How close to the boundary can a duplex be in Cessnock?
Cessnock Council's main plan, Cessnock DCP 2010, Chapter D.2 Urban Housing, asks a single storey duplex for these setbacks: front 6m; side 1m, plus 0.3m for every metre of wall above 3m; and rear 1m, plus 0.3m for every metre of wall above 3m.
In Cessnock the setbacks for a duplex come from Cessnock Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the duplex first.
NSW addresses only. Free, and no sign up.
What setbacks does Cessnock Council's main plan set for a duplex?
The table gives Cessnock DCP 2010, Chapter D.2 Urban Housing's one and two storey figures and the clause each comes from. The plan covers this land: R1 General Residential land outside the Huntlee Lot Type Map. D.2 applies "to all land where residential development is permissible" (s 2.1.1); every other zone where a dual occupancy is permitted (R2, R3, R5, RU2) is matched to the plans below, which carry D.2's dual occupancy figures.
| Setback | One storey | Two storeys | Where in the plan |
|---|---|---|---|
| Front | 6m | 6m | Cessnock DCP 2010, Part D, Chapter D.2 Urban Housing, s 2.3.4 Streetscape & Front Setbacks, Provisions 1 and Table 1: Street Setbacks in New Area; s 2.6.1 Table 2 Yield Table |
| Side | 1m, plus 0.3m for every metre of wall above 3m | 1m, plus 0.3m for every metre of wall above 3m | Cessnock DCP 2010, Part D, Chapter D.2 Urban Housing, s 2.4.4 Side and Rear Setbacks, Provisions 1 to 3 |
| Rear | 1m, plus 0.3m for every metre of wall above 3m | 1m, plus 0.3m for every metre of wall above 3m | Cessnock DCP 2010, Part D, Chapter D.2 Urban Housing, s 2.4.4 Side and Rear Setbacks, Provisions 1 to 3 |
| Corner block, second street | 3m | 3m | Cessnock DCP 2010, Part D, Chapter D.2 Urban Housing, s 2.6.1 Table 2 Yield Table, Dual Occupancy, Street Setbacks |
Which DCP applies to my block in Cessnock?
It depends on where the lot is. Cessnock DCP 2010, Chapter D.2 Urban Housing is Cessnock Council's main plan, and 10 other plans cover a duplex on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Cessnock Building Line Setback Policy B32.4 (a council policy, not a DCP), R2 and R3 | New dwelling houses on land zoned R2 or R3, outside Huntlee (E17 Lot Type Map), where DCP 2010 sets no house setbacks. | 6m | 1m, plus 0.3m for every metre of wall above 3m | 1m, plus 0.3m for every metre of wall above 3m | 3m |
| Cessnock Building Line Setback Policy B32.4 (a council policy, not a DCP), R5 Large Lot Residential | New dwelling houses on land zoned R5, less the Mulbring (North) land of DCP 2010 D1 Schedule 4, which sets its own 30 m road setback. | 6m | 1m, plus 0.3m for every metre of wall above 3m | 1m, plus 0.3m for every metre of wall above 3m | 3m |
| Cessnock Building Line Setback Policy B32.4 (a council policy, not a DCP), RU2 Rural Landscape | New dwelling houses on land zoned RU2 Rural Landscape. | 6m | 1m, plus 0.3m for every metre of wall above 3m | 1m, plus 0.3m for every metre of wall above 3m | 3m |
| Cessnock DCP 2010, Chapter E17 Huntlee, Cottage lots | Huntlee land shown on the Lot Type Map as Cottage (C): rear laneway lots. | 3.5m | 0.9m | 3m | 1m |
| Cessnock DCP 2010, Chapter E17 Huntlee, Small Traditional lots | Huntlee land shown on the Lot Type Map as Small Traditional (ST). | 4.5m | 1m | 3m | 1m |
| Cessnock DCP 2010, Chapter E17 Huntlee, Traditional and Large Traditional lots | Huntlee land shown on the Lot Type Map as Traditional (T) or Large Traditional (LT). | 4.5m | 1m | 4m | 1m |
| Cessnock DCP 2010, Chapter E17 Huntlee, Country lots | Huntlee land shown on the Lot Type Map as Country (CTY). | 6m | 1.5m | 6m | 3m |
| Cessnock DCP 2010, Chapter E17 Huntlee, Medium Density and Urban One lots (Table 9A) | Huntlee land shown on the Lot Type Map as Medium Density (MD) or Urban One (UO), in the town centre mixed use zone. | 1.5m | 0.9m | 1.5m | 1m |
Show 2 more plans
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Cessnock DCP 2010, Chapter E17 Huntlee, Multi Dwelling and Mixed Use land | Huntlee land shown on the Lot Type Map as Multi Dwelling (MD) or Mixed Use (MU). | not set by the DCP: ask the council | not set by the DCP: ask the council | not set by the DCP: ask the council | not set |
| Cessnock DCP 2010, Chapter D1 Subdivision Guidelines, Schedule 4 (R5 at Rothbury, North Rothbury, Mulbring North and Sawyers Gully) | R5 Large Lot Residential land at Sawyers Gully, Rothbury & North Rothbury and Mulbring (North), as shown in D1 Schedule 4 Figures 1 to 3. | 6m | 1m, plus 0.3m for every metre of wall above 3m | 1m, plus 0.3m for every metre of wall above 3m | 3m |
What are the complying development setbacks for a duplex?
If you build a duplex with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.
| Example lot | Front | Side | Rear | Corner block, second street |
|---|---|---|---|---|
| 450m² (15m wide, 30m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 600m² (15m wide, 40m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 1,000m² (20m wide, 50m deep) | 6.5m | 0.9m (1.5m at two storeys) | 5m (12m at two storeys) | 3m |
What if my block is on a corner?
Cessnock DCP 2010, Chapter D.2 Urban Housing sets a separate setback for a duplex from the second street, the side street of a corner block: 3m (Cessnock DCP 2010, Part D, Chapter D.2 Urban Housing, s 2.6.1 Table 2 Yield Table, Dual Occupancy, Street Setbacks). The complying development figure for the second street is in the CDC table above.
Does a two storey duplex need bigger setbacks?
Yes, through the wall height: under Cessnock DCP 2010, Chapter D.2 Urban Housing the side and rear setback grows as the wall gets taller. Under complying development, the two storey figures are in the CDC table above.
What else do people ask?
Can Cessnock Council approve a duplex closer to the boundary?
It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.
Do these setbacks apply to a shed, pool or fence in Cessnock?
No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were the setbacks on this page checked?
We last read Cessnock Council's plans on 11 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.