: front the average of the neighbouring homes (4m where there are none), side 0.9m and rear 2m.

Granny flat setbacks in Albury City gives the two storey figures, the clauses and every other plan that covers one.

What are Albury City Council's setbacks for a duplex?

Albury City Council's main plan, Albury DCP 2010, Part 10, Divisions D and E (Zones R1, R3, E1 and MU1), asks a single storey duplex for these setbacks: front the average of the neighbouring homes (4m where there are none), side 0.9m and rear 2m.

Duplex setbacks in Albury City gives the two storey figures, the clauses and every other plan that covers one.

Which DCP covers my block in Albury City?

It depends on the lot: we hold 17 plans with setbacks for homes in Albury City Council, and Albury DCP 2010, Part 10, Divisions D and E (Zones R1, R3, E1 and MU1) is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.

Every plan in Albury City with setbacks for homes
PlanWhere it appliesHomes it covers
Albury DCP 2010, Part 10, Divisions D and E (Zones R1, R3, E1 and MU1)Main plan. Land in Zones R1 General Residential, R3 Medium Density Residential, E1 Local Centre and MU1 Mixed Use (formerly B1, B2 and B4): the main suburbs of Albury, Lavington, Thurgoona and Hamilton Valley.house, granny flat, duplex
Albury DCP 2010, Part 10, Division C (Zone R2 Low Density Residential)Land in Zone R2 Low Density Residential (Albury's R2 is semi-rural: Splitters Creek fringe, Thurgoona and Ettamogah Rise).house, granny flat, duplex
Albury DCP 2010, Part 10, Division C (Zone R5 Large Lot Residential)Land in Zone R5 Large Lot Residential outside Hamilton Valley.house, granny flat
Albury DCP 2010, Part 9, Development in the Rural Zones (Zones RU1, RU4 and RU5)Land in Zones RU1 Primary Production, RU4 Primary Production Small Lots and RU5 Village (Table Top and Lake Hume villages).house, granny flat, duplex
Albury DCP 2010, Part 9, Development in the Rural Zones (Zone RU2 Rural Landscape)Land in Zone RU2 Rural Landscape, except the South Albury floodplain land in Figure 9.3 where the DCP does not permit dwellings.house, granny flat, duplex
Albury DCP 2010, Part 9, s 9.5.3 Special Development Restrictions in South Albury (Figure 9.3)RU2 land on the Murray River floodplain in South Albury (Figure 9.3).None
Albury DCP 2010, Part 8, Development in the Environmental Zones (Zones C3 and C4)Land in Zones C3 Environmental Management and C4 Environmental Living (the E3 and E4 of Part 8 s 8.1; in the current Albury zoning E3 is Productivity Support and E4 General Industrial, so the zones test lists C3 and C4 only) outside the Doctors Point and Padman Drive Residential Precincts.house, duplex
Albury DCP 2010, Part 8, s 8.4.2 and s 8.7 Doctor's Point Development Plan (Figure 8.2)The Doctors Point Residential Precinct: C4 land off Doctors Point Road and Sunset View Road, east of Albury (Figure 8.2).house, duplex
Show 9 more plans
Every plan in Albury City with setbacks for homes, continued
PlanWhere it appliesHomes it covers
Albury DCP 2010, Part 8, s 8.4.2 (Padman Drive Residential Precinct)The Padman Drive Residential Precinct, West Albury: the seven C4 lots on the south side of Padman Drive.house, duplex
Albury DCP 2010, Appendix F Hamilton Valley Design Guidelines (Standard Lots, Zone R1)R1 land in the suburb of Hamilton Valley (Figure 1.1 Lot Distribution and Framework Plan): the Standard Lots, and R1 lots over 1,150 m2, which Table 1.1 makes Rural Edge Lots (area tiers).house, granny flat, duplex
Albury DCP 2010, Appendix F Hamilton Valley Design Guidelines (Rural Edge Lots, Zone R5)R5 land in the suburb of Hamilton Valley (Figure 1.1): the Rural Edge Lots with 4,000 m2 and 10,000 m2 minimums.house, granny flat
Albury DCP 2010, Appendix F Hamilton Valley Design Guidelines (Town Lots, Zone E1)The Hamilton Valley neighbourhood centre: E1 Local Centre land in the suburb of Hamilton Valley (three lots, 5.5 ha, at the Hamilton Valley Road roundabout).house, granny flat, duplex
Albury DCP 2010, Appendix F Hamilton Valley Design Guidelines (Village Lots)Village Lots in Hamilton Valley: medium density townhouse lots "Sited only directly adjoining a neighbourhood focal point" (Figure 1.1), usually 200 to 350 m2 with a rear service lane.house, granny flat, duplex
Albury DCP 2010, Appendix N Charles Sturt University: Albury CBD Development Control Plan 2010The former Charles Sturt University Albury CBD campus between Guinea, Olive, Wilson and David Streets (R1), less Adamshurst and the corner lots the plan leaves out.house, granny flat, duplex
Albury DCP 2010, Appendix N Charles Sturt University: Albury CBD Development Control Plan 2010 (Urban Residential precinct)The Urban Residential precinct of the former CSU Albury CBD campus (Figure A1.3 Precinct Character: the crescent of attached town houses around Adamshurst).house, granny flat, duplex
Albury DCP 2010, Part 10, Division I, Racecourse Estate Development Plan (Figure 2. a. i)Racecourse Estate, Lavington: the horse estate between Union Road, the Hume Freeway, Dallinger Road and the Albury Racecourse (Figure 2.house, granny flat, duplex
Albury DCP 2010, Part 10, Division I, Easternview Estate Development Plan (Figure 2. a. ii)The Easternview Estate lots with building envelopes (figure lots 1 to 26) on Grandview Terrace, Palm Drive and Ronald Place, East Albury.None

Do Albury City Council's setbacks apply to complying development?

No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).

The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

What setbacks apply on a corner block in Albury City?

Albury DCP 2010, Part 10, Divisions D and E (Zones R1, R3, E1 and MU1) sets a separate setback for a house from the second street, the side street of a corner block: the average of the neighbouring homes (2m where there are none) (Albury DCP 2010, Part 10, Division D, cl 2, Development Guidelines Table, c. iii Min. secondary street setback on a corner lot). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.

What else do people ask?

Can Albury City Council approve a smaller setback?

It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

Do Albury City setbacks apply to sheds, pools and fences?

Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were Albury City Council's setbacks checked?

We last read Albury City Council's plans on 12 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block