How close to the boundary can a duplex be in Snowy Monaro Regional?
Snowy Monaro Regional Council's main plan, Cooma-Monaro Shire DCP 2014, Part 2.3 (R1, R2 and RU5), asks a single storey duplex for these setbacks: front 6m, side 0.9m and rear 3m.
In Snowy Monaro Regional the setbacks for a duplex come from Snowy Monaro Regional Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the duplex first.
NSW addresses only. Free, and no sign up.
What setbacks does Snowy Monaro Regional Council's main plan set for a duplex?
The table gives Cooma-Monaro Shire DCP 2014, Part 2.3 (R1, R2 and RU5)'s one and two storey figures and the clause each comes from. The plan covers this land: Land in zones R1, R2 and RU5 in the former Cooma-Monaro Shire (Cooma, Bredbo, Nimmitabel, Numeralla, Michelago and other villages).
| Setback | One storey | Two storeys | Where in the plan |
|---|---|---|---|
| Front | 6m | 6m | Part 2.3.3, Table 3 General setback requirements |
| Side | 0.9m | 0.9m | Part 2.3.3, Table 3 General setback requirements |
| Rear | 3m | 3m | Part 2.3.3, Table 3 General setback requirements |
| Corner block, second street | 4m | 4m | Part 2.3.3, Table 3 General setback requirements |
Which DCP applies to my block in Snowy Monaro Regional?
It depends on where the lot is. Cooma-Monaro Shire DCP 2014, Part 2.3 (R1, R2 and RU5) is Snowy Monaro Regional Council's main plan, and 20 other plans cover a duplex on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Cooma-Monaro Shire DCP 2014, Part 6.8 (Michelago village) | RU5 Village land in Michelago (the DCP clause names RU5 and R2; Michelago has no R2 land). | 8m | 3m | 3m | 4m |
| Cooma-Monaro Shire DCP 2014, Part 2.3 (MU1 Mixed Use) | Land in zone MU1 Mixed Use in the former Cooma-Monaro Shire. | 4m | 0.9m | 3m | 4m |
| Cooma-Monaro Shire DCP 2014, Part 6.2 Gateways (MU1 lots in Gateways 2 and 3) | MU1 Mixed Use lots inside the Polo Flat Gateway (Figure 12) and Saleyards Gateway (Figure 13), Cooma: Lot 2 DP 1092392, Lot 360 DP 750535 and Lot 21 DP 703560. | 10m | 0.9m | 3m | 4m |
| Cooma-Monaro Shire DCP 2014, Part 2.3 (R5, 1,800 m2 minimum lot) | R5 Large Lot Residential land the Cooma-Monaro LEP Lot Size Map gives a 1,800 m2 minimum lot. | 8m | 0.9m | 5m | 6m |
| Cooma-Monaro Shire DCP 2014, Part 2.3 (R5, minimum lot under 2 ha) | R5 Large Lot Residential land the Cooma-Monaro LEP Lot Size Map gives a 4,000 m2 or 9,000 m2 (or 500 m2) minimum lot. | 10m | 5m | 10m | 10m |
| Cooma-Monaro Shire DCP 2014, Part 2.3 (R5, minimum lot over 2 ha) | R5 Large Lot Residential land the Cooma-Monaro LEP Lot Size Map gives an 8 ha or 80 ha minimum lot. | 50m | 10m | 25m | 25m |
| Cooma-Monaro Shire DCP 2014, Part 2.3 (R5, minimum lot exactly 2 ha) | R5 Large Lot Residential land the Cooma-Monaro LEP Lot Size Map gives a minimum lot of exactly 2 ha, which Table 3 leaves out of both its "<2ha" and ">2ha" bands. | not set by the DCP: ask the council | not set by the DCP: ask the council | not set by the DCP: ask the council | not set |
| Cooma-Monaro Shire DCP 2014, Part 2.3 (RU1 and C4) | Land in zones RU1 Primary Production and C4 Environmental Living in the former Cooma-Monaro Shire. | 50m | 50m | 50m | 50m |
Show 12 more plans
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Snowy River DCP 2013, Part D1 Residential Accommodation | Housing land in the former Snowy River Shire outside the Jindabyne DCP 2024 land: Berridale, Adaminaby, Dalgety, Kalkite and the rural areas. | the average of the neighbouring homes (6m where there are none) | 0.9m | 0.9m | 0.9m on lots up to 6.99m wide, 1.5m on wider lots |
| Snowy River DCP 2013, Part F5 Ivy Cottage Estate (Berridale) | Lots 1 to 34 DP 701757 and Lots 1 and 3 DP 732682, O'Brien Avenue, Berridale. | 12m (from O'Brien Avenue) | 6m | 6m | 6m |
| Snowy River DCP 2013, Part F11 Three Rivers Lake Jindabyne | Three Rivers estate, Lake Jindabyne (formerly Lots 1000 and 1002 DP 1253446, now community plan DP 271424), about 6 km north of Jindabyne. | 6m | 3m | 3m | 6m |
| Jindabyne DCP 2024, Chapter B (B1.5.2 Building setbacks) | The Jindabyne DCP land (Figure A-1): Jindabyne, East Jindabyne, Tyrolean Village, Leesville, Lakewood, Cobbin, High Country and Highview estates and the surrounding rural land. | 6m | 0.9m | 0.9m | 0.9m on lots up to 6.99m wide, 1.5m on wider lots |
| Jindabyne DCP 2024, Chapter C2.2.2 Lower yield residential | Lower yield residential areas on the Jindabyne West, East Jindabyne and Jindabyne South Indicative Layout Plans. | 6m | 1.2m | 6m | 0.9m on lots up to 6.99m wide, 1.5m on wider lots |
| Jindabyne DCP 2024, Chapter C2.2.3 Higher yield residential | Higher yield residential areas on the Jindabyne West, East Jindabyne and Jindabyne South Indicative Layout Plans. | 3.5m | 2m | 8m | 2m |
| Jindabyne DCP 2024, Chapter C2.2.2 Large lot residential | Large lot residential areas on the Jindabyne West, East Jindabyne and Jindabyne South Indicative Layout Plans. | 6m | 3m | 8m | 0.9m on lots up to 6.99m wide, 1.5m on wider lots |
| Jindabyne DCP 2024, Chapter C2.2.2 Lower yield residential (Town Centre Growth) | Lower yield residential areas in the Jindabyne Town Centre Growth sub-precinct (Figure C-6). | 4.5m | 0.9m | 3m | 3m |
| Jindabyne DCP 2024, Chapter C2.2.3 Higher yield residential (Town Centre Growth) | Higher yield residential areas in the Jindabyne Town Centre Growth sub-precinct (Figure C-6). | 3.5m | 0.9m | 8m | 2m |
| Bombala DCP 2012, Part 4.2 (R1 and RU5) | Land in zones R1 and RU5 in the former Bombala Shire (Bombala, Delegate and the villages). | the average of the neighbouring homes | not set by the DCP: ask the council | not set by the DCP: ask the council | not set |
| Bombala DCP 2012, Part 4.3 (R5 Large Lot Residential) | Land in zone R5 in the former Bombala Shire. | 30m | 30m | 30m | 30m |
| Bombala DCP 2012, Part 4.5 (RU1 Primary Production) | Land in zone RU1 in the former Bombala Shire. | 100m | 100m | 100m | 100m |
What are the complying development setbacks for a duplex?
If you build a duplex with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.
| Example lot | Front | Side | Rear | Corner block, second street |
|---|---|---|---|---|
| 450m² (15m wide, 30m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 600m² (15m wide, 40m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 1,000m² (20m wide, 50m deep) | 6.5m | 0.9m (1.5m at two storeys) | 5m (12m at two storeys) | 3m |
What if my block is on a corner?
Cooma-Monaro Shire DCP 2014, Part 2.3 (R1, R2 and RU5) sets a separate setback for a duplex from the second street, the side street of a corner block: 4m (Part 2.3.3, Table 3 General setback requirements). The complying development figure for the second street is in the CDC table above.
Does a two storey duplex need bigger setbacks?
No. Cooma-Monaro Shire DCP 2014, Part 2.3 (R1, R2 and RU5) sets the same figures for a one or two storey duplex. Under complying development, the two storey figures are in the CDC table above.
What else do people ask?
Can Snowy Monaro Regional Council approve a duplex closer to the boundary?
It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.
Do these setbacks apply to a shed, pool or fence in Snowy Monaro Regional?
No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were the setbacks on this page checked?
We last read Snowy Monaro Regional Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.