Skip to main content

How close to the boundary can a house be in Richmond Valley?

Richmond Valley Council's main plan, Richmond Valley DCP 2021, Part A Residential Development (R1 General Residential and RU5 Village), asks a single storey house for these setbacks: front the average of the neighbouring homes (6m where there are none); side 0.9m, plus 0.25m for every metre of wall above 3.5m; and rear 3m.

In Richmond Valley the setbacks for a house come from Richmond Valley Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Richmond Valley Council's main plan set for a house?

The table gives Richmond Valley DCP 2021, Part A Residential Development (R1 General Residential and RU5 Village)'s one and two storey figures and the clause each comes from. The plan covers this land: R1 General Residential and RU5 Village land in Richmond Valley (Casino, Evans Head, Coraki, Woodburn, Broadwater, Rileys Hill and the villages).

Richmond Valley DCP 2021, Part A Residential Development (R1 General Residential and RU5 Village): setbacks for a house
SetbackOne storeyTwo storeysWhere in the plan
Frontthe average of the neighbouring homes (6m where there are none)the average of the neighbouring homes (6m where there are none)Richmond Valley DCP 2021, Part A-1, A-1.3 Building Setbacks, Setbacks to Streets, cl 1
Side0.9m, plus 0.25m for every metre of wall above 3.5m0.9m, plus 0.25m for every metre of wall above 3.5mRichmond Valley DCP 2021, Part A-1, A-1.3 Building Setbacks, Side Boundary Setbacks, cl 7 (page A-18)
Rear3m6m for second storey (the first storey of a two storey dwelling keeps 3 m)Richmond Valley DCP 2021, Part A-1, A-1.3 Building Setbacks, Rear Boundary Setbacks, cl 8 (page A-19)
Corner block, second street3m3mRichmond Valley DCP 2021, Part A-1, A-1.3 Building Setbacks, Setbacks to Secondary and Parallel Roads, cl 4 and 5

Which DCP applies to my block in Richmond Valley?

It depends on where the lot is. Richmond Valley DCP 2021, Part A Residential Development (R1 General Residential and RU5 Village) is Richmond Valley Council's main plan, and 4 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Richmond Valley that cover a house
PlanWhere it appliesFrontSideRearSecond street
Richmond Valley DCP 2021, Part A Residential Development (R5 Large Lot Residential)R5 Large Lot Residential land.15m5m5m15m
Richmond Valley DCP 2021, Part A Residential Development (RU1 Primary Production)RU1 Primary Production land.15m10m10m15m
Richmond Valley DCP 2021, Part A Residential Development (C3 Environmental Management)C3 Environmental Management land (named "E3 Environmental Management" in the 2021 contents page; in this LEP E3 is now Productivity Support, so the zone test is C3 only).15m10m10m15m
Richmond Valley DCP 2021, Part B Commercial Development and Part I-3 Building Setbacks (E1 Local Centre)E1 Local Centre land (local centres in Casino and Evans Head).0m0m0m0m

What are the complying development setbacks for a house?

If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a house on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
1,000m² (20m wide, 50m deep)6.5m1.5m (2.1m at two storeys)5m (12m at two storeys)3m

What if my block is on a corner?

Richmond Valley DCP 2021, Part A Residential Development (R1 General Residential and RU5 Village) sets a separate setback for a house from the second street, the side street of a corner block: 3m (Richmond Valley DCP 2021, Part A-1, A-1.3 Building Setbacks, Setbacks to Secondary and Parallel Roads, cl 4 and 5). Where the house faces that street, it asks for the average of the neighbouring homes (6m where there are none). The complying development figure for the second street is in the CDC table above.

Does a two storey house need bigger setbacks?

Yes, under Richmond Valley DCP 2021, Part A Residential Development (R1 General Residential and RU5 Village): the rear setback goes from 3m to 6m for second storey (the first storey of a two storey dwelling keeps 3 m). The side setback also grows as the wall gets taller. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Richmond Valley Council approve a house closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Richmond Valley?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Richmond Valley Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block