Skip to main content

How close to the boundary can a duplex be in Liverpool Plains?

Liverpool Plains Council's main plan, Liverpool Plains DCP 2012, s 3.1 and 3.2 (R1 General Residential), asks a single storey duplex for these setbacks: front 4.5m, side 1m and rear 1m.

In Liverpool Plains the setbacks for a duplex come from Liverpool Plains Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the duplex first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Liverpool Plains Council's main plan set for a duplex?

The table gives Liverpool Plains DCP 2012, s 3.1 and 3.2 (R1 General Residential)'s one and two storey figures and the clause each comes from. The plan covers this land: Land zoned R1 General Residential (Quirindi and Werris Creek), outside the Quirindi North Residential Area.

Liverpool Plains DCP 2012, s 3.1 and 3.2 (R1 General Residential): setbacks for a duplex
SetbackOne storeyTwo storeysWhere in the plan
Front4.5m4.5mLiverpool Plains DCP 2012, s 3.2.1 Building Setbacks (Residential Dual Occupancy), table, row R1 (General Residential)
Side1m2mLiverpool Plains DCP 2012, s 3.2.1 Building Setbacks (Residential Dual Occupancy), table, row R1 (General Residential)
Rear1m2mLiverpool Plains DCP 2012, s 3.2.1 Building Setbacks (Residential Dual Occupancy), table, row R1 (General Residential)
Corner block, second street4.5m4.5mLiverpool Plains DCP 2012, s 3.2.1 Building Setbacks (Residential Dual Occupancy), table, row R1, and the bullet below the table

Which DCP applies to my block in Liverpool Plains?

It depends on where the lot is. Liverpool Plains DCP 2012, s 3.1 and 3.2 (R1 General Residential) is Liverpool Plains Council's main plan, and 9 other plans cover a duplex on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Liverpool Plains that cover a duplex
PlanWhere it appliesFrontSideRearSecond street
Liverpool Plains DCP 2012, s 3.1 and 3.2 (RU5 Village)Land zoned RU5 Village (Willow Tree, Wallabadah, Currabubula, Spring Ridge, Caroona, Blackville, Premer and a small RU5 area at Braefield, south of Quirindi).6m3m3m6m
Liverpool Plains DCP 2012, s 3.1 and 3.2 (RU1 Primary Production)Land zoned RU1 Primary Production (almost all of the shire).not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
Liverpool Plains DCP 2012, s 3.1 and 3.2 (R5, Lot Size Map under 2 ha)R5 Large Lot Residential land whose Lot Size Map minimum is under 2 ha (4,000, 5,000 or 8,000 m2, 1 ha or 1.5 ha): about 590 ha. Note 1 to s 3.1.1 picks the row by the LEP minimum, not the lot's own area.15m10m10m15m
Liverpool Plains DCP 2012, s 3.1 and 3.2 (R5, Lot Size Map 2 ha)R5 Large Lot Residential land whose Lot Size Map minimum is exactly 2 ha, outside the Quirindi North Residential Area: about 112 ha (250.6 ha in all, 138.7 ha of it in the QNRA).15m10m10m15m
Liverpool Plains DCP 2012, s 3.1 and 3.2 (R5, Lot Size Map over 2 ha)R5 Large Lot Residential land whose Lot Size Map minimum is over 2 ha (2.5, 5, 7, 10, 20, 40 or 200 ha): about 1,818 ha, mostly the 40 ha land south of Quirindi and north of the QNRA.15m10m10m15m
Liverpool Plains DCP 2012, s 4.3 Quirindi North Residential Area (R5)R5 land in the Quirindi North Residential Area (Werris Creek Road, Bradys Lane, Bells Gate Road), as the s 4.3 Structure Plan shows: s 3 figures (Lot Size Map 2 ha, so no house street frontage) with the s 4.3 controls added.15m10m10m15m
Liverpool Plains DCP 2012, s 4.3 Quirindi North Residential Area (C4)C4 Environmental Living land in the Quirindi North Residential Area (the s 4.3 "E4 zone"): s 4.3.9 sets setbacks by vegetation, with no figure.not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
Liverpool Plains DCP 2012, s 4.3 Quirindi North Residential Area (R1)R1 land inside the Quirindi North Residential Area outline (7.7 ha at its south end, beside Quirindi, part of 12//DP878120 whose point is in C4, so no current lot matches it; kept for when that land is subdivided): the R1 figures with the s 4.3 controls added.4.5m1m1m4.5m
Show 1 more plan
Other plans in Liverpool Plains that cover a duplex, continued
PlanWhere it appliesFrontSideRearSecond street
Liverpool Plains DCP 2012 (C3 and C4, no setback figures)Land zoned C3 Environmental Management or C4 Environmental Living outside the Quirindi North Residential Area.not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set

What are the complying development setbacks for a duplex?

If you build a duplex with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a duplex on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
1,000m² (20m wide, 50m deep)6.5m0.9m (1.5m at two storeys)5m (12m at two storeys)3m

What if my block is on a corner?

Liverpool Plains DCP 2012, s 3.1 and 3.2 (R1 General Residential) sets a separate setback for a duplex from the second street, the side street of a corner block: 4.5m (Liverpool Plains DCP 2012, s 3.2.1 Building Setbacks (Residential Dual Occupancy), table, row R1, and the bullet below the table). The complying development figure for the second street is in the CDC table above.

Does a two storey duplex need bigger setbacks?

Yes, under Liverpool Plains DCP 2012, s 3.1 and 3.2 (R1 General Residential): the side setback goes from 1m to 2m; the rear setback goes from 1m to 2m. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Liverpool Plains Council approve a duplex closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Liverpool Plains?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Liverpool Plains Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block