How close to the boundary can a duplex be in Cowra?
Cowra Council's main plan, Cowra DCP 2026, Part E.1 Dwelling Controls and Part E.2 Medium Density Housing, asks a single storey duplex for these setbacks: front the average of the neighbouring homes (6m where there are none), side 0.9m and rear 3m.
In Cowra the setbacks for a duplex come from Cowra Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the duplex first.
NSW addresses only. Free, and no sign up.
What setbacks does Cowra Council's main plan set for a duplex?
The table gives Cowra DCP 2026, Part E.1 Dwelling Controls and Part E.2 Medium Density Housing's one and two storey figures and the clause each comes from. The plan covers this land: Land zoned R1 General Residential, RU5 Village and E1 Local Centre outside the character areas and Valley View Estate.
| Setback | One storey | Two storeys | Where in the plan |
|---|---|---|---|
| Front | the average of the neighbouring homes (6m where there are none) | the average of the neighbouring homes (6m where there are none) | Part E.2, E.2.11.1 a (Scenarios 1 to 4) |
| Side | 0.9m | 1.5m | Part E.2, E.2.12 a and b |
| Rear | 3m | 6m | Part E.2, E.2.13 a and b |
| Corner block, second street | 4.5m | 4.5m | Part E.2, E.2.11.3 a |
Which DCP applies to my block in Cowra?
It depends on where the lot is. Cowra DCP 2026, Part E.1 Dwelling Controls and Part E.2 Medium Density Housing is Cowra Council's main plan, and 13 other plans cover a duplex on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Cowra DCP 2026, Part E.1 Dwelling Controls (R2 Low Density Residential) | Land zoned R2 Low Density Residential (three small areas in west Cowra, 7.5 ha). | not set by the DCP: ask the council | not set by the DCP: ask the council | not set by the DCP: ask the council | not set |
| Cowra DCP 2026, Part E.3.1 Vaux St Character Area | The precinct shown in the E.3.1 Vaux St Character Area map (page 47). | the average of the neighbouring homes | 0.9m | 3m | 4.5m |
| Cowra DCP 2026, Part E.3.2 Keswick St Character Area | The precinct shown in the E.3.2 Keswick St Character Area map (page 51). | at least 13m, or the street's established building line where that is further back | 0.9m | 3m | 4.5m |
| Cowra DCP 2026, Part E.3.3 Liverpool St Character Area | The precinct shown in the E.3.3 Liverpool St Character Area map (page 55). | at least 5.5m, or the street's established building line where that is further back | 0.9m | 3m | 4.5m |
| Cowra DCP 2026, Part E.3.4 Darling St Character Area | The precinct shown in the E.3.4 Darling St Character Area map (page 59). | at least 5m, or the street's established building line where that is further back | 0.9m | 3m | 4.5m |
| Cowra DCP 2026, Part E.3.5 Bartlett Ave Character Area (north side) | The precinct shown in the E.3.5 Bartlett Ave Character Area (north side) map (page 63). | at least 5.5m, or the street's established building line where that is further back | 0.9m | 3m | 4.5m |
| Cowra DCP 2026, Part E.3.5 Bartlett Ave Character Area (south side) | The precinct shown in the E.3.5 Bartlett Ave Character Area (south side) map (page 63). | at least 6.5m, or the street's established building line where that is further back | 0.9m | 3m | 4.5m |
| Cowra DCP 2026, Part E.3.6 Railway St Character Area | The precinct shown in the E.3.6 Railway St Character Area map (page 67). | at least 3m, or the street's established building line where that is further back | 0.9m | 3m | 4.5m |
Show 5 more plans
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Cowra DCP 2026, Part E.3.7 Fitzroy St Character Area | The precinct shown in the E.3.7 Fitzroy St Character Area map (page 71). | at least 5m, or the street's established building line where that is further back | 0.9m | 3m | 4.5m |
| Cowra DCP 2026, Part E.3.8 Parkes St Character Area (Woodstock Commercial Precinct) | The precinct shown in the E.3.8 Parkes St Character Area (Woodstock Commercial Precinct) map (page 75). | 0m | 0.9m | 3m | 4.5m |
| Cowra DCP 2026, Part E.4 Valley View Estate | Valley View Estate, east Cowra (Tokyo Terrace, Seoul Street and the London Drive frontage, and the undeveloped land to the south), as shown in the E.4.1 map (page 81). | 8m | 2m | 5m | 4.5m |
| Cowra DCP 2026, Part F.1 Rural Dwellings (RU1 Primary Production) | Land zoned RU1 Primary Production. | not set by the DCP: ask the council | not set by the DCP: ask the council | not set by the DCP: ask the council | not set |
| Cowra DCP 2026, Part F.1 Rural Dwellings (RU4 Primary Production Small Lots) | Land zoned RU4 Primary Production Small Lots. | not set by the DCP: ask the council | not set by the DCP: ask the council | not set by the DCP: ask the council | not set |
What are the complying development setbacks for a duplex?
If you build a duplex with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.
| Example lot | Front | Side | Rear | Corner block, second street |
|---|---|---|---|---|
| 450m² (15m wide, 30m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 600m² (15m wide, 40m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 1,000m² (20m wide, 50m deep) | 6.5m | 0.9m (1.5m at two storeys) | 5m (12m at two storeys) | 3m |
What if my block is on a corner?
Cowra DCP 2026, Part E.1 Dwelling Controls and Part E.2 Medium Density Housing sets a separate setback for a duplex from the second street, the side street of a corner block: 4.5m (Part E.2, E.2.11.3 a). The complying development figure for the second street is in the CDC table above.
Does a two storey duplex need bigger setbacks?
Yes, under Cowra DCP 2026, Part E.1 Dwelling Controls and Part E.2 Medium Density Housing: the side setback goes from 0.9m to 1.5m; the rear setback goes from 3m to 6m. Under complying development, the two storey figures are in the CDC table above.
What else do people ask?
Can Cowra Council approve a duplex closer to the boundary?
It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.
Do these setbacks apply to a shed, pool or fence in Cowra?
No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were the setbacks on this page checked?
We last read Cowra Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.