How close to the boundary can a house be in Blayney?
Blayney Council's main plan, Blayney Shire DCP 2026, Part B (B2 Single Dwellings in Urban Areas, B5 Medium Density Housing): R1 and RU5, asks a single storey house for these setbacks: front at least 4.5m, or the street's established building line where that is further back; side 0.9m; and rear 1.5m.
In Blayney the setbacks for a house come from Blayney Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.
NSW addresses only. Free, and no sign up.
What setbacks does Blayney Council's main plan set for a house?
The table gives Blayney Shire DCP 2026, Part B (B2 Single Dwellings in Urban Areas, B5 Medium Density Housing): R1 and RU5's one and two storey figures and the clause each comes from. The plan covers this land: Land zoned R1 General Residential (Blayney and part of Millthorpe) and RU5 Village (Millthorpe and the other villages).
| Setback | One storey | Two storeys | Where in the plan |
|---|---|---|---|
| Front | at least 4.5m, or the street's established building line where that is further back | at least 4.5m, or the street's established building line where that is further back | Part B, B2.1 3) Dwelling setbacks table, Primary Street (Not Classified Road) (FRONT SETBACK) column, R1 General Residential / RU5 Village rows |
| Side | 0.9m | 1.5m for walls above the 1st storey (">1st storey"); the 1st storey may sit at 900mm | Part B, B2.1 3) Dwelling setbacks table, Side Boundary (Not road frontage) column |
| Rear | 1.5m | 1.5m | Part B, B2.1 3) Dwelling setbacks table, Rear Boundary (Not road frontage) column |
| Corner block, second street | 3m on lots up to 900m², 4.5m on larger lots | 3m on lots up to 900m², 4.5m on larger lots | Part B, B2.1 3) Dwelling setbacks table, Secondary Street / Corner Lots (Not Classified Road) column |
Which DCP applies to my block in Blayney?
It depends on where the lot is. Blayney Shire DCP 2026, Part B (B2 Single Dwellings in Urban Areas, B5 Medium Density Housing): R1 and RU5 is Blayney Council's main plan, and 3 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Blayney Shire DCP 2026, Part B (B2 Single Dwellings in Urban Areas, B5 Medium Density Housing): E1 Local Centre | Land zoned E1 Local Centre (the Town of Blayney). | the average of the neighbouring homes | left to the Building Code (0.9m) | left to the Building Code (0.9m) | 3m |
| Blayney Shire DCP 2026, Part B (B2, B4 Large Lot & Rural Dwellings, B5): R5 Large Lot Residential | Land zoned R5 Large Lot Residential. | at least 8m, or the street's established building line where that is further back on lots up to 9,999.99m²; 20m on larger lots | 3m on lots up to 9,999.99m²; 10m on larger lots | 6m on lots up to 9,999.99m²; 10m on larger lots | 6m on lots up to 9,999.99m²; 20m on larger lots |
| Blayney Shire DCP 2026, Part B4 Large Lot & Rural Dwellings (including Rural Dual Occupancies): RU1 and RU2 | Land zoned RU1 Primary Production and RU2 Rural Landscape. | 20m | 10m | 10m | 20m |
What are the complying development setbacks for a house?
If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.
| Example lot | Front | Side | Rear | Corner block, second street |
|---|---|---|---|---|
| 450m² (15m wide, 30m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 600m² (15m wide, 40m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 1,000m² (20m wide, 50m deep) | 6.5m | 1.5m (2.1m at two storeys) | 5m (12m at two storeys) | 3m |
What if my block is on a corner?
Blayney Shire DCP 2026, Part B (B2 Single Dwellings in Urban Areas, B5 Medium Density Housing): R1 and RU5 sets a separate setback for a house from the second street, the side street of a corner block: 3m on lots up to 900m², 4.5m on larger lots (Part B, B2.1 3) Dwelling setbacks table, Secondary Street / Corner Lots (Not Classified Road) column). The complying development figure for the second street is in the CDC table above.
Does a two storey house need bigger setbacks?
Yes, under Blayney Shire DCP 2026, Part B (B2 Single Dwellings in Urban Areas, B5 Medium Density Housing): R1 and RU5: the side setback goes from 0.9m to 1.5m for walls above the 1st storey (">1st storey"); the 1st storey may sit at 900mm. Under complying development, the two storey figures are in the CDC table above.
What else do people ask?
Can Blayney Council approve a house closer to the boundary?
It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.
Do these setbacks apply to a shed, pool or fence in Blayney?
No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were the setbacks on this page checked?
We last read Blayney Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.