Skip to main content

How close to the boundary can a granny flat be in Lake Macquarie?

Lake Macquarie Council's main plan, Lake Macquarie DCP 2014, Part 3 (Development within Residential Zones) and Part 9, asks a single storey granny flat for these setbacks: front 4m, side 0.9m and rear 3m.

In Lake Macquarie the setbacks for a granny flat come from Lake Macquarie Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the granny flat first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Lake Macquarie Council's main plan set for a granny flat?

The table gives Lake Macquarie DCP 2014, Part 3 (Development within Residential Zones) and Part 9's one and two storey figures and the clause each comes from. The plan covers this land: Land zoned R2 Low Density Residential and R3 Medium Density Residential in Lake Macquarie, outside the area plan and site specific DCP plans listed below.

Lake Macquarie DCP 2014, Part 3 (Development within Residential Zones) and Part 9: setbacks for a granny flat
SetbackOne storeyTwo storeysWhere in the plan
Front4m4mPart 3 (Development within Residential Zones), s 3.2 Street Setback, controls 1 and 2
Side0.9m1.5m for any part of the building over 4.5 metres in heightPart 3 (Development within Residential Zones), s 3.3 Side Setback, controls 1 and 2
Rear3m6m for any part of the building over 4.5 metres in heightPart 3 (Development within Residential Zones), s 3.4 Rear Setback, controls 1 and 2
Corner block, second street2m2mPart 3 (Development within Residential Zones), s 3.2 Street Setback, control 3

Which DCP applies to my block in Lake Macquarie?

It depends on where the lot is. Lake Macquarie DCP 2014, Part 3 (Development within Residential Zones) and Part 9 is Lake Macquarie Council's main plan, and 10 other plans cover a granny flat on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Lake Macquarie that cover a granny flat
PlanWhere it appliesFrontSideRearSecond street
Lake Macquarie DCP 2014, Parts 2 and 7 (rural and environmental zones)Land in the RU2, RU3, RU4 and RU6 zones (Part 2: "applies to all development in the RU2 Rural Landscape, RU3 Forestry, RU4 Primary Production Small Lots and RU6 Transition land use zones") and the C2, C3 and C4 zones (Part 7: "applies to all development in the C2 Environmental Conservation, C3 Environmental Management, and C4 Environmental Living zones"), with Part 9.5 for dwelling houses in RU2, RU4, C2, C3 and C4.the average of the neighbouring homes (20m where there are none)5m5mnot set
Lake Macquarie DCP 2014, Part 11.2 West Wallsend and Holmesville HCA Area Plan, Appletree Grove EstateThe Appletree Grove Estate (the 375 lot subdivision approved in 2012) inside the West Wallsend and Holmesville Heritage Conservation Area, shown pink in Figure 11 of Area Plan 11.2.5m1.05m to one side, 2m to the other4m2m
Lake Macquarie DCP 2014, Part 11.8 Catherine Hill Bay Heritage Conservation Area PlanThe Catherine Hill Bay Heritage Conservation Area (Catherine Hill Bay and Middle Camp villages), except the Munmorah State Conservation Area and the Middle Camp North Urban Release Area.not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
Catherine Hill Bay (South) Development Control Plan 2012Catherine Hill Bay (South), the 72 ha State Significant Site south and south west of the Catherine Hill Bay village (Beaches Catherine Hill Bay estate), "shown in Figure 1 below as the area within the red boundary" (s 1.2).not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
Lake Macquarie DCP 2014, Part 12.4 Martinsville Precinct Area Plan"This Area Plan applies to all the land outlined in heavy black edging as shown within Figure 1: Martinsville Area Plan Boundary" (s 1.1).the average of the neighbouring homes (30m where there are none)5m5mnot set
Lake Macquarie DCP 2014, Part 12.16 North Wallarah Peninsula, Part 3 Lake Sector (Murrays Beach)The Lake Sector (Murrays Beach): "all land within North Wallarah Peninsula west of the Pacific Highway" (s 1), as outlined in Figure 16.not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
Lake Macquarie DCP 2014, Part 12.16 North Wallarah Peninsula, Part 4 Coastal Sector (Pinny Beach)The Coastal Sector (Pinny Beach), "the coastal land south of the existing Caves Beach Village": the Coastal Village (West and East Village), Spoon Rocks Valley and Radar Hill precincts, as outlined in Figure 17.not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
Lake Macquarie DCP 2014, Part 12.16 North Wallarah Peninsula, Northern Sector Central Precinct (main subdivision area)The main subdivision area of the Central Precinct in the Northern Sector of North Wallarah Peninsula (Figure 34), excluding its western, northern and southern edges.4m0.9m3m2m
Show 2 more plans
Other plans in Lake Macquarie that cover a granny flat, continued
PlanWhere it appliesFrontSideRearSecond street
Lake Macquarie DCP 2014, Part 12.16 North Wallarah Peninsula, Northern Sector Central Precinct edgesThe Central Precinct Western Edge, Northern Edge and Southern Edge of the Northern Sector, as outlined in Figure 34 (s 5.3.3).not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
Lake Macquarie DCP 2014, Part 12.26 Windale Area Plan (R3 zone)R3 Medium Density Residential land in the suburb of Windale: "This Area Plan contains local objectives and development controls for the suburb of Windale" (s 1).4m0.9m3m2m

What are the complying development setbacks for a granny flat?

If you build a granny flat with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a granny flat on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m2m
1,000m² (20m wide, 50m deep)6.5m1.5m5m3m

What if my block is on a corner?

Lake Macquarie DCP 2014, Part 3 (Development within Residential Zones) and Part 9 sets a separate setback for a granny flat from the second street, the side street of a corner block: 2m (Part 3 (Development within Residential Zones), s 3.2 Street Setback, control 3). The complying development figure for the second street is in the CDC table above.

Does a two storey granny flat need bigger setbacks?

Yes, under Lake Macquarie DCP 2014, Part 3 (Development within Residential Zones) and Part 9: the side setback goes from 0.9m to 1.5m for any part of the building over 4.5 metres in height; the rear setback goes from 3m to 6m for any part of the building over 4.5 metres in height. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Lake Macquarie Council approve a granny flat closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Lake Macquarie?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Lake Macquarie Council's plans on 11 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block