Skip to main content

How close to the boundary can a house be in Sydney?

Sydney Council's main plan, Sydney DCP 2012, Section 4.1 Single dwellings, terraces and dual occupancies, asks a single storey house for these setbacks: front at least not set, or the street's established building line where that is further back; and rear at least not set, or the street's established building line where that is further back. It does not set a side setback: ask the council.

In Sydney the setbacks for a house come from Sydney Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Sydney Council's main plan set for a house?

The table gives Sydney DCP 2012, Section 4.1 Single dwellings, terraces and dual occupancies's one and two storey figures and the clause each comes from. The plan covers this land: Land Sydney DCP 2012 applies to (Section 1.4, Figure 1.1: the City of Sydney less the excluded sites) in zones R1, R2, E1, MU1 and SP5 of Sydney LEP 2012, outside the Rosebery Estate and the Cooper Street locality.

Sydney DCP 2012, Section 4.1 Single dwellings, terraces and dual occupancies: setbacks for a house
SetbackOne storeyTwo storeysWhere in the plan
Frontat least not set, or the street's established building line where that is further backat least not set, or the street's established building line where that is further backSydney DCP 2012, Section 4.1.2 Building setbacks, provision (1)
Sidenot set by the DCP: ask the councilnot set by the DCP: ask the councilNone
Rearat least not set, or the street's established building line where that is further backat least not set, or the street's established building line where that is further backSydney DCP 2012, Section 4.1.2 Building setbacks, provision (4)

Which DCP applies to my block in Sydney?

It depends on where the lot is. Sydney DCP 2012, Section 4.1 Single dwellings, terraces and dual occupancies is Sydney Council's main plan, and 3 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Sydney that cover a house
PlanWhere it appliesFrontSideRearSecond street
Sydney DCP 2012, Section 5.6 Rosebery EstateThe Rosebery Estate as shown in Figure 5.1 Specific Areas (Sydney DCP 2012 Section 5.6), on land zoned R2, E1 or MU1.6m1m to one side, 3m for the first 14m from the front, then 1m to the other10mnot set
Sydney DCP 2012, Section 2.13.5 Cooper Street locality, with Section 4.1The Cooper Street locality, Redfern and Surry Hills ("bounded by the back of lots adjoining Cleveland Street to the north, Marriott Street to the east, Cooper Street to the south and Elizabeth Street to the west"), on land zoned R1 or MU1.at least not set, or the street's established building line where that is further backnot set by the DCP: ask the councilat least not set, or the street's established building line where that is further backnot set
South Sydney DCP 1997: Urban Design, Part F 1 Single dwelling houses, Part G 1 Rosebery, Part G 2 Rear lanes and Part E 2.4 SetbacksThe five strips of Rosebery along Gardeners Road still zoned 2(a) Residential (Low Density) under South Sydney LEP 1998 (104 lots, 5.7 ha), which Sydney DCP 2012 excludes (Figure 1.1, area 5 "Various Sites (Southern Sydney)").6m0.9mat least not set, or the street's established building line where that is further back4m

What are the complying development setbacks for a house?

If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a house on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
1,000m² (20m wide, 50m deep)6.5m1.5m (2.1m at two storeys)5m (12m at two storeys)3m

What if my block is on a corner?

Sydney DCP 2012, Section 4.1 Single dwellings, terraces and dual occupancies sets no separate setback for the second street of a corner block for a house, so ask the council how it treats one. The complying development figure for the second street is in the CDC table above.

Does a two storey house need bigger setbacks?

No. Sydney DCP 2012, Section 4.1 Single dwellings, terraces and dual occupancies sets the same figures for a one or two storey house. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Sydney Council approve a house closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Sydney?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Sydney Council's plans on 12 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block