Skip to main content

How close to the boundary can a house be in Inner West?

Inner West Council's main plan, Marrickville DCP 2011, Part 4.1 Low Density Residential Development, asks a single storey house for these setbacks: front the average of the neighbouring homes; side no figure on lots up to 7.99m wide, 0.9m on wider lots; and rear the average of the neighbouring homes.

In Inner West the setbacks for a house come from Inner West Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Inner West Council's main plan set for a house?

The table gives Marrickville DCP 2011, Part 4.1 Low Density Residential Development's one and two storey figures and the clause each comes from. The plan covers this land: R1 General Residential, R2 Low Density Residential, R3 Medium Density Residential and R4 High Density Residential land in the former Marrickville council area (Camperdown south of Parramatta Road, Dulwich Hill, Enmore, Lewisham, Marrickville, Newtown, Petersham, Stanmore, St Peters, Sydenham, Tempe).

Marrickville DCP 2011, Part 4.1 Low Density Residential Development: setbacks for a house
SetbackOne storeyTwo storeysWhere in the plan
Frontthe average of the neighbouring homesthe average of the neighbouring homesMarrickville DCP 2011, Part 4.1 Low Density Residential Development, s 4.1.6.2 C10(i)(a)
Sideno figure on lots up to 7.99m wide, 0.9m on wider lotsno figure on lots up to 7.99m wide, 1.5m on wider lotsMarrickville DCP 2011, Part 4.1 Low Density Residential Development, s 4.1.6.2 C10(ii), side setback table
Rearthe average of the neighbouring homesthe average of the neighbouring homesMarrickville DCP 2011, Part 4.1 Low Density Residential Development, s 4.1.6.2 C10(iii)
Corner block, second streetthe average of the neighbouring homesthe average of the neighbouring homesMarrickville DCP 2011, Part 4.1 Low Density Residential Development, s 4.1.6.2 C10(i)(b)

Which DCP applies to my block in Inner West?

It depends on where the lot is. Marrickville DCP 2011, Part 4.1 Low Density Residential Development is Inner West Council's main plan, and 5 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Inner West that cover a house
PlanWhere it appliesFrontSideRearSecond street
Leichhardt DCP 2013, Part C Section 3 Residential ProvisionsR1 General Residential and R3 Medium Density Residential land in the former Leichhardt council area (Annandale, Balmain, Balmain East, Birchgrove, Camperdown north of Parramatta Road, Leichhardt, Lilyfield, Rozelle).the average of the neighbouring homesinside a plane rising at 60° from 2.8m above the boundarythe average of the neighbouring homesnot set
Comprehensive Inner West DCP 2016 (Ashfield), Chapter F Parts 1 and 2R2 Low Density Residential and R3 Medium Density Residential land in the former Ashfield council area (Ashbury, Ashfield, Croydon, Croydon Park, Haberfield, Hurlstone Park, Summer Hill), outside the heritage conservation areas.the average of the neighbouring homes0.9mnot set by the DCP: ask the councilnot set
Comprehensive Inner West DCP 2016 (Ashfield), Chapter E1 Heritage Conservation AreasR2 and R3 land in a heritage conservation area of the former Ashfield council area, other than Haberfield (C54).the average of the neighbouring homesnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
Comprehensive Inner West DCP 2016 (Ashfield), Chapter E2 Haberfield Heritage Conservation AreaR2 and R3 land in the Haberfield Heritage Conservation Area (C54 on the Inner West LEP 2022 heritage map).at least not set, or the street's established building line where that is further back3m to one side, not set by the DCP: ask the council to the othernot set by the DCP: ask the councilnot set
Comprehensive Inner West DCP 2016 (Ashfield), Chapter E2 s 2.3, 140A Hawthorne Parade HaberfieldThe 21 house lots of the former Defence land at 140A Hawthorne Parade, Haberfield (Lots 1 to 21 DP1306562, Darragh Lane), the land marked "A" in E2 Figure 1 and laid out in Figure 13.4m3m to one side, not set by the DCP: ask the council to the othernot set by the DCP: ask the councilnot set

What are the complying development setbacks for a house?

If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a house on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
1,000m² (20m wide, 50m deep)6.5m1.5m (2.1m at two storeys)5m (12m at two storeys)3m

What if my block is on a corner?

Marrickville DCP 2011, Part 4.1 Low Density Residential Development sets a separate setback for a house from the second street, the side street of a corner block: the average of the neighbouring homes (Marrickville DCP 2011, Part 4.1 Low Density Residential Development, s 4.1.6.2 C10(i)(b)). The complying development figure for the second street is in the CDC table above.

Does a two storey house need bigger setbacks?

Yes, under Marrickville DCP 2011, Part 4.1 Low Density Residential Development: the side setback goes from no figure on lots up to 7.99m wide, 0.9m on wider lots to no figure on lots up to 7.99m wide, 1.5m on wider lots. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Inner West Council approve a house closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Inner West?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Inner West Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block