Skip to main content

How close to the boundary can a duplex be in Wollongong?

Wollongong Council's main plan, Wollongong DCP 2009, Chapter B1 Residential Development (R2 zone), asks a single storey duplex for these setbacks: front 6m, side 0.9m and rear 0.9m.

In Wollongong the setbacks for a duplex come from Wollongong Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the duplex first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Wollongong Council's main plan set for a duplex?

The table gives Wollongong DCP 2009, Chapter B1 Residential Development (R2 zone)'s one and two storey figures and the clause each comes from. The plan covers this land: R2 Low Density Residential land across the City of Wollongong, other than land a precinct chapter in Part D covers.

Wollongong DCP 2009, Chapter B1 Residential Development (R2 zone): setbacks for a duplex
SetbackOne storeyTwo storeysWhere in the plan
Front6m6mChapter B1, s 4.2.2(1)(a)
Side0.9m0.9mChapter B1, s 4.3.2(1) and (2)
Rear0.9m8m for upper storey: in the R2 zone development within the 8 m rear setback is limited to single storeyChapter B1, s 4.3.2(1); s 4.1.2(4)
Corner block, second street3m3mChapter B1, s 4.2.2(2)(c)

Which DCP applies to my block in Wollongong?

It depends on where the lot is. Wollongong DCP 2009, Chapter B1 Residential Development (R2 zone) is Wollongong Council's main plan, and 13 other plans cover a duplex on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Wollongong that cover a duplex
PlanWhere it appliesFrontSideRearSecond street
Wollongong DCP 2009, Chapter B1 Residential Development (R1 and R3 zones)R1 General Residential and R3 Medium Density Residential land, other than land a precinct chapter in Part D covers.6m0.9m0.9m3m
Wollongong DCP 2009, Chapter D6 Kanahooka (Northern side of Kanahooka Road), R2 landR2 land in the precinct on the northern side of Kanahooka Road, Kanahooka, between Kanahooka Road and Mullet Creek (Figure 1).6m0.9m0.9m6m
Wollongong DCP 2009, Chapter D15 Woonona (Edgewood Estate)"the Edgewood Estate (i.e. former "Boral Brickworks Site"), Princes Highway, Woonona" (s 2(1)).3mleft to the Building Code (0.9m)left to the Building Code (0.9m)3m
Wollongong DCP 2009, Chapter D17 Bulli Brickworks"the former Bulli Brickworks Site, located off the Princes Highway, Bulli (Lot 2 DP 582940 and Lot 207 DP 228538)" (s 2).3m0.9m0.9m3m
Wollongong DCP 2009, Chapter D16, Bong Bong East and North Neighbourhood Plan (R2 and R3 land)The Bong Bong East and North neighbourhood (s 14.5.1, Figure 18), south of Bong Bong Road, Horsley and Kembla Grange: the residential land of the neighbourhood plan.4.5m0.9m3m2m
Wollongong DCP 2009, Chapter D16, Hayes Lane and Iredell Road Neighbourhood PlanThe Hayes Lane and Iredell Road neighbourhood (s 14.5.13, Figures 35 and 36), north of Bong Bong Road, Horsley: R2 land.4m0.9m0.9m2m
Wollongong DCP 2009, Chapter D16 West Dapto Urban Release Area (R2 zone)R2 land in the West Dapto Urban Release Area (Figure 1), including Yallah but not the Tallawarra Lands (D21), outside the neighbourhood plans traced separately.4m0.9m0.9m3m
Wollongong DCP 2009, Chapter D16 West Dapto Urban Release Area (R1 and R3 zones)R1 and R3 land in the West Dapto Urban Release Area (Figure 1), including Yallah but not the Tallawarra Lands (D21), outside the neighbourhood plans traced separately.4m0.9m0.9m3m
Show 5 more plans
Other plans in Wollongong that cover a duplex, continued
PlanWhere it appliesFrontSideRearSecond street
Wollongong DCP 2009, Chapter D19 Former Corrimal Coke Works SiteThe former Corrimal Coke Works site, Corrimal (key site; zoned mostly R3 with RE1 open space).4m0.9m0.9m4m
Wollongong DCP 2009, Chapter D20 Former Port Kembla School SiteThe former Port Kembla Public School site, Military Road, Port Kembla (key site; zoned R3 with RE2).4.5m0.9m0.9m3m
Wollongong DCP 2009, Chapter D21 Tallawarra Lands (R2 zone)R2 zone land in the Tallawarra Lands (Figure 2), the former power station land on the western shore of Lake Illawarra between Koonawarra and Haywards Bay.4.5m0.9m3m on lots up to 300m², 0.9m on larger lots1.5m on lots up to 300m², 2m on larger lots
Wollongong DCP 2009, Chapter D21 Tallawarra Lands (R1 and R3 zones)R1 and R3 zones land in the Tallawarra Lands (Figure 2), the former power station land on the western shore of Lake Illawarra between Koonawarra and Haywards Bay.4.5m0.9m3m on lots up to 300m², 0.9m on larger lots1.5m on lots up to 300m², 2m on larger lots
Wollongong DCP 2009, Chapter D13 Wollongong City Centre (General Residential zone)R1 General Residential land inside the Wollongong City Centre (Figure 1.1).4m6m6m4m

What are the complying development setbacks for a duplex?

If you build a duplex with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a duplex on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
1,000m² (20m wide, 50m deep)6.5m0.9m (1.5m at two storeys)5m (12m at two storeys)3m

What if my block is on a corner?

Wollongong DCP 2009, Chapter B1 Residential Development (R2 zone) sets a separate setback for a duplex from the second street, the side street of a corner block: 3m (Chapter B1, s 4.2.2(2)(c)). The complying development figure for the second street is in the CDC table above.

Does a two storey duplex need bigger setbacks?

Yes, under Wollongong DCP 2009, Chapter B1 Residential Development (R2 zone): the rear setback goes from 0.9m to 8m for upper storey: in the R2 zone development within the 8 m rear setback is limited to single storey. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Wollongong Council approve a duplex closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Wollongong?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Wollongong Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block