Skip to main content

How close to the boundary can a granny flat be in Nambucca Valley?

Nambucca Valley Council's main plan, Nambucca DCP, Part H Residential Development (Zones R1, R2, R3, R4, RU5 and MU1), asks a single storey granny flat for these setbacks: front the average of the neighbouring homes (4.5m where there are none); and side 0.9m, plus 0.25m for every metre of wall above 3.8m. It does not set a rear setback: ask the council.

In Nambucca Valley the setbacks for a granny flat come from Nambucca Valley Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the granny flat first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Nambucca Valley Council's main plan set for a granny flat?

The table gives Nambucca DCP, Part H Residential Development (Zones R1, R2, R3, R4, RU5 and MU1)'s one and two storey figures and the clause each comes from. The plan covers this land: Land in Zones R1, R2, R3, R4, RU5 and MU1 (Part H H1.1: "R1, R2, R3, R4, B1, B2, B3, B4 and RU5"; B4 is now MU1, and the LEP prohibits residential accommodation in E1 and E2, the old B1 to B3).

Nambucca DCP, Part H Residential Development (Zones R1, R2, R3, R4, RU5 and MU1): setbacks for a granny flat
SetbackOne storeyTwo storeysWhere in the plan
Frontthe average of the neighbouring homes (4.5m where there are none)the average of the neighbouring homes (4.5m where there are none)Nambucca DCP, Part H, H4.1.3 Setbacks, control 1 and table (applies to all residential accommodation, H1.1)
Side0.9m, plus 0.25m for every metre of wall above 3.8m0.9m, plus 0.25m for every metre of wall above 3.8mNambucca DCP, Part H, H4.1.3 Setbacks, controls 3 to 5 ("A dwelling or building"; "apply to buildings whether or not they are attached to a dwelling")
Rearnot set by the DCP: ask the councilnot set by the DCP: ask the councilNone
Corner block, second street2m2mNambucca DCP, Part H, H4.1.3 Setbacks, control 1 and table (secondary street column)

Which DCP applies to my block in Nambucca Valley?

It depends on where the lot is. Nambucca DCP, Part H Residential Development (Zones R1, R2, R3, R4, RU5 and MU1) is Nambucca Valley Council's main plan, and 5 other plans cover a granny flat on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Nambucca Valley that cover a granny flat
PlanWhere it appliesFrontSideRearSecond street
Nambucca DCP, Part M Matthew Street North Precinct, Scotts HeadThe Matthew Street North Precinct: the 15 lots on the north east side of Matthew Street, Scotts Head, between the street and the headland (Figure 2), all zoned R1.4.5m1.5m6m2m
Nambucca DCP, Part J South Macksville URA, lots on the northern boundary (40 m rear)Future residential lots along the northern boundary of the South Macksville Urban Release Area, adjoining RU1 land (Map J10, 40 m rear setback hatching).the average of the neighbouring homes (4.5m where there are none)0.9m, plus 0.25m for every metre of wall above 3.8m40m2m
Nambucca DCP, Part J South Macksville URA, lots on Peterkins Lane (20 m rear)Future residential lots along the western boundary of the South Macksville Urban Release Area, backing onto the Peterkins Lane reservation (Map J10, 20 m rear setback hatching).the average of the neighbouring homes (4.5m where there are none)0.9m, plus 0.25m for every metre of wall above 3.8m20m2m
Nambucca DCP, Part F Rural and Environmental Development (Zone R5 Large Lot Residential)Land in Zone R5 Large Lot Residential (Part F F1.1 and F1.3.1 control 2).20m5m5m20m
Nambucca DCP, Part F Rural and Environmental Development (Zones RU1 and RU2)Land in Zones RU1 Primary Production and RU2 Rural Landscape (Part F F1.1 and F1.3.1 control 1).20mnot set by the DCP: ask the councilnot set by the DCP: ask the council20m

What are the complying development setbacks for a granny flat?

If you build a granny flat with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a granny flat on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m2m
1,000m² (20m wide, 50m deep)6.5m1.5m5m3m

What if my block is on a corner?

Nambucca DCP, Part H Residential Development (Zones R1, R2, R3, R4, RU5 and MU1) sets a separate setback for a granny flat from the second street, the side street of a corner block: 2m (Nambucca DCP, Part H, H4.1.3 Setbacks, control 1 and table (secondary street column)). The complying development figure for the second street is in the CDC table above.

Does a two storey granny flat need bigger setbacks?

Yes, through the wall height: under Nambucca DCP, Part H Residential Development (Zones R1, R2, R3, R4, RU5 and MU1) the side setback grows as the wall gets taller. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Nambucca Valley Council approve a granny flat closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Nambucca Valley?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Nambucca Valley Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block