Skip to main content

How close to the boundary can a duplex be in Inverell?

Inverell Council's main plan, Inverell DCP 2013, Chapter 3 (Zone R1 General Residential), asks a single storey duplex for these setbacks: front the average of the neighbouring homes (4.5m where there are none), side left to the Building Code (0.9m) and rear left to the Building Code (0.9m).

In Inverell the setbacks for a duplex come from Inverell Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the duplex first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Inverell Council's main plan set for a duplex?

The table gives Inverell DCP 2013, Chapter 3 (Zone R1 General Residential)'s one and two storey figures and the clause each comes from. The plan covers this land: Land zoned R1 General Residential under Inverell LEP 2012 (Inverell town, 836 ha).

Inverell DCP 2013, Chapter 3 (Zone R1 General Residential): setbacks for a duplex
SetbackOne storeyTwo storeysWhere in the plan
Frontthe average of the neighbouring homes (4.5m where there are none)the average of the neighbouring homes (4.5m where there are none)Inverell DCP 2013, Chapter 3, s 3.8 Setbacks, Acceptable Solution, table; s 3.8 Acceptable Solution, first dot point
Sideleft to the Building Code (0.9m)left to the Building Code (0.9m)Inverell DCP 2013, Chapter 3, s 3.8 Setbacks, Acceptable Solution, table
Rearleft to the Building Code (0.9m)left to the Building Code (0.9m)Inverell DCP 2013, Chapter 3, s 3.8 Setbacks, Acceptable Solution, table

Which DCP applies to my block in Inverell?

It depends on where the lot is. Inverell DCP 2013, Chapter 3 (Zone R1 General Residential) is Inverell Council's main plan, and 7 other plans cover a duplex on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Inverell that cover a duplex
PlanWhere it appliesFrontSideRearSecond street
Inverell DCP 2013, Chapter 3 (Zone RU5 Village)Land zoned RU5 Village under Inverell LEP 2012 (708 ha: Ashford, Yetman, Bonshaw, Delungra, Gilgai, Graman, Mount Russell, Little Plain, Gum Flat, Oakwood, Bukkulla, Nullamanna, Wandera, Elsmore and Danthonia).the average of the neighbouring homes (6m where there are none)left to the Building Code (0.9m)left to the Building Code (0.9m)not set
Inverell DCP 2013, Chapter 3 (Zone R5 Large Lot Residential)Land zoned R5 Large Lot Residential under Inverell LEP 2012 (4,919 ha around Inverell and Gilgai).15m4m4mnot set
Inverell DCP 2013, Chapter 3 (Zone RU1 Primary Production)Land zoned RU1 Primary Production under Inverell LEP 2012 (about 777,700 ha).20m10m10mnot set
Inverell DCP 2013, Chapter 3 (Zone C4 Environmental Living)Land zoned C4 Environmental Living under Inverell LEP 2012 (12.6 ha at Inverell, the DCP's "E4" row).not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
Inverell DCP 2013, Chapters 3 and 7 (heritage conservation areas, Zone R1)R1 land in the Ross Hill and Belgravia heritage conservation areas (Inverell LEP 2012 heritage map; DCP Figures 7.2 and 7.3).at least 4.5m, or the street's established building line where that is further backthe average of the neighbouring homes (left to the Building Code (0.9m) where there are none)left to the Building Code (0.9m)not set
Inverell DCP 2013, Chapters 3 and 7 (Ashford Town Centre conservation area, Zone RU5)RU5 land in the Ashford Town Centre heritage conservation area (4.1 ha; DCP Figure 7.5).at least 6m, or the street's established building line where that is further backthe average of the neighbouring homes (left to the Building Code (0.9m) where there are none)left to the Building Code (0.9m)not set
Guyra DCP 2015, Chapter 3 (former Guyra Shire land, Zone RU5 Village: Tingha)RU5 Village land under Guyra LEP 2012 in Inverell Shire (the village of Tingha, 193.6 ha), the former Guyra Shire land transferred to Inverell in July 2019.the average of the neighbouring homes (4m where there are none)0.9m, plus 0.5m for every metre of wall above 3.5m2.4m, plus 0.5m for every metre of wall above 3.5mnot set

What are the complying development setbacks for a duplex?

If you build a duplex with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a duplex on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
1,000m² (20m wide, 50m deep)6.5m0.9m (1.5m at two storeys)5m (12m at two storeys)3m

What if my block is on a corner?

Inverell DCP 2013, Chapter 3 (Zone R1 General Residential) sets no separate setback for the second street of a corner block for a duplex, so ask the council how it treats one. The complying development figure for the second street is in the CDC table above.

Does a two storey duplex need bigger setbacks?

No. Inverell DCP 2013, Chapter 3 (Zone R1 General Residential) sets the same figures for a one or two storey duplex. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Inverell Council approve a duplex closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Inverell?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Inverell Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block