Skip to main content

How close to the boundary can a duplex be in Uralla?

Uralla Council's main plan, Uralla DCP 2011, Chapter 3 Residential Development (R1 and RU5), asks a single storey duplex for these setbacks: front the average of the neighbouring homes (6m where there are none), side 0.9m and rear 1.5m.

In Uralla the setbacks for a duplex come from Uralla Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the duplex first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Uralla Council's main plan set for a duplex?

The table gives Uralla DCP 2011, Chapter 3 Residential Development (R1 and RU5)'s one and two storey figures and the clause each comes from. The plan covers this land: Land zoned R1 General Residential (Uralla town, about 346 ha) and RU5 Village (Bundarra, about 98 ha).

Uralla DCP 2011, Chapter 3 Residential Development (R1 and RU5): setbacks for a duplex
SetbackOne storeyTwo storeysWhere in the plan
Frontthe average of the neighbouring homes (6m where there are none)the average of the neighbouring homes (6m where there are none)Ch 3, s 3.13 and Ch 3, s 3.6 Setbacks and Building Envelopes, Table 3.2 (Zone R1: General Residential, Zone RU5: Village)
Side0.9mno figure on lots up to 5.99m wide; 0.9m, plus 0.25m for every metre of wall above 5.5m on lots up to 10m wide; 0.9m, plus 0.25m for every metre of wall above 4.5m on lots up to 18m wide; 1.5m, plus 0.25m for every metre of wall above 4.5m on lots up to 24m wide; 2.5m on wider lots for walls equal to or greater than 3.5 m in heightCh 3, s 3.13 and Ch 3, s 3.6 Setbacks and Building Envelopes, Table 3.2 (Zone R1: General Residential, Zone RU5: Village); Codes SEPP cl 3.10(4) (adopted by the table)
Rear1.5m2.4m, plus 0.5m for every metre of wall above 3.5m for walls equal to or greater than 3.5 m in heightCh 3, s 3.13 and Ch 3, s 3.6 Setbacks and Building Envelopes, Table 3.2 (Zone R1: General Residential, Zone RU5: Village)
Corner block, second streetno figure on lots up to 199.99m²; 2m on lots up to 600m²; 3m on lots up to 1,500m²; 5m on larger lotsno figure on lots up to 199.99m²; 2m on lots up to 600m²; 3m on lots up to 1,500m²; 5m on larger lotsCh 3, s 3.13 and Ch 3, s 3.6 Setbacks and Building Envelopes, Table 3.2 (Zone R1: General Residential, Zone RU5: Village); Codes SEPP cl 3.10(11) (adopted by the table)

Which DCP applies to my block in Uralla?

It depends on where the lot is. Uralla DCP 2011, Chapter 3 Residential Development (R1 and RU5) is Uralla Council's main plan, and 8 other plans cover a duplex on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Uralla that cover a duplex
PlanWhere it appliesFrontSideRearSecond street
Uralla DCP 2011, Chapter 3 Residential Development (R2)Land zoned R2 Low Density Residential (four areas: west and south Uralla, the east Uralla land off Rock Abbey Road outside Barleyfields, and Bundarra; about 108 ha in all).the average of the neighbouring homes (8m where there are none)1.6m3.2m6m
Uralla DCP 2011, Chapter 17 BarleyfieldsR2 Low Density Residential land in Barleyfields, north-east Uralla, between Barleyfields Road, Warwick Street, Rock Abbey Road and Big Ridge Road, as edged in Figure 17.1 (Lot 842 DP 857745 and Lot 85 DP 746291 excluded).10m3m3m6m
Uralla DCP 2011, Chapter 4 Rural Development (RU1 and RU2)Land zoned RU1 Primary Production and RU2 Rural Landscape (most of the shire).50m50m50m50m
Uralla DCP 2011, Chapter 4 Rural Development (R5)Land zoned R5 Large Lot Residential (about 3,177 ha around Uralla and Kentucky).25m25m25m25m
Uralla DCP 2011, Chapter 4 Rural Development (C4, the DCP's E4)Land zoned C4 Environmental Living (the DCP's E4; about 544 ha).25m25m25m25m
Uralla DCP 2011, Chapter 4 Rural Development (C3, the DCP's E3)Land zoned C3 Environmental Management (the DCP's E3; about 142 ha).25m25m25m25m
Uralla DCP 2011, Chapter 5 Commercial and Industrial Areas (MU1, the DCP's B4)Land zoned MU1 Mixed Use (the DCP's B4) in the Uralla town centre, about 10 ha; lots facing Hill or Salisbury Street between Bridge and Maitland Streets take the next plan.6mnot set by the DCP: ask the councilnot set by the DCP: ask the council6m
Uralla DCP 2011, Chapter 5 (MU1 on Hill and Salisbury Streets between Bridge and Maitland Streets)MU1 Mixed Use lots facing Hill Street or Salisbury Street between Bridge Street and Maitland Street, Uralla (19 lots, 2.1 ha).0mnot set by the DCP: ask the councilnot set by the DCP: ask the council6m

What are the complying development setbacks for a duplex?

If you build a duplex with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a duplex on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
1,000m² (20m wide, 50m deep)6.5m0.9m (1.5m at two storeys)5m (12m at two storeys)3m

What if my block is on a corner?

Uralla DCP 2011, Chapter 3 Residential Development (R1 and RU5) sets a separate setback for a duplex from the second street, the side street of a corner block: no figure on lots up to 199.99m²; 2m on lots up to 600m²; 3m on lots up to 1,500m²; 5m on larger lots (Ch 3, s 3.13 and Ch 3, s 3.6 Setbacks and Building Envelopes, Table 3.2 (Zone R1: General Residential, Zone RU5: Village); Codes SEPP cl 3.10(11) (adopted by the table)). The complying development figure for the second street is in the CDC table above.

Does a two storey duplex need bigger setbacks?

Yes, under Uralla DCP 2011, Chapter 3 Residential Development (R1 and RU5): the side setback goes from 0.9m to no figure on lots up to 5.99m wide; 0.9m, plus 0.25m for every metre of wall above 5.5m on lots up to 10m wide; 0.9m, plus 0.25m for every metre of wall above 4.5m on lots up to 18m wide; 1.5m, plus 0.25m for every metre of wall above 4.5m on lots up to 24m wide; 2.5m on wider lots for walls equal to or greater than 3.5 m in height; the rear setback goes from 1.5m to 2.4m, plus 0.5m for every metre of wall above 3.5m for walls equal to or greater than 3.5 m in height. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Uralla Council approve a duplex closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Uralla?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Uralla Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block