How close to the boundary can a house be in Blacktown?
Blacktown Council's main plan, Blacktown DCP 2015, Part C, asks a single storey house for these setbacks: front 6m, side 0.9m and rear 0.9m.
In Blacktown the setbacks for a house come from Blacktown Council's development control plan (DCP), the council's own rules for the design of homes in its area, unless you build as complying development, which follows state rules instead. This page is a first look: enter your address and the Site Checker opens at the setbacks for your lot, with the house first.
NSW addresses only. Free, and no sign up.
What setbacks does Blacktown Council's main plan set for a house?
The table gives Blacktown DCP 2015, Part C's one and two storey figures and the clause each comes from. The plan covers this land: All land zoned residential (R1, R2, R3, R4) under Blacktown LEP 2015, which is the established suburbs of Blacktown City, except land covered by a more specific plan below: Stanhope Gardens (Part C Figure 3.1), Part K Greystanes Creek, Part L Stonecutters Ridge, Part M The Ponds, Part N Ashlar and the Bungarribee Doonside DDC. Not the North West Growth Area precincts, which are covered by the Growth Centre Precincts DCP.
| Setback | One storey | Two storeys | Where in the plan |
|---|---|---|---|
| Front | 6m | 6m | Blacktown DCP 2015, Part C (effective 1 February 2026), s 3.2.3 Building line |
| Side | 0.9m | 1.2m for 2 storey walls | Blacktown DCP 2015, Part C (effective 1 February 2026), s 3.2.4 Side and rear boundary wall setbacks (maximum 2 storeys), (a), (c) and (d) |
| Rear | 0.9m | 3m for the upper storey walls | Blacktown DCP 2015, Part C (effective 1 February 2026), s 3.2.4 (a) and (c); Table 3.11 checklist |
| Corner block, second street | 3m | 3m | Blacktown DCP 2015, Part C (effective 1 February 2026), s 3.4.1 Setbacks (corner lots) |
Which DCP applies to my block in Blacktown?
It depends on where the lot is. Blacktown DCP 2015, Part C is Blacktown Council's main plan, and 13 other plans cover a house on particular land, such as a precinct, an estate, rural land or a former council area. Many councils have several plans, set by zone, estate, precinct or former council area, so enter your address and the Site Checker picks the plan that covers your lot. The table lists each plan with its one storey figures.
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| Blacktown DCP 2015, Part C, Stanhope Gardens masterplanned estate | The Stanhope Gardens masterplanned estate shown in Part C Figure 3.1, where Part C sets its own front, side and corner setbacks (exceptions in ss 3.2.3, 3.2.4, 3.4.1, 3.8, 4.3.5 and 4.3.6). | 4.5m | 1.2m | 0.9m | 2m |
| Blacktown DCP 2015, Part K, Greystanes Creek | Land adjacent to Greystanes Creek Reserve outlined in Part K Figure 2.1 (s 2.1: "new development (residential or otherwise) on land situated in the City of Blacktown outlined in heavy black as shown on the map in Figure 2.1"). | 6m | 0.9m | 10m | 3m |
| Blacktown DCP 2015, Part L Stonecutters Ridge | "all land within Stonecutters Ridge (the site) as shown at Figure 1.1" (s 1.2), the golf course estate at Colebee. | 4m on lots up to 449.99m², 4.5m on lots up to 600m², 6m on larger lots | 0.9m | 4m | 3m |
| Blacktown DCP 2015, Part M The Ponds | "the land shown hatched on Figure 1.2" (s 1.2), The Ponds, about 330 ha either side of Second Ponds Creek. | 4.5m | 0.9m | 0.9m | 4m |
| Blacktown DCP 2015, Part N Ashlar Precinct | The former Ashlar Golf Course, 38.38 ha, "the land shown hatched on Figure 1" (s 1.2). | 3.5m | 1m | 4m | 3m |
| Bungarribee Precinct (Doonside) Development Design Code | "the parcel of land at Bungarribee bounded by Bungarribee Creek in the south, Eastern Creek to the west, Eastern Road to the north and Doonside Road to the east as shown on Figure 1" (s 1.4), the Doonside residential parcel of the Western Sydney Parklands Bungarribee precinct. | 4.5m | 0.9m | 3m on lots up to 29.99m deep, 3m on deeper lots | 3m for the first 9m from the front building line, then 4m |
| Blacktown City Council Growth Centre Precincts DCP 2010 | North West Growth Area precincts in Blacktown where precinct planning is complete: Alex Avenue, Riverstone, Area 20, Schofields, Marsden Park, West Schofields (Townson Road part only) and Riverstone East Stages 1 and 2, less the Cudgegong Station Area and other land excluded by s 1.1 / Figure 1-1. | 4.5m | 0.9m to one side, 0.9m on lots up to 15m wide, 0.9m on wider lots to the other | 4m | 1m on lots up to 8.99m wide, 2m on wider lots |
| Blacktown City Council Growth Centre Precincts DCP 2010, Environmental Living zone (Table 4-6) | Land in the Environmental Living zone (C4, formerly E4) of SEPP (Precincts: Central River City) 2021 inside the Blacktown Growth Centre precincts the DCP covers. | 4.5m | 1.5m to one side, 1.5m to the other | 10m | 4.5m |
Show 5 more plans
| Plan | Where it applies | Front | Side | Rear | Second street |
|---|---|---|---|---|---|
| BCC Growth Centre Precincts DCP 2010, Schedule 1 Alex Avenue (Landcom Demonstration Precinct, Burdekin Road) | Former Lot 1 DP 1243995, Burdekin Road, Schofields (Schedule 1 Figure 4-1): "This Part applies to all development on the land shown in Figure 4-1." Main body controls apply except on battle-axe lots and lots with side loaded garages. | 4.5m | 0.9m to one side, 0.9m on lots up to 15m wide, 0.9m on wider lots to the other | 4m | 1m on lots up to 8.99m wide, 2m on wider lots |
| BCC Growth Centre Precincts DCP 2010, Schedule 4 Area 20 (Windsor Road interface) | Lots in the Area 20 precinct backing onto Windsor Road (the Windsor Road interface land shown in Schedule 4 Figure 3-4), where the rear setback is 12 m. | 4.5m | 0.9m to one side, 0.9m on lots up to 15m wide, 0.9m on wider lots to the other | 12m | 1m on lots up to 8.99m wide, 2m on wider lots |
| BCC Growth Centre Precincts DCP 2010, Schedule 6 Marsden Park (Richmond Road and South Street) | Lots in the Marsden Park precinct along Richmond Road and South Street (Schedule 6 Figure 6-7) that do not front a parallel road; dwellings sit at least 20 m from those roads. | 4.5m | 0.9m to one side, 0.9m on lots up to 15m wide, 0.9m on wider lots to the other | 20m | 1m on lots up to 8.99m wide, 2m on wider lots |
| BCC Growth Centre Precincts DCP 2010, Schedule 7 West Schofields Townson Road (R2/E2 lots) | Lots in the Townson Road precinct zoned partly R2 Low Density Residential and partly E2 (now C2) Environmental Conservation, where habitable structures sit 15 m back from the zone boundary. | 4.5m | 0.9m to one side, 0.9m on lots up to 15m wide, 0.9m on wider lots to the other | 15m (any habitable structure, measured from the zone boundary between the R2 Residential and E2 (now C2) Environmental Conservation zone, not from the lot boundary) | 1m on lots up to 8.99m wide, 2m on wider lots |
| BCC Growth Centre Precincts DCP 2010, Schedule 9 Riverstone East Stage 3 | The Riverstone East Stage 3 precinct; Schedule 9 Tables 2 to 9 replace the main body Tables 4-2 to 4-5 there. | 4.5m | 0.9m to one side, 0.9m on lots up to 14.99m wide, 1.5m on wider lots to the other | 4.5m | 1m on lots up to 8.99m wide, 2m on wider lots |
What are the complying development setbacks for a house?
If you build a house with a complying development certificate (CDC), the fast approval a private certifier can issue when a design meets the state's fixed standards, the setbacks come from the state codes, not from the council's DCP, and they depend on the lot's area and width. The table shows the complying development (CDC) figures the Site Checker uses for three example lots: 450m² (15m wide, 30m deep), 600m² (15m wide, 40m deep) and 1,000m² (20m wide, 50m deep). Your own lot's figures are in its report, and Can I use complying development on my block? explains which lots qualify.
| Example lot | Front | Side | Rear | Corner block, second street |
|---|---|---|---|---|
| 450m² (15m wide, 30m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 600m² (15m wide, 40m deep) | 4.5m | 0.9m (1.5m at two storeys) | 3m (8m at two storeys) | 2m |
| 1,000m² (20m wide, 50m deep) | 6.5m | 1.5m (2.1m at two storeys) | 5m (12m at two storeys) | 3m |
What if my block is on a corner?
Blacktown DCP 2015, Part C sets a separate setback for a house from the second street, the side street of a corner block: 3m (Blacktown DCP 2015, Part C (effective 1 February 2026), s 3.4.1 Setbacks (corner lots)). The complying development figure for the second street is in the CDC table above.
Does a two storey house need bigger setbacks?
Yes, under Blacktown DCP 2015, Part C: the side setback goes from 0.9m to 1.2m for 2 storey walls; the rear setback goes from 0.9m to 3m for the upper storey walls. Under complying development, the two storey figures are in the CDC table above.
What else do people ask?
Can Blacktown Council approve a house closer to the boundary?
It can. A development application (DA) is assessed on its merits, so the council can accept less than its plan asks for where a design justifies it, or ask for more. A complying development certificate has no such room: the design meets the code's setbacks or it is not complying development.
Do these setbacks apply to a shed, pool or fence in Blacktown?
No. Sheds, pergolas, carports, pools, decks and fences follow different rules (exempt development, which needs no approval when it meets them), and these pages do not cover them.
When were the setbacks on this page checked?
We last read Blacktown Council's plans on 11 November 2026. Each figure names the clause it came from, and each plan links to the council's own document, so you can check it against the current version.
Where does this information come from?
These pages are a first look at the setbacks in each council's published development control plan and in the complying development codes, read from the documents linked on each page. They are not a section 10.7 planning certificate or a design check, and a council plan can change after we read it. Confirm anything you rely on with the council or a certifier before you buy, design or build. Nothing on this page replaces advice from your certifier, engineer, lawyer or your own designer.