Skip to main content

What are Walcha Council's setbacks for a house, granny flat or duplex?

A setback is how far a home must sit from each boundary of its lot. In Walcha the setbacks for a house, a granny flat or a duplex come from Walcha Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.

It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.

Check your address

NSW addresses only. Free, and no sign up.

What are Walcha Council's setbacks for a house?

Walcha Council's main plan, Walcha DCP 2019, Chapter 3 Residential Development: R1 General Residential, asks a single storey house for these setbacks: front the average of the neighbouring homes (6m where there are none), side 0.9m and rear 0.9m.

House setbacks in Walcha gives the two storey figures, the clauses and every other plan that covers one.

What are Walcha Council's setbacks for a granny flat?

Walcha Council's main plan, Walcha DCP 2019, Chapter 3 Residential Development: R1 General Residential, asks a single storey granny flat for these setbacks: front the average of the neighbouring homes (6m where there are none), side 0.9m and rear 0.9m.

Granny flat setbacks in Walcha gives the two storey figures, the clauses and every other plan that covers one.

What are Walcha Council's setbacks for a duplex?

Walcha Council's main plan, Walcha DCP 2019, Chapter 3 Residential Development: R1 General Residential, asks a single storey duplex for these setbacks: front the average of the neighbouring homes (6m where there are none), side 0.9m and rear 0.9m.

Duplex setbacks in Walcha gives the two storey figures, the clauses and every other plan that covers one.

Which DCP covers my block in Walcha?

It depends on the lot: we hold 7 plans with setbacks for homes in Walcha Council, and Walcha DCP 2019, Chapter 3 Residential Development: R1 General Residential is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.

Every plan in Walcha with setbacks for homes
PlanWhere it appliesHomes it covers
Walcha DCP 2019, Chapter 3 Residential Development: R1 General ResidentialMain plan. Land zoned R1 General Residential (the town of Walcha).house, granny flat, duplex
Walcha DCP 2019, Chapter 3 Residential Development: RU5 VillageLand zoned RU5 Village (the villages, including Walcha Road, Woolbrook and Nowendoc).house, granny flat, duplex
Walcha DCP 2019, Chapter 3 Residential Development: R5 Large Lot ResidentialLand zoned R5 Large Lot Residential (around Walcha and Nowendoc).house, granny flat, duplex
Walcha DCP 2019, Chapter 3 Residential Development: C4 Environmental LivingLand zoned C4 Environmental Living (E4 in the DCP) at Walcha.house, duplex
Walcha DCP 2019, Chapter 4 Rural Development: RU1 and RU4Land zoned RU1 Primary Production and RU4 Primary Production Small Lots.house, duplex
Walcha DCP 2019, Chapter 7 Commercial and Industrial Areas: E1 Local CentreLand zoned E1 Local Centre (B2 in the DCP), the Walcha town centre.house
Walcha DCP 2019, Chapter 7 Commercial and Industrial Areas: MU1 Mixed UseLand zoned MU1 Mixed Use (B4 in the DCP) at Walcha.house, granny flat

Do Walcha Council's setbacks apply to complying development?

No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).

The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

What setbacks apply on a corner block in Walcha?

Walcha DCP 2019, Chapter 3 Residential Development: R1 General Residential sets a separate setback for a house from the second street, the side street of a corner block: 3m (Ch 3, s 3.5, Table 3.2 Minimum Setbacks, R1 / RU5 Dwelling / Dual Occupancy row, Street). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.

What else do people ask?

Can Walcha Council approve a smaller setback?

It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

Do Walcha setbacks apply to sheds, pools and fences?

Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were Walcha Council's setbacks checked?

We last read Walcha Council's plans on 12 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block