How close to the boundary can a house be in Inverell?
Inverell Council's main plan, Inverell DCP 2013, Chapter 3 (Zone R1 General Residential), asks a single storey house for these setbacks: front the average of the neighbouring homes (4.5m where there are none), side left to the Building Code (0.9m) and rear left to the Building Code (0.9m).
In Inverell the setbacks for a house come from Inverell Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.
NSW addresses only. Free, and no sign up.
What setbacks does Inverell Council's main plan set for a house?
The table gives Inverell DCP 2013, Chapter 3 (Zone R1 General Residential)'s one and two storey figures and the clause each comes from. The plan covers this land: Land zoned R1 General Residential under Inverell LEP 2012 (Inverell town, 836 ha).
| Setback | One storey | Two storeys | Where in the plan |
|---|---|---|---|
| Front | the average of the neighbouring homes (4.5m where there are none) | the average of the neighbouring homes (4.5m where there are none) | Inverell DCP 2013, Chapter 3, s 3.8 Setbacks, Acceptable Solution, table; s 3.8 Acceptable Solution, first dot point |
| Side | left to the Building Code (0.9m) | left to the Building Code (0.9m) | Inverell DCP 2013, Chapter 3, s 3.8 Setbacks, Acceptable Solution, table |
| Rear | left to the Building Code (0.9m) | left to the Building Code (0.9m) | Inverell DCP 2013, Chapter 3, s 3.8 Setbacks, Acceptable Solution, table |
Which DCP applies to my block in Inverell?
It depends on where the lot is. Inverell DCP 2013, Chapter 3 (Zone R1 General Residential) is Inverell Council's main plan, and 8 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Inverell DCP 2013, Chapter 3 (Zone RU5 Village) | Land zoned RU5 Village under Inverell LEP 2012 (708 ha: Ashford, Yetman, Bonshaw, Delungra, Gilgai, Graman, Mount Russell, Little Plain, Gum Flat, Oakwood, Bukkulla, Nullamanna, Wandera, Elsmore and Danthonia). | the average of the neighbouring homes (6m where there are none) | left to the Building Code (0.9m) | left to the Building Code (0.9m) | not set |
| Inverell DCP 2013, Chapter 3 (Zone R5 Large Lot Residential) | Land zoned R5 Large Lot Residential under Inverell LEP 2012 (4,919 ha around Inverell and Gilgai). | 15m | 4m | 4m | not set |
| Inverell DCP 2013, Chapter 3 (Zone RU1 Primary Production) | Land zoned RU1 Primary Production under Inverell LEP 2012 (about 777,700 ha). | 20m | 10m | 10m | not set |
| Inverell DCP 2013, Chapter 3 (Zone C3 Environmental Management) | Land zoned C3 Environmental Management under Inverell LEP 2012 (5,625 ha, the DCP's "E3" row). | 20m | 10m | 10m | not set |
| Inverell DCP 2013, Chapter 3 (Zone C4 Environmental Living) | Land zoned C4 Environmental Living under Inverell LEP 2012 (12.6 ha at Inverell, the DCP's "E4" row). | not set by the DCP: ask the council | not set by the DCP: ask the council | not set by the DCP: ask the council | not set |
| Inverell DCP 2013, Chapters 3 and 7 (heritage conservation areas, Zone R1) | R1 land in the Ross Hill and Belgravia heritage conservation areas (Inverell LEP 2012 heritage map; DCP Figures 7.2 and 7.3). | at least 4.5m, or the street's established building line where that is further back | the average of the neighbouring homes (left to the Building Code (0.9m) where there are none) | left to the Building Code (0.9m) | not set |
| Inverell DCP 2013, Chapters 3 and 7 (Ashford Town Centre conservation area, Zone RU5) | RU5 land in the Ashford Town Centre heritage conservation area (4.1 ha; DCP Figure 7.5). | at least 6m, or the street's established building line where that is further back | the average of the neighbouring homes (left to the Building Code (0.9m) where there are none) | left to the Building Code (0.9m) | not set |
| Guyra DCP 2015, Chapter 3 (former Guyra Shire land, Zone RU5 Village: Tingha) | RU5 Village land under Guyra LEP 2012 in Inverell Shire (the village of Tingha, 193.6 ha), the former Guyra Shire land transferred to Inverell in July 2019. | the average of the neighbouring homes (4m where there are none) | 0.9m, plus 0.5m for every metre of wall above 3.5m | 2.4m, plus 0.5m for every metre of wall above 3.5m | not set |
What are the complying development setbacks for a house?
If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.
| Example lot | Front | Side | Rear | Corner block, second street |
|---|---|---|---|---|
| 450m² (15m wide, 30m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 600m² (15m wide, 40m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 1,000m² (20m wide, 50m deep) | 6.5m | 1.5m (2.1m at two storeys) | 5m (12m at two storeys) | 3m |
What if my block is on a corner?
Inverell DCP 2013, Chapter 3 (Zone R1 General Residential) sets no separate setback for the second street of a corner block for a house, so ask the council how it treats one. The complying development figure for the second street is in the CDC table above.
Does a two storey house need bigger setbacks?
No. Inverell DCP 2013, Chapter 3 (Zone R1 General Residential) sets the same figures for a one or two storey house. Under complying development, the two storey figures are in the CDC table above.
What else do people ask?
Can Inverell Council approve a house closer to the boundary?
It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.
Do these setbacks apply to a shed, pool or fence in Inverell?
No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were the setbacks on this page checked?
We last read Inverell Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.