How close to the boundary can a granny flat be in Burwood?
Burwood Council's main plan, Burwood DCP, Part 4 (s 4.4 Dual Occupancies and Secondary Dwellings; s 4.5 Dwelling Houses), asks a single storey granny flat for these setbacks: front the average of the neighbouring homes, side 0.9m and rear 3m.
In Burwood the setbacks for a granny flat come from Burwood Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the granny flat first.
NSW addresses only. Free, and no sign up.
What setbacks does Burwood Council's main plan set for a granny flat?
The table gives Burwood DCP, Part 4 (s 4.4 Dual Occupancies and Secondary Dwellings; s 4.5 Dwelling Houses)'s one and two storey figures and the clause each comes from. The plan covers this land: Residential zones R1, R2 and R3 of the Burwood LGA (BDCP s 1.3: "The BDCP applies to all the land located in the Burwood LGA"; s 4.5.1: dwelling houses "on land in Residential zones under the BLEP 2012"; s 4.4.1: every dual occupancy or secondary dwelling), less the two special residential precincts (s 4.8: Appian Way, Malvern Hill) and the two area based precincts (s 3.7 Cooper Street, s 3.8 Livingstone Street and Sym Avenue), which have their own plans.
| Setback | One storey | Two storeys | Where in the plan |
|---|---|---|---|
| Front | the average of the neighbouring homes | at least 9m, or the street's established building line where that is further back for upper level of a two storey dwelling | BDCP s 4.4.3, Building Design, Setbacks, P9 |
| Side | 0.9m | 1.5m for upper level of a two storey dwelling | BDCP s 4.4.3, Building Design, Setbacks, P10 |
| Rear | 3m | 6m for upper level of a two storey dwelling | BDCP s 4.4.3, Building Design, Setbacks, P11 |
| Corner block, second street | at least not set, or the street's established building line where that is further back | at least not set, or the street's established building line where that is further back | BDCP s 4.4.3, Building Design, Setbacks, P12 |
Which DCP applies to my block in Burwood?
It depends on where the lot is. Burwood DCP, Part 4 (s 4.4 Dual Occupancies and Secondary Dwellings; s 4.5 Dwelling Houses) is Burwood Council's main plan, and 4 other plans cover a granny flat on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Burwood DCP, s 4.8.1 Appian Way (with Part 4) | The Appian Way Heritage Conservation Area, Burwood (BLEP 2012 Schedule 5 C1; BDCP Figure 95), residential lots only (R2; the tennis courts are RE2). | at least not set, or the street's established building line where that is further back | 0.9m | 3m | at least not set, or the street's established building line where that is further back |
| Burwood DCP, s 4.8.2 Malvern Hill (with Part 4) | The Malvern Hill Heritage Conservation Area, Croydon (BLEP 2012 Schedule 5 C13), residential lots only (R2; The Strand shopping centre is E1 and is left out). | the average of the neighbouring homes | 0.9m | 3m | at least not set, or the street's established building line where that is further back |
| Burwood DCP, s 3.7 Cooper Street Precinct, Strathfield (with Part 4) | The lots outlined in BDCP Figure 48: the south side of Cooper Street, Strathfield, between Cooper Street and Cowdery Lane, which are the lots BLEP 2012 cl 6.6(2) lists. | 6m | 0.9m | 3m | at least not set, or the street's established building line where that is further back |
| Burwood DCP, s 3.8 Livingstone Street and Sym Avenue Precinct, Burwood (with Part 4) | The properties outlined in BDCP Figure 51: both sides of Livingstone Street between Conder Street and Sym Lane, and Sym Avenue, Burwood; the same land as Areas A, B and C on the BLEP 2012 Additional Local Provisions Map (cl 6.8). | 6m | 0.9m | 3m | 6m |
What are the complying development setbacks for a granny flat?
If you build a granny flat with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.
| Example lot | Front | Side | Rear | Corner block, second street |
|---|---|---|---|---|
| 450m² (15m wide, 30m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m | 2m |
| 600m² (15m wide, 40m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m | 2m |
| 1,000m² (20m wide, 50m deep) | 6.5m | 1.5m | 5m | 3m |
What if my block is on a corner?
Burwood DCP, Part 4 (s 4.4 Dual Occupancies and Secondary Dwellings; s 4.5 Dwelling Houses) sets a separate setback for a granny flat from the second street, the side street of a corner block: at least not set, or the street's established building line where that is further back (BDCP s 4.4.3, Building Design, Setbacks, P12). It measures the front setback from the shorter street frontage. The complying development figure for the second street is in the CDC table above.
Does a two storey granny flat need bigger setbacks?
Yes, under Burwood DCP, Part 4 (s 4.4 Dual Occupancies and Secondary Dwellings; s 4.5 Dwelling Houses): the front setback goes from the average of the neighbouring homes to at least 9m, or the street's established building line where that is further back for upper level of a two storey dwelling; the side setback goes from 0.9m to 1.5m for upper level of a two storey dwelling; the rear setback goes from 3m to 6m for upper level of a two storey dwelling. Under complying development, the two storey figures are in the CDC table above.
What else do people ask?
Can Burwood Council approve a granny flat closer to the boundary?
It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.
Do these setbacks apply to a shed, pool or fence in Burwood?
No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were the setbacks on this page checked?
We last read Burwood Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.