Skip to main content

How close to the boundary can a granny flat be in The Hills Shire?

The Hills Shire Council's main plan, The Hills DCP 2012, Part B Section 2 (Residential) and Section 3 (Dual Occupancy), asks a single storey granny flat for these setbacks: front at least 10m, or the street's established building line where that is further back; side 0.9m; and rear 4m.

In The Hills Shire the setbacks for a granny flat come from The Hills Shire Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the granny flat first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does The Hills Shire Council's main plan set for a granny flat?

The table gives The Hills DCP 2012, Part B Section 2 (Residential) and Section 3 (Dual Occupancy)'s one and two storey figures and the clause each comes from. The plan covers this land: Residential zoned land (R1, R2, R3, R4), village (RU5) and C3/C4 land under The Hills LEP 2019 that no site specific section, release area section or Growth Centre DCP covers (Part B Section 2 s 1.1: it applies to all residential zoned land and all land where residential accommodation is permissible).

The Hills DCP 2012, Part B Section 2 (Residential) and Section 3 (Dual Occupancy): setbacks for a granny flat
SetbackOne storeyTwo storeysWhere in the plan
Frontat least 10m, or the street's established building line where that is further backat least 10m, or the street's established building line where that is further backThe Hills DCP 2012, Part B Section 2, s 2.14.1 (a) to (c); s 2.14
Side0.9m0.9mThe Hills DCP 2012, Part B Section 2, s 2.14.1 (g); s 2.14
Rear4m6m for the 2-3 storey elements of the dwellingThe Hills DCP 2012, Part B Section 2, s 2.14.1 (h); s 2.14
Corner block, second street4m4mThe Hills DCP 2012, Part B Section 2, s 2.14.1 (d)

Which DCP applies to my block in The Hills Shire?

It depends on where the lot is. The Hills DCP 2012, Part B Section 2 (Residential) and Section 3 (Dual Occupancy) is The Hills Shire Council's main plan, and 17 other plans cover a granny flat on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in The Hills Shire that cover a granny flat
PlanWhere it appliesFrontSideRearSecond street
The Hills DCP 2012, Part B Section 2 (7.5 m front setback areas)Residential land in the West Pennant Hills Valley (Map 1), Bingara Crescent/Crestwood (Map 2) and Kings Road (Map 3) areas, where Part B Section 2 s 2.14.1 sets a 7.5 m primary road setback instead of 10 m.at least 7.5m, or the street's established building line where that is further back0.9m4m4m
The Hills DCP 2012, Part B Section 2 (Bella Vista Residential, 6 m front setback)Residential land in the Bella Vista Residential area shown on Map 4 of Part B Section 2, where s 2.14.1 sets a 6 m primary road setback instead of 10 m.at least 6m, or the street's established building line where that is further back0.9m4m4m
The Hills DCP 2012, Part B Section 1 (Rural)Rural and environmental zones RU1, RU2, RU3, RU6, SP3, W2 and C2 (Part B Section 1, Land to which this section applies).10m5m5m10m
Box Hill Growth Centre Precincts DCP 2018All development on the land in Figure 1 of the DCP: the Box Hill and Box Hill Industrial Growth Centre precincts.4.5m0.9m to one side, 0.9m on lots up to 15m wide, 0.9m on wider lots to the other4m1m on lots up to 8.99m wide, 2m on wider lots
Box Hill Growth Centre Precincts DCP 2018 (Ridge Area)The Ridge Character Area of the Box Hill precinct, along the ridgelines of Old Pitt Town Road, which the DCP describes as "a predominately large lot residential zone" (s 2.3.2).7.5m1.5m to one side, 1.5m to the other10m4.5m
North Kellyville Precinct DCP 2018All development on the land in Figure 1 of the DCP: the North Kellyville Growth Centre precinct.4.5m0.9m to one side, 0.9m on lots up to 15m wide, 0.9m on wider lots to the other4m1m on lots up to 8.99m wide, 2m on wider lots
North Kellyville Precinct DCP 2018 (Environmental Living zone)Land zoned Environmental Living (E4, now C4) in the North Kellyville precinct (Table 15).4.5m1.5m to one side, 1.5m to the other10m4.5m
The Hills DCP 2012, Part D Section 5 (Kellyville / Rouse Hill Release Area)Land within the Kellyville/Rouse Hill Release Area outlined by a bold black line in Figure 1 and on Sheets 1 to 4 (s 1.1).4.5m0.9m4m2m
Show 9 more plans
Other plans in The Hills Shire that cover a granny flat, continued
PlanWhere it appliesFrontSideRearSecond street
The Hills DCP 2012, Part D Section 7 (Balmoral Road Release Area)Land within the Balmoral Road Release Area outlined by a bold black line on the BRRA map and in Figure 1 (s 1.1).6m0.9m4m4m
The Hills DCP 2012, Part D Section 17 (Gables), R3 and R4 lotsR3 Medium Density and R4 High Density land in Gables (the former Box Hill North precinct), outlined in red in Figure 1 of Part D Section 17.4.5m on lots up to 449.99m²; at least 10m, or the street's established building line where that is further back on larger lots0.9m4m2m on lots up to 449.99m², 4m on larger lots
The Hills DCP 2012, Part D Section 17 (Gables), R2 large lotsR2 Low Density Residential large lots in Gables (s 3.2), outlined in red in Figure 1 of Part D Section 17.at least 10m, or the street's established building line where that is further back5m4m4m
The Hills DCP 2012, Part D Section 6 (Rouse Hill Regional Centre)The Rouse Hill Regional Centre (s 1.2: 'land commonly referred to as the Rouse Hill Regional Centre as shown edged heavy red in Figure 1 below [Note.3m1m on lots up to 10.99m wide, 1.2m on lots up to 13.5m wide, 1.5m on wider lots4m2m
The Hills DCP 2012, Part D Section 13 (354-368 Old Northern Road, Castle Hill)s 1.2: 'This Section applies to all land identified in Figure 1.1 below and legally identified as: Lot 2002 DP 1090990' (354-368 Old Northern Road, Castle Hill), a low density subdivision of single dwellings between Old Northern Road, Old Castle Hill Road and Heritage Park Drive.6m0.9m4m4m
The Hills DCP 2012, Part B Section 1 Rural (Riverside Oaks Golf Course housing)Residential development in the Riverside Oaks Golf Course tourist complex, 74 O'Briens Road, Cattai.4.5m0.9m4m2m
The Hills DCP 2012, Part B Section 2 Appendix C.1 (Corner Old Windsor Road and Seven Hills Road, Baulkham Hills)The residential estate at the corner of Old Windsor Road and Seven Hills Road, Baulkham Hills, outlined on Part B Section 2 Map Sheet 43 of 46 (Appendix C.1.1).10m1m4m4m
The Hills DCP 2012, Part B Section 2 Appendix C.5 (Mackillop Drive, Norwest)C.5.1: 'land at Mackillop Drive, Barina Downs Road, Banyan Avenue and Irongum Terrace identified in the figure below (see Figure 2)', Norwest (Baulkham Hills); single detached dwellings under C.5.2.6m0.9m4m2m
The Hills DCP 2012, Part B Section 2 Appendix C.3 (Land adjoining Heritage Park, Castle Hill)Land adjoining Castle Hill Heritage Park between Old Castle Hill Road and the park, outlined on Part B Section 2 Map Sheet 45 of 46 (Appendix C.3.1).at least 10m, or the street's established building line where that is further back0.9m4m4m

What are the complying development setbacks for a granny flat?

If you build a granny flat with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a granny flat on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m2m
1,000m² (20m wide, 50m deep)6.5m1.5m5m3m

What if my block is on a corner?

The Hills DCP 2012, Part B Section 2 (Residential) and Section 3 (Dual Occupancy) sets a separate setback for a granny flat from the second street, the side street of a corner block: 4m (The Hills DCP 2012, Part B Section 2, s 2.14.1 (d)). The complying development figure for the second street is in the CDC table above.

Does a two storey granny flat need bigger setbacks?

Yes, under The Hills DCP 2012, Part B Section 2 (Residential) and Section 3 (Dual Occupancy): the rear setback goes from 4m to 6m for the 2-3 storey elements of the dwelling. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can The Hills Shire Council approve a granny flat closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in The Hills Shire?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read The Hills Shire Council's plans on 11 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block