Skip to main content

What are Cobar Council's setbacks for a house, granny flat or duplex?

A setback is how far a home must sit from each boundary of its lot. Cobar Council has no development control plan (DCP), the council's own rules for the design of homes, so its setbacks for a house, a granny flat or a duplex are not written down: a development application is assessed on its merits. Complying development follows state rules instead. This page reads what we hold for each of the three.

It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.

Check your address

NSW addresses only. Free, and no sign up.

What are Cobar Council's setbacks for a house?

Cobar Council has no development control plan (DCP), so no council setbacks are written down for a house: a development application is assessed on its merits. Ask the council what it expects.

House setbacks in Cobar gives the complying development figures and every other plan that covers one.

What are Cobar Council's setbacks for a granny flat?

Cobar Council has no development control plan (DCP), so no council setbacks are written down for a granny flat: a development application is assessed on its merits. Ask the council what it expects.

Granny flat setbacks in Cobar gives the complying development figures and every other plan that covers one.

What are Cobar Council's setbacks for a duplex?

Cobar Council has no development control plan (DCP), so no council setbacks are written down for a duplex: a development application is assessed on its merits. Ask the council what it expects.

Duplex setbacks in Cobar gives the complying development figures and every other plan that covers one.

Which DCP covers my block in Cobar?

None: Cobar Council has no development control plan (DCP), so no plan sets setbacks for any of its zones. A development application is assessed on its merits, so ask the council what it expects. The table lists the zones we hold and the homes each permits.

Every plan in Cobar with setbacks for homes
PlanWhere it appliesHomes it covers
Cobar Shire: no DCP (R2 Low Density Residential)Main plan. Land zoned R2 Low Density Residential: most of Cobar township's housing (about 340 ha).house, granny flat, duplex
Cobar Shire: no DCP (R1 General Residential)Land zoned R1 General Residential: about 29 ha in Cobar township, west of the town centre.house, granny flat, duplex
Cobar Shire: no DCP (R5 Large Lot Residential)Land zoned R5 Large Lot Residential: two areas at Cobar, about 700 ha south of the town and 14 ha on its north-west edge.house, granny flat, duplex
Cobar Shire: no DCP (RU5 Village)Land zoned RU5 Village: the villages of Nymagee, Mount Hope, Euabalong and Euabalong West.house, granny flat, duplex
Cobar Shire: no DCP (RU1 Primary Production)Land zoned RU1 Primary Production: the rural land of the shire.house, duplex
Cobar Shire: no DCP (E1 Local Centre)Land zoned E1 Local Centre: Cobar's town centre (about 30 ha in two areas).duplex
Cobar Shire: no DCP (C3 Environmental Management)Land zoned C3 Environmental Management: one area of about 5,190 ha centred north-west of Cobar town.house

Do Cobar Council's setbacks apply to complying development?

No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).

The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

What setbacks apply on a corner block in Cobar?

Cobar Shire: no DCP (R2 Low Density Residential) sets no separate setback for the second street of a corner block for a house, so ask the council how it treats one. Under complying development the code sets one by lot size.

What else do people ask?

Can Cobar Council approve a smaller setback?

It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

Do Cobar setbacks apply to sheds, pools and fences?

Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were Cobar Council's setbacks checked?

We last read Cobar Council's plans on 12 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block