Skip to main content

What are Central Coast Council's setbacks for a house, granny flat or duplex?

A setback is how far a home must sit from each boundary of its lot. In Central Coast the setbacks for a house, a granny flat or a duplex come from Central Coast Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page reads what we hold for each of the three.

It is a first look. Enter your address and the Site Checker opens at the setbacks for your lot, from the plan that covers it.

Check your address

NSW addresses only. Free, and no sign up.

What are Central Coast Council's setbacks for a house?

Central Coast Council's main plan, Central Coast DCP 2022, Chapters 2.1 and 2.2 (residential lots), asks a single storey house for these setbacks: front 3m on lots up to 300m², the average of the neighbouring homes (4.5m where there are none) on larger lots; side 0.9m, plus 0.25m for every metre of wall above 4.5m; and rear 3m.

House setbacks in Central Coast gives the two storey figures, the clauses and every other plan that covers one.

What are Central Coast Council's setbacks for a granny flat?

Central Coast Council's main plan, Central Coast DCP 2022, Chapters 2.1 and 2.2 (residential lots), asks a single storey granny flat for these setbacks: front 3m on lots up to 300m², the average of the neighbouring homes (4.5m where there are none) on larger lots; side 0.9m, plus 0.25m for every metre of wall above 4.5m; and rear 3m.

Granny flat setbacks in Central Coast gives the two storey figures, the clauses and every other plan that covers one.

What are Central Coast Council's setbacks for a duplex?

Central Coast Council's main plan, Central Coast DCP 2022, Chapters 2.1 and 2.2 (residential lots), asks a single storey duplex for these setbacks: front the average of the neighbouring homes (4.5m where there are none); side 0.9m, plus 0.25m for every metre of wall above 4.5m; and rear 4.5m.

Duplex setbacks in Central Coast gives the two storey figures, the clauses and every other plan that covers one.

Which DCP covers my block in Central Coast?

It depends on the lot: we hold 3 plans with setbacks for homes in Central Coast Council, and Central Coast DCP 2022, Chapters 2.1 and 2.2 (residential lots) is the main one. The others cover particular land, such as precincts, estates, rural land or former council areas. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot.

Every plan in Central Coast with setbacks for homes
PlanWhere it appliesHomes it covers
Central Coast DCP 2022, Chapters 2.1 and 2.2 (residential lots)Main plan. Lots zoned R1, R2, R3 or RU5 across the Central Coast (Chapter 2.1 s 2.1.3.1: "The following setback requirements apply to dwellings and all ancillary development on a lot zoned R1, R2, R3 or RU5").house, granny flat, duplex
Central Coast DCP 2022, Chapter 5.10 (Pearl Beach)"This chapter applies to all properties in the village of Pearl Beach (Figure 1)." (s 5.10.4) New buildings and alterations and additions.house, granny flat, duplex
Central Coast DCP 2022, Chapters 2.1 and 2.2 (large lots, rural and environmental zones)Lots zoned RU1, RU2, RU6, C3, C4, R5 or C2 (where permissible) across the Central Coast (Chapter 2.1 Table 2); dual occupancy in rural and environmental zones under Chapter 2.2 s 2.2.12.house, granny flat, duplex

Do Central Coast Council's setbacks apply to complying development?

No. A home approved with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, follows the state codes' setbacks instead of the council's. On a 600m² (15m wide, 40m deep) lot, for example, the Site Checker reads the complying development setbacks for a house as front 4.5m, side 0.9m (1.5m at two storeys) and rear 3m (8m at two storeys).

The council's plan applies when you lodge a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

What setbacks apply on a corner block in Central Coast?

Central Coast DCP 2022, Chapters 2.1 and 2.2 (residential lots) sets a separate setback for a house from the second street, the side street of a corner block: 2m (Central Coast DCP 2022, Ch 2.1, s 2.1.3.1, Table 1, row d). The front setback still applies to the main street. Under complying development the code sets its own second street figure by lot size.

What else do people ask?

Can Central Coast Council approve a smaller setback?

It can, through a development application. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more.

Do Central Coast setbacks apply to sheds, pools and fences?

Not the ones on this page. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were Central Coast Council's setbacks checked?

We last read Central Coast Council's plans on 11 November 2026. Each plan links to the council's own document, so you can check a figure against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block