Skip to main content

What are Lane Cove Council's setbacks for a house, granny flat or duplex?

A setback is how far a home must sit from each boundary of its lot. In Lane Cove the setbacks for a house, a granny flat or a duplex come from Lane Cove Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.

It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.

Check your address

NSW addresses only. Free, and no sign up.

What are Lane Cove Council's setbacks for a house?

Lane Cove Council's main plan, Lane Cove DCP, Part C, C.1 Dwelling Houses and Dual Occupancies (R2), asks a single storey house for these setbacks: front the average of the neighbouring homes (7.5m where there are none); side 1.2m; and rear 25% of the lot depth, and at least 8m on lots up to 1,000m²; 35% of the lot depth, and at least 10m on larger lots.

House setbacks in Lane Cove gives the two storey figures, the clauses and every other plan that covers one.

What are Lane Cove Council's setbacks for a granny flat?

Lane Cove Council's main plan, Lane Cove DCP, Part C, C.1 Dwelling Houses and Dual Occupancies (R2), names a granny flat but sets no front, side or rear setback for one, so a development application is assessed on its merits. Ask the council what it expects.

Granny flat setbacks in Lane Cove gives the complying development figures and every other plan that covers one.

What are Lane Cove Council's setbacks for a duplex?

Lane Cove Council's main plan, Lane Cove DCP, Part C, C.1 Dwelling Houses and Dual Occupancies (R2), asks a single storey duplex for these setbacks: front the average of the neighbouring homes (7.5m where there are none), side 1.2m and rear 6m.

Duplex setbacks in Lane Cove gives the two storey figures, the clauses and every other plan that covers one.

Which DCP covers my block in Lane Cove?

It depends on the lot: we hold 3 plans with setbacks for homes in Lane Cove Council, and Lane Cove DCP, Part C, C.1 Dwelling Houses and Dual Occupancies (R2) is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.

Every plan in Lane Cove with setbacks for homes
PlanWhere it appliesHomes it covers
Lane Cove DCP, Part C, C.1 Dwelling Houses and Dual Occupancies (R2)Main plan. Zone R2 Low Density Residential land in Lane Cove, outside the Greenwich Heritage Conservation Area.house, granny flat, duplex
Lane Cove DCP, Part C, C.1 Dwelling Houses and Dual Occupancies (C4 Environmental Living)Zone C4 Environmental Living land (two areas, about 3.5 ha, around 151.155 E, 33.806 S on the Planning Portal zoning layer).house, duplex
Lane Cove DCP, Part C Residential Localities, Locality 4 Greenwich Heritage Conservation Area (with C.1)R2 land inside the Greenwich Heritage Conservation Area (Lane Cove LEP 2009 heritage item C1, "Greenwich Conservation Area, Greenwich"), at the southern end of the Greenwich peninsula.house, granny flat, duplex

Do Lane Cove Council's setbacks apply to complying development?

No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).

The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

What setbacks apply on a corner block in Lane Cove?

Lane Cove DCP, Part C, C.1 Dwelling Houses and Dual Occupancies (R2) sets a separate setback for a house from the second street, the side street of a corner block: 2m (Lane Cove DCP, Part C Residential Development, C.1 Dwelling Houses and Dual Occupancies, s 1.3.1 Front setbacks, provision b)). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.

What else do people ask?

Can Lane Cove Council approve a smaller setback?

It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

Do Lane Cove setbacks apply to sheds, pools and fences?

Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were Lane Cove Council's setbacks checked?

We last read Lane Cove Council's plans on 12 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block