Skip to main content

How close to the boundary can a granny flat be in Port Macquarie-Hastings?

Port Macquarie-Hastings Council's main plan, Port Macquarie-Hastings DCP 2013, Part C1 Low Density Residential Development, asks a single storey granny flat for these setbacks: front 4.5m, side 0.9m and rear 4m.

In Port Macquarie-Hastings the setbacks for a granny flat come from Port Macquarie-Hastings Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the granny flat first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Port Macquarie-Hastings Council's main plan set for a granny flat?

The table gives Port Macquarie-Hastings DCP 2013, Part C1 Low Density Residential Development's one and two storey figures and the clause each comes from. The plan covers this land: The whole Port Macquarie-Hastings LGA ("The Plan applies to all land in the Port Macquarie-Hastings Local Government Area", s A4) outside the large lot residential and rural zones (own plan, Table 4's 10 m row) and the Westport Neighbourhood (Part D1.3, own plan).

Port Macquarie-Hastings DCP 2013, Part C1 Low Density Residential Development: setbacks for a granny flat
SetbackOne storeyTwo storeysWhere in the plan
Front4.5m4.5mPMHDCP 2013, Part C1 Low Density Residential Development, Application; s 44 c) and Table 4
Side0.9m3m for first floors and abovePMHDCP 2013, Part C1, s 47 a) and b)
Rear4m4mPMHDCP 2013, Part C1, s 46 a)
Corner block, second street3m3mPMHDCP 2013, Part C1, s 44 c) and Table 4

Which DCP applies to my block in Port Macquarie-Hastings?

It depends on where the lot is. Port Macquarie-Hastings DCP 2013, Part C1 Low Density Residential Development is Port Macquarie-Hastings Council's main plan, and 7 other plans cover a granny flat on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Port Macquarie-Hastings that cover a granny flat
PlanWhere it appliesFrontSideRearSecond street
Port Macquarie-Hastings DCP 2013, Part C1 (large lot residential and rural zones)Land zoned R5 Large Lot Residential and the rural zones RU1 to RU6, where C1 Table 4 sets a 10 m street setback ("Large lot residential and rural zones 10.0m").10m0.9m4m10m
Port Macquarie-Hastings DCP 2013, Part D1.3 Westport Neighbourhood (R1 land)The Westport Neighbourhood, Port Macquarie: the land outlined in Figure 53 (Warlters Street and Bay Street west to beyond Aston Street, Buller Street, Kooloonbung Creek, Hollingworth Street, Table Street, Morton Street and Garden Crescent, with the Hilltop Crescent lots on its western edge).3m3m6m3m
Port Macquarie-Hastings DCP 2013, Part D1.3 Westport Neighbourhood (R3, R4, E1 and RE1 land)The Westport Neighbourhood land (Figure 53) outside the R1 zone: R4 High Density Residential (114 of the 309 lots), E1 Local Centre (73), R3 Medium Density Residential (42) and RE1 (1).3m3m6m3m
Port Macquarie-Hastings DCP 2013, Part D2.1 East Port Neighbourhood (northern side of Clarence Street, east of Munster Street)The lots on the northern side of Clarence Street from Munster Street to the street's eastern end at Town Beach Park, inside the East Port Neighbourhood (Part D2.1, Figure 60).3m0.9m4m3m
Port Macquarie-Hastings DCP 2013, Part D2.1 East Port Neighbourhood (southern side of Clarence Street, between Munster and School Streets)The lots on the southern side of Clarence Street between Munster Street and School Street, inside the East Port Neighbourhood (Part D2.1, Figure 60).0m0.9m4m3m
Port Macquarie-Hastings DCP 2013, Part D2.1 East Port Neighbourhood (southern side of William Street, between Murray and Grant Streets)The lots on the southern side of William Street between Murray Street and Grant Street, inside the East Port Neighbourhood (Part D2.1, Figure 60).2m0.9m4m3m
Port Macquarie-Hastings DCP 2013, Part D2.1 East Port Neighbourhood (5 to 9 Pacific Drive)5, 7 and 9 Pacific Drive, Port Macquarie (Lot 8 DP32244, Lot A DP157217, Lot B DP157217), inside the East Port Neighbourhood (Part D2.1, Figure 60).6m0.9m4m3m

What are the complying development setbacks for a granny flat?

If you build a granny flat with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a granny flat on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m2m
1,000m² (20m wide, 50m deep)6.5m1.5m5m3m

What if my block is on a corner?

Port Macquarie-Hastings DCP 2013, Part C1 Low Density Residential Development sets a separate setback for a granny flat from the second street, the side street of a corner block: 3m (PMHDCP 2013, Part C1, s 44 c) and Table 4). On a corner block it also changes the other boundaries: rear 0.9m for one storey, 3m for first floors and above. The complying development figure for the second street is in the CDC table above.

Does a two storey granny flat need bigger setbacks?

Yes, under Port Macquarie-Hastings DCP 2013, Part C1 Low Density Residential Development: the side setback goes from 0.9m to 3m for first floors and above. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Port Macquarie-Hastings Council approve a granny flat closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Port Macquarie-Hastings?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Port Macquarie-Hastings Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block