Skip to main content

How close to the boundary can a house be in Campbelltown?

Campbelltown Council's main plan, Campbelltown (Sustainable City) DCP 2015, Volume 1, Part 3, asks a single storey house for these setbacks: front 5.5m, side 0.9m and rear 3m.

In Campbelltown the setbacks for a house come from Campbelltown Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.

Check your address

NSW addresses only. Free, and no sign up.

What setbacks does Campbelltown Council's main plan set for a house?

The table gives Campbelltown (Sustainable City) DCP 2015, Volume 1, Part 3's one and two storey figures and the clause each comes from. The plan covers this land: Land zoned R2 Low Density or R3 Medium Density Residential under CLEP 2015 that no site specific DCP covers (Vol 1 Part 1 s 1.1.3).

Campbelltown (Sustainable City) DCP 2015, Volume 1, Part 3: setbacks for a house
SetbackOne storeyTwo storeysWhere in the plan
Front5.5m5.5mSCDCP 2015 Vol 1, Part 3, s 3.6.1.3 a) i)
Side0.9m0.9mSCDCP 2015 Vol 1, Part 3, s 3.6.1.3 a) v)
Rear3m8m for any part of the building higher than 4.5 metresSCDCP 2015 Vol 1, Part 3, s 3.6.1.3 a) vi) and vii)
Corner block, second street2m2mSCDCP 2015 Vol 1, Part 3, s 3.6.1.3 a) iii)

Which DCP applies to my block in Campbelltown?

It depends on where the lot is. Campbelltown (Sustainable City) DCP 2015, Volume 1, Part 3 is Campbelltown Council's main plan, and 22 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.

Other plans in Campbelltown that cover a house
PlanWhere it appliesFrontSideRearSecond street
Campbelltown (Sustainable City) DCP 2015, Volume 2 Part 8B Glenlee Estate (C4 dwelling lots)Part 8B s 1.1: "This DCP applies to land identified in the Land Application Map at Figure 1.1, known as the Glenlee Estate (the Estate).7.5m2m6m3m
Campbelltown (Sustainable City) DCP 2015, Volume 2 Part 8A Menangle Park (R2 Low Density Residential)Part 8A s 1.1: "The DCP applies to land in the Menangle Park Precinct shown on the Land Application Map in Figure 1.1." Figure 1.1 notes the Glenlee Precinct is not included, and Part 8B excludes the Glenlee Estate.4.5m0.9m on lots up to 600m², 1.5m on larger lots4m on lots up to 420m², 4m on lots up to 600m², 6m on larger lots3m
Campbelltown (Sustainable City) DCP 2015, Volume 2 Part 8A Menangle Park (R3 Medium Density Residential)Part 8A s 1.1: "The DCP applies to land in the Menangle Park Precinct shown on the Land Application Map in Figure 1.1." Figure 1.1 notes the Glenlee Precinct is not included, and Part 8B excludes the Glenlee Estate.3m0.9m4m3m
Campbelltown (Sustainable City) DCP 2015, Volume 2 Part 8A Menangle Park (R5 Large Lot Residential)Part 8A s 1.1: "The DCP applies to land in the Menangle Park Precinct shown on the Land Application Map in Figure 1.1." Figure 1.1 notes the Glenlee Precinct is not included, and Part 8B excludes the Glenlee Estate.5m1.5m on lots up to 1,000m²; 3m on larger lots8m on lots up to 1,000m²; 10m on larger lots3m on lots up to 1,000m²; 5m on larger lots
Campbelltown (Sustainable City) DCP 2015, Volume 2 Part 7 Figtree Hill (Mount Gilead)Part 7 s 1.1: "This Part applies to the land identified in Figure 1." Figure 1 is the Figtree Hill (Mount Gilead stage 1) estate off Appin Road, the Mount Gilead Urban Release Area under Campbelltown LEP 2015 cl 6.1.4.5m0.9m to one side, 0.9m to the other4m3m
Campbelltown (Sustainable City) DCP 2015, Volume 2 Part 13 MaryfieldsPart 13 s 13.1: "This Development Control Plan (DCP) applies to `Maryfields Estate' being the land identified in Figure 13.1.5.5m0.9m3m2m
Campbelltown (Sustainable City) DCP 2015, Volume 2, Part 9 (Urban Renewal Areas: Airds Bradbury and Claymore)The NSW Land and Housing Corporation urban renewal areas of Airds Bradbury and Claymore shown in Part 9 Appendix 1, excluding lots shown as privately owned.3m on lots up to 300m², 4m on larger lots0.9m3m on lots up to 450m², 4m on larger lots1m on lots up to 300m², 2m on larger lots
Campbelltown (Sustainable City) DCP 2015, Volume 2, Part 1 (Minto Renewal DCP)The Minto Renewal Area.4m0.9m4m2m
Show 14 more plans
Other plans in Campbelltown that cover a house, continued
PlanWhere it appliesFrontSideRearSecond street
Campbelltown (Sustainable City) DCP 2015, Volume 2, Part 10 (Blairmount and Badgally Road)The Blairmount and Badgally Road release land.4m0.9m4m2m
Campbelltown (Sustainable City) DCP 2015, Volume 2, Part 11 (Caledonia Precinct)The Caledonia Precinct at Ingleburn (about 170 lots between Bensley Road and Oxford Road) shown in Figure 11.1.5.5m0.9m3m2m
Campbelltown (Sustainable City) DCP 2015, Volume 2, Part 19 (Macarthur Grange)The former Macarthur Grange Golf Course at Varroville.15m on lots up to 10,000m²; 35m on larger lots10m10m10m
Campbelltown Growth Centre Precincts DCP (East Leppington), Part 4 residentialEast Leppington Precinct land in Campbelltown (62% of the precinct; the rest is in Camden and Liverpool).4.5m0.9m to one side, 0.9m on lots up to 8.99m wide, 0.9m on lots up to 15m wide, 0.9m on wider lots to the other4m1m on lots up to 8.99m wide, 2m on wider lots
Campbelltown Growth Centre Precincts DCP (East Leppington), Environmental Living zoneEast Leppington Precinct land in Campbelltown (62% of the precinct; the rest is in Camden and Liverpool).4.5m1.5m to one side, 1.5m to the other10m4.5m
Edmondson Park South DCP 2012, Section 6 (Residential)The Campbelltown part of Edmondson Park South (the former Ingleburn Army Camp land at Bardia; 37% of the site, 1.45 km2).the average of the neighbouring homes (4.5m where there are none)0.9m4m2m
Edmondson Park South DCP 2012, Section 7 (Environmental Living)The Campbelltown part of Edmondson Park South (the former Ingleburn Army Camp land at Bardia; 37% of the site, 1.45 km2).12m6m12m12m
Campbelltown (Sustainable City) DCP 2015, Volume 2, Part 5 (University of Western Sydney Campbelltown DCP)The Western Sydney University Campbelltown campus and Landcom lands (the Macarthur Heights estate) shown in Part 5 Figure 1.4m on lots up to 2,000m²; 10m on larger lots1m on lots up to 2,000m²; 3m on larger lots4m on lots up to 2,000m²; 5m on larger lots2m on lots up to 500m², 4m for along both street frontages for length of frontages beyond 9m (2m for the first 9m) on larger lots
Campbelltown (Sustainable City) DCP 2015, Volume 2, Part 6 (Edmondson Park Smart Growth DCP, Locality CB)Part 6 s 1.4: "This Plan applies to that land within the Campbelltown Local Government Area (LGA) generally bound by Campbelltown Road, the South Western Freeway (Hume Highway) and the Ingleburn Army Camp, as identified on Map 1."4.5m1m1m2m
Campbelltown (Sustainable City) DCP 2015, Volume 2, Part 2 (Glenfield Road Area DCP 2002)Part 2 s 1.4: "This Plan applies to that land within the Campbelltown Local Government Area (LGA) generally bound by Campbelltown Road, Old Glenfield Road, Glenfield Road, the Main South Railway Line, as identified on Map 1."4.5m1m1m1.5m
Campbelltown (Sustainable City) DCP 2015, Volume 1, Part 3 (Zone R5 Large Lot Residential)Land zoned R5 Large Lot Residential under CLEP 2015 that no site-specific DCP covers.not set by the DCP: ask the councilnot set by the DCP: ask the councilnot set by the DCP: ask the councilnot set
Campbelltown (Sustainable City) DCP 2015, Volume 1, Part 4 (rural residential)Rural residential land zoned RU2, E3 or E4 (now C3 and C4) under CLEP 2015 (Part 4 s 4.1, s 4.5).15m on lots up to 10,000m²; 35m on larger lots10m10m10m
Campbelltown (Sustainable City) DCP 2015, Volume 1, Part 4 (rural residential, RU5 Village)Land zoned RU5 Village under CLEP 2015.15m on lots up to 10,000m²; 35m on larger lots10m10m10m
Campbelltown (Sustainable City) DCP 2015, Volume 3 (Deferred Areas DCP), Part 3 non-urban landLand marked 'Deferred Matter' under CLEP 2015 (Vol 3, Part 1, s 1.2: 'The DADCP applies to the areas that have been marked as a `Deferred Matter" under Campbelltown Local Environmental Plan 2015.').15m on lots up to 10,000m²; 35m on larger lots10m10m10m

What are the complying development setbacks for a house?

If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.

Complying development (CDC) setbacks for a house on three example lots
Example lotFrontSideRearCorner block, second street
450m² (15m wide, 30m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
600m² (15m wide, 40m deep)4.5m0.9m (1.5m at two storeys)3m (8m at two storeys)2m
1,000m² (20m wide, 50m deep)6.5m1.5m (2.1m at two storeys)5m (12m at two storeys)3m

What if my block is on a corner?

Campbelltown (Sustainable City) DCP 2015, Volume 1, Part 3 sets a separate setback for a house from the second street, the side street of a corner block: 2m (SCDCP 2015 Vol 1, Part 3, s 3.6.1.3 a) iii)). The complying development figure for the second street is in the CDC table above.

Does a two storey house need bigger setbacks?

Yes, under Campbelltown (Sustainable City) DCP 2015, Volume 1, Part 3: the rear setback goes from 3m to 8m for any part of the building higher than 4.5 metres. Under complying development, the two storey figures are in the CDC table above.

What else do people ask?

Can Campbelltown Council approve a house closer to the boundary?

It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.

Do these setbacks apply to a shed, pool or fence in Campbelltown?

No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.

When were the setbacks on this page checked?

We last read Campbelltown Council's plans on 11 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.

Where does this information come from?

These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.

What else can I check?

Check what applies to your block